重新退火 的英文怎麼說
中文拼音 [zhòngxīntuìhuǒ]
重新退火
英文
reannealing- 重 : 重Ⅰ名詞(重量; 分量) weight Ⅱ動詞(重視) lay [place put] stress on; place value upon; attach im...
- 新 : Ⅰ形容詞1 (剛出現的或剛經驗到的) new; fresh; novel; up to date 2 (沒有用過的) unused; new 3 (...
- 退 : 動詞1 (向後移動) retreat; draw back; move back 2 (使向後移動) cause to move back; remove; wit...
- 火 : fire
- 重新 : again; anew; afresh
- 退火 : [冶金學] anneal; annealing; back-out
-
Shenyang alloy material co., ltd. ’ s transferring item is one of the important transforming items for us, which has approved by national financial department by means of using japan ' s loan, the importance of item includes the advanced half continual vacuum melting furnace 、 simultaneous x - ray spectrometer system 、 fluorescent analyzed instruments ; advanced annealed furnace 、 vacuum annealed furnace and other heat treated furnish etc , and others totally 50 types
沈陽合金材料有限公司的搬遷改造項目是國家發改委和財政部批準的國家利用日元貸款改造重點項目之一,項目重點改造內容有引進國外最先進的半連續真空感應熔煉爐、 x熒光分析儀、直讀光譜儀;國內先進的罩式退火爐、真空退火爐等熱處理設備及一些冷加工設備,共增添新設備五十多臺套。Though mcw metrobus in kcrc bus division is not a new thing when they arrived, all of them were playing a significant role in the fleet, no only at early stage but also the day full of air - conditioned buses in the fleet
九廣鐵路巴士部的都城嘉慕都城型縱然在出現時不算是甚麼新鮮事物,但在車隊中卻起了一個相當重要的角色,即使在車隊中已經充斥各式各樣的空調巴士的年代,都城型依然能夠繼續肩負每天接載乘客的使命,直到退下火線的一刻。Though mcw metrobus in kcrc bus division is not a new thing when they arrived, all of them were playing a significant role in the fleet, not only at the early stage but also the day full of air - conditioned buses in the fleet
九廣鐵路巴士部的都城嘉慕都城型縱然在出現時不算是甚麼新鮮事物,但在車隊中卻起了一個相當重要的角色,即使在車隊中已經充斥各式各樣的空調巴士的年代,都城型依然能夠繼續肩負每天接載乘客的使命,直到退下火線的一刻。First, the solid ice on the surface could have been annealed, meaning that its temperature could have been raised above the 78 kelvin mark to allow the amorphous ice to recrystallize
首先,表面的固體冰曾經退火過,也就是說其溫度曾升高至78k以上使無定型冰重新結晶。The annealing also changes the grain morphology. the p grains from the amorphous layer are finer than in the other cases. silicide grains grow towards the substrate at high annealing temperature and finally shrink into isolated islands, thus deteriorating the silicide / si interface smoothness
由於非晶的形成,使得退火后晶粒要經重新形核和長大的過程,所以在同樣的退火條件下,與未形成非晶的樣品比,硅化物顆粒要小。( 4 ) anneal of sic - c / sic with si implantation in vacuum at 1600 for 30min had resulted in production of new cracks, which led to larger weight loss of the composite
( 4 )注入si試樣真空1600退火30min后, sic塗層表面出現許多新裂紋, 1300模擬空氣中的氧化失重增大。分享友人