金屬矯直 的英文怎麼說
中文拼音 [jīnzhǔjiǎozhí]
金屬矯直
英文
metal straightening-
This consists for the most part in straightening up, cleaning, and, on thicker plates above 5/16 in vee-ing the edges.
主要是矯直，清選，對于厚度超過516英寸的金屬板，還需將焊邊做成V形坡口。This consists for the most part in straightening up, cleaning, and, on thicker plates above 516 in vee - ing the edges
主要是矯直，清選，對于厚度超過5 16英寸的金屬板，還需將焊邊做成v形坡口。This consists for the most part in straightening up, cleaning, and, on thicker plates above 5 / 16 in vee - ing the edges
主要是矯直，清選，對于厚度超過5 16英寸的金屬板，還需將焊邊做成v形坡口。The formation process of w - type ferrite underwent from oxide of metal, the m - type transition phase to final w - phase. when the heating rate was 5 / min, at 900 for 3 hrs and 1200 for 4 hrs, pure m - type and w - type ferrites were formed in air respectively. with heat treatment temperature increasing, crystal structure was more intact, the saturation magnetization increased and the coercive force decreased
熱處理過程表明， m型鐵氧體直接由金屬氧化物反應形成，未經歷尖晶石中間相； w型鐵氧體形成由金屬氧化物到m相過渡相最終向w相的轉變；當升溫速率為5 min ，溫度在900 ，保溫3小時和1200保溫4小時，就分別形成單相m相和w相鐵氧體；隨著熱處理溫度的升高和保溫時間的延長，衍射峰變尖銳，結晶更完整，空心微球的飽和磁化強度增大，矯頑力減小。The tbco amorphous films with and without cr underlayer had been successfully prepared onto glass substrate by magnetron sputtering method. the influence of the preparing conditions to the structure, coercivity and the perpendicular magnetic anisotropy ( pma ) of tbco films were investigated. and the origin of the pma in these films was studied
採用磁控濺射法在玻璃基片上成功地制備了帶有和不帶有金屬cr底層的tbco非晶垂直磁化膜，研究了制備工藝對tbco薄膜結構、矯頑力、垂直磁各向異性的影響，並對tbco非晶垂直磁化膜的磁各向異性來源進行了研究。分享友人