過液量調節器 的英文怎麼說

中文拼音 [guòyèliángdiàojiéqì]
過液量調節器 英文
liquid feed regulator
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 液 : 名詞（液體） liquid; fluid; juice
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 節 : 節構詞成分。
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 調節器 : regulator; adjuster; governor; controller; conditioner; actuator; phaser
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  1. The control system of mould level is crucial to improve the slab quality in the continuous casting process, pid controller is used in the traditional mould level control, and it has some defaults, such as : at the start - up or finishing period of casting or during the changeover of tundish, pid control has a bad effect, its overshoot is large and its transient time is long ; the erosion of the tundish stopper and the submersed nozzles lead to the accuracy of control become bad ; the abrupt falloff of block in the submersed nozzles makes the level acutely fluctuate, and pid control can not overcome the disturbances resulted from the change of casting speed

    結晶器液位控制系統是提高連鑄產品質量的關鍵環節，傳統的連鑄機液位控制方法採用常規的pid控制，存在如下不足：開始、結束澆注和換中間罐澆注時，控制效果差，超調量大，過渡時間長；塞棒頭和浸入式水口被腐蝕后引起控制精度差；浸入式水口堵塞物的突然脫落所引起的液位劇烈波動；無法克服拉速波動引起的擾動。
  2. Keep the wiper adjusted or changed when excess coolant on the strip becomes the concern. there is a style new wiper available and on hold

    鋁帶表面存在過量冷卻液成為令人擔憂的問題時，則隨時調節或更換除油器。可獲得並備有新型除油器。
  3. There is difference frequency measurement requirement for every part of pid regulating, difference between dynamic quality and static quality in response time and accuracy. according to these, it use the interrupt functions and high - speed counter of the simens s7 - 200 plc cpu226 basic unit and some peripheral circuit to measure frequency ; in software designed, the procedure frame of hydraulic - turbine governor and disperse process of parallel pid are analyzed, an improved pid algorithm is adopted to realize a pid regulation mode with variable structure and parameters ; the mechanical liquid - pressure system of the hydraulic - turbine governor is with electric - hydraulic converter unit of step motor. according to the drive character of five phase of response step motor, a variable frequency regulated voltage driver unit is designed in order to realize interface between plc and driver of step motor

    本文利用s7 - 200plc自身的特點設計了頻率測量單元，根據pid調節各個環節的特點，以及調速器動態特性、靜態特性對頻率測量的實時性和精度要求的不同，利用s7 - 200plc基本單元中內置的高速計數器以及相應的外圍放大整形、分頻電路，實現了水輪發電機組頻率的測量；在軟體上，對微機調速器的整個程序框架、並聯pid的離散化過程進行了分析，選用改進的pid演算法實現了變參數、變結構的pid調節模式；調速器的機械液壓隨動系統具有步進電機電液轉換元件，採用五相反應式步進電機，根據其驅動特性設計了變頻調壓驅動器，實現plc與步進電機驅動器之間數字介面。
  4. As a sensor of temperature measurement and adjustment, in dustrial ceramic thermal resistance are used to measure surface temperature in the range of - 200 to 600 of liquid, gas and solid in manufacture processes having various advantages of high accuracy, stable performance, convenience in maintain

    工業用裝配式熱電阻作為溫度測量和調節的傳感器，通常用來和顯示儀表配套，以直接測量生產過程中- 200600范圍內的液體氣體以及固體表面的溫度，具有精度高性
  5. To improve the performance of ashp, an improved ashp system is presented. different from the original system, the new one can control the refrigerant flow rate by the sub - cooling of condenser and adjust the sup - heating of the compressor inlet vapor by the heater in accumulator. the simulation shows the new system not only has better dynamic characteristic of frost and defrost of ashp, but also has higher coefficient of performance

    為改善空氣源熱泵機組的結霜除霜動態性能，提出了一種利用冷凝器過冷度來調節製冷劑流量，在氣液分離器里增加電熱裝置保持壓縮機進口過熱度的改進型系統，結果表明這種改進型系統不但可以改善系統的運行性能，同時能改善系統運行的經濟性，為機組的技術升級和產品更新提供了一個新的途徑。
  6. As transducer for measuring and adjusting temperature, industrial thermal resistance usually used compound with display instrument, to directly measure temperture in producing process formedium of liquid steam gas or solid surface at 0 1800. industrial thermal resistance including platinum thermal resistance and copper thermal resistance

    工業用熱電阻作為溫度測量和調節的傳感器，通常用來與顯示儀表等配套，以直接測量各種生產過程中自- 200至500范圍內液體蒸汽和氣體介質以及固體表面等的溫度。
  7. The product range includes process instrument, pneumatic hydraulic units, working lights system, kinds of sensor, switch, transmitter, valve, and so on. especially on combustion safety control, moment limiting control and electro - hydraulic control system, we have special technique service experience. we can serve the whole set service, including design, system integration, installation calibration and technique training

    公司技術力量雄厚，擁有眾多技術全面專業性強且經驗豐富的技術工程人員，不斷引進吸收國內外先進技術及優秀產品，產品有過程調節儀表氣動液壓元件專用照明燈系列各類傳感器控制開關變送器閥門等，尤其在車輛燃燒安全控制系統力矩限制控制系統電液控制系統鍋爐燃燒安全控制系統等方面有獨到的技術服務經驗，實行從設計系統集成設備安裝調試技術培訓一條服務，深受廣大客戶好評。
分享友人
分享到 Line

分享到臉書