金屬層板 的英文怎麼說

中文拼音 [jīnzhǔcéngbǎn]
金屬層板 英文
metal wood
  • 金 : Ⅰ名詞1 （金屬） metals 2 （錢） money 3 （古時金屬制的打擊樂器） ancient metal percussion instrum...
  • 屬 : 屬名詞1 （類別） category 2 [生物學] （生物分類系統上所用的等級之一） genus 3 （家屬; 親屬） fami...
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 板 : Ⅰ名詞1 （片狀硬物體） board; plank; plate 2 （專指店鋪的門板） shutter 3 [音樂] （打拍子的樂器） ...
  • 金屬 : metal
  1. Mechanism of multi - layer spray deposition of bimetal

    多層噴射沉積制備雙金屬板材的機理初探
  2. Nonlinear vibration of heated bimetallic thin circular plates

    受熱雙層金屬圓板的非線性振動
  3. Water wash is prohibited for clesning the surface of raised floor. dry mop shall be used to clean it to prevent surface of raised floor from being desquamated and metal parts under it from being rusted and corrded

    活動地板表面禁止用水沖洗，應用擰乾的拖把拖掃，以防活動地板表面飾面層起皮及下部金屬件銹蝕。
  4. These electrons cannot pass into the phototube because of the insulation on the metal plate.

    由於金屬板上的絕緣層，這些電子並不能進入電光管。
  5. Polyvinyl chloride coated and laminated metal sheets

    聚氯乙烯塗層和層壓金屬板
  6. By using one - dimensional finite different hydrodynamic code coupled with four spall models, spall in ductile metal has been studied

    摘要在平面一維彈塑性流動有限差分計算程序中加入4種延性金屬層裂模型，對平板撞擊層裂實驗進行數值模擬。
  7. In this paper, a high performance sma system applied to steel bridge deck is put forth in allusion to the pavement project of the wuhan junshan yangtze river highway bridge. it comprises steel slab, zn coating layer, closing layer, adhesive, pre - mixed asphalt stone and dual layer sma from bottom to top. it is based on the fea results of the forces and deformation of the pavement layer by means of the algor feas, according to this bridge ' s traffic and the ambient temperature varying range of the pavement layer

    本文針對武漢軍山長江公路大橋鋼箱梁橋面鋪裝工程，從鋪裝層環境溫度變化范圍、交通量等使用條件出發，在用algorfeas有限元分析軟體分析鋪裝層受力變形基礎上，提出了（即鋼板+金屬鋅塗層+封閉層+粘接劑+預拌瀝青碎石+雙層sma ）的高性能鋼橋面sma鋪裝體系，並對這種sma的組成材料，包括改性瀝青、集料、礦粉、纖維進行了比較研究，設計了這種sma的配合比，對sma混合料的性能進行了對比試驗，對這種sma方案進行了疲勞性能研究，驗證了所選擇sma方案的可行性。
  8. Our company adopts the metal honeycomb or the metal network board carrier, with special coating coating technology and processing technology, prepare different forms, the all kinds of catalysiseses of specification, used in petrol exhaust. with the characteristic of light in low temp, purification efficiency high and long life etc. main technological schemes as below

    通用汽油機凈化器我公司採用金屬蜂窩或金屬網板載體，通過特殊的塗層塗覆技術及加工工藝，可制備不同形狀規格的各類催化凈化器，用於汽油機的排氣凈化，具有起燃溫度低凈化效率高使用壽命長等特點。
  9. Fire extinguishing pylon is designed with the help of lots of design institute in order to meet the fireproof requirement. it s made of fire extinguishing panel and common steel pylon or fire extinguishing dent, heat isolation layer and general steel pylon. its quality in fire extinguishments, electricity, and metal framework has over - passed the relevant standards of usa and japan etc

    防火橋架是我公司為滿足消防要求，在眾多設計單位支持下，研製成功的耐火鋼制橋架，具體結構有阻燃板加普通鋼制橋架和防火槽盒加隔熱層加普通鋼制橋架兩種，其耐火性能電氣性能金屬結構性能已超過美國日本等國的有關標準。
  10. With the focus on the structure and components character of plate metal / ceramics graded coating, this paper extends and improves the thermal elastoplastic analysis model of trilayered materials derived by suresh et al and builds the theoretical model of thermal elastoplastic stresses analysis of plate metal / ceramics graded coating, and this paper also analyzes the thermal elastoplastic stresses and deformation of metal / ceramics graded coating

    本文針對平板狀金屬陶瓷梯度塗層的結構和組成特徵，推廣和完善了suresh等人的三疊層材料的熱彈塑性分析模型，建立了平板狀金屬陶瓷梯度塗層熱彈塑性應力分析的理論模型，對金屬陶瓷梯度塗層的熱彈塑性應力和熱彈塑性變形進行了分析。
  11. Analysis of metal - clad graded index planar optical waveguides with edge element method

    金屬包層漸變平板光波導的邊緣元分析
  12. During the past years a great deal of interest has been devoted to the study of ceramic composite armor due to the application in defense, in the light of recent work of ceramic / composite armor the dissertation provides the defensible performance of ceramic / metal, ceramic / non - metal light armor and multi - layer ceramic composite armor and its optimization design. at one time, it motives us to study the smash mechanism of ceramic facet plate under the effect of impact load and to analyzed different defensible performance from homogeneous armor

    本文針對陶瓷復合裝甲的研究現狀，深入系統地研究了陶瓷/金屬、陶瓷/非金屬輕型裝甲和陶瓷多層復合裝甲的抗彈性能及優化設計，同時研究了在沖擊載荷作用下陶瓷面板的破碎機理，對陶瓷復合裝甲不同於均質裝甲的抗彈性能進行了分析。
  13. The sculpture is constructed with a double - shell system of copper and zinc. these two materials have a great degree of difference in their thermal conductivity. the materials are structurally bonded together to allow for their varying degrees of expansion

    雕塑採用了銅和鋅雙層板作面層，利用兩種金屬不同的導熱系數，隨時表現出冷縮熱脹的效果，創造出一個抽象和簡潔的動感雕塑，讓人們感覺出周圍溫度的變化和陽光的美。
  14. Standard test method for adherence of porcelain enamel coatings to sheet metal

    金屬薄板搪瓷覆層的粘著性的標準試驗方法
  15. Definition of the wood - frame - construction house : one kind of frame - construction house, the wall and the floor and the roof of which are made of the structural wood - based panel and the specific timber, distance between each is less than 600 millimeter, jointed by the metal joinsts

    輕型木構小住宅是指：將木基結構板材與間距不大於600mm側立的規格材用金屬件連接成墻體、樓蓋、和屋蓋，並組成框架式結構的住宅，一般為1 ? 3層。
  16. In this paper, the metal powder and foil, which used in some of researches, has n ' t been used

    本文提出薄金屬板作造型材料分層快速製造金屬功能零件，並做了相關的課題研究。
  17. 0. 250 preferred thicknesses for uncoated thin flat metals under 0, 250 in

    無鍍層金屬薄板的最佳厚度
  18. Continuously hot - dip metal coated steel sheet and strip. tolerances on dimensions and shape

    連續熱浸鍍金屬鍍層鋼板和鋼帶.尺寸和形狀公差
  19. The book also considers forming technologies for various composite material forms including thermoset and thermoplastic prepreg, molding compounds, and composite / metal laminates

    該書還認為成形技術，為各種復合材料的形式，包括熱固性和熱塑性預浸料，成型化合物，並復合/金屬層板。
  20. Self - supporting metal sheet for roofing, external cladding and internal lining - product specification and requirements ; german version en 14782 : 2006

    外部鑲面和內部襯墊屋頂層用自承重金屬薄板.產品規范
分享友人
分享到 Line

分享到臉書