邊端距離 的英文怎麼說

中文拼音 [biānduānjùlí]
邊端距離 英文
edge distance
  • 邊 : 邊Ⅰ名詞1 （幾何圖形上夾成角的直線或圍成多邊形的線段） side; section 2 （邊緣） edge; margin; oute...
  • 端 : Ⅰ名詞1 （東西的頭） end; extremity 2 （事情的開頭） beginning 3 （門類; 方面） item; point 4 （原...
  • 距 : Ⅰ名詞1 （距離） distance 2 （雄雞、雉等的腿的後面突出像腳趾的部分） spur （of a cock etc ）Ⅱ動詞...
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 距離 : 1 （相隔的長度） distance; range; gap; space; spacing; separation 2 （相距） be apart from; be aw...
  1. Following are detailed steps of this system : in the segmentation section, we use three successive frames to detect the motion infomation of the pictures, by using blockmatching algorithm in two successive frames twice, we can get two pictures composed of motion blocks of the moving object, then we find out the common motion blocks of the two pictures, experiments prove these blocks approximately compose the moving object. after getting the motion blocks, we calculate the center of these blocks as the center of the moving object, thus we can use the center point as the origin, construct n straight linesjoining the boundry of the image and the center. on each line, we can find out a proper point near the object contour according to some criteria, then we use these n points as the initial points of the snake and let the snake converge on the object contour, thus finish the segmentation of the moving object

    本方案的實現過程為：分割部分：對運動目標的前後三幀進行兩次塊匹配運動檢測，通過找出兩個匹配結果中運動圖像塊的公共部分，獲得組成運動目標的圖像塊；求出運動目標圖像塊的形心作為運動目標的中心，以此中心為端點，向四周發散出角度間隔為的n條射線，射線的另一端終止於圖像的邊緣；在每條射線上按照一定的準則（點的梯度和與目標中心的距離在一定閾值范圍內）找出n個初始輪廓點；以這些初始輪廓點作為主動輪廓模型（ snake ）的初始點，用改進的貪婪演算法使snake收斂到待分割的運動目標輪廓上。
  2. For every point on contour curves, the support area and support radius were first calculated based on actual distance of adjacent pixels, end points were obtained with linear interpolation technique ; next, the distance between point and its centroid of support area was used as feature strength to determine feature points candidate ; finally, those points with local maximum feature strength were selected as vertices of polygonal

    摘要首先基於相鄰像素間的歐氏距離計算出輪廓曲線上每一點的支持區域及支持半徑，用線性插值得到支持區域的端點；然後求得支持區域的質心，以曲線上的點和其相應的支持區域質心之間的距離作為特徵響應篩選出候選特徵點；最後將具有局部極大特徵強度的點作為多邊形的頂點。
分享友人
分享到 Line

分享到臉書