鈰合金 的英文怎麼說
中文拼音 [shìgějīn]
鈰合金
英文
cerium alloy-
Silver alloys - determination of cerium content
貴金屬及其合金化學分析方法銀合金中鈰量的測定Silver alloy - determination of cerium content
銀合金中鈰量的測定Effect of ultrasonic on the performance of tin - cerium alloy electrolyte
超聲波對錫鈰合金鍍液性能的影響Titanium alloy - method for determination of lanthanum, cerium, praseodymium and neodymium
鈦合金.鑭鈰鏷和釹的測定方法The methods for chemical analysis of zinc and zinc alloys - the determination of lead, cadmium, iron, copper, tin, aluminium, arsenic, stibium, magnesium lanthanum and cerium contents - the inductively coupled plasma - optical emission spectrometric method
鋅及鋅合金化學分析方法鉛鎘鐵銅錫鋁砷銻鎂鑭鈰量的測定電感耦合等離子體-發射光譜法Surface depletion layer and its influence on the corrosion morphology for aiuminum - linthium alloys containing cerium
鈰對鋁鋰合金表面貧化層及其腐蝕形態的影響Determination of cerium in cerium - tungsten alloys - oxidation - reduction volumetry
鎢鈰合金中鈰的測定氧化還原容量法Standard specification for zinc - 5 % aluminum - mischmetal alloy - coated steel wire strand
鋅- 5 %鋁-鈰合金塗覆鋼絲繩的標準規范Standard specification for zinc - 5 % aluminum - mischmetal alloy - coated carbon steel wire
鋅- 5 %鋁-鈰合金塗覆碳素鋼絲的標準規范Standard specification for zinc - 5 % aluminum - mischmetal alloy - coated steel chain - link fence fabric
鋅- 5 %鋁-鈰合金塗覆鋼連接鏈環欄柵結構Standard specification for zinc - 5 % aluminum - mischmetal alloy - coated steel overhead ground wire strand
地面架空線用鋅- 5 %鋁-鈰合金塗覆鋼絞線的標準規范Standard test method for chemical analysis of zinc - 5 % aluminum - mischmetal alloys by icp emission spectrometry
用icp發射光譜測定法對鋅- 5 %鋁-鈰合金作化學分析的標準試驗方法4 the research, development and production of surface engineering - new plating techniques ; electroless plating, composite electroplating ; aluminium and its alloys hard anodizing and colouring, metal surface ceramics and the surface modification of special nonmetal materials
鋁合金表面微弧氧化自潤滑陶瓷覆層新技術電沉積或脈沖電沉積制備多功能復合材料新技術無氰電鍍鋅-鋁合金和鋅-鈰合金新工藝The test results of sub - c type showed that middle voltage is higher with 50 u m alloy particle, la - rich alloy has perfect performance at high rate, ce - rich alloy is excellent at high rate and lower temperature, low co alloy is good to decreasing middle voltage except the less recycle life. experiments about the electrolyte showe d that the performance is optimized with contents : koh 78 %, naoh 20 %, lioh 2 % and density 1. 300 g / cm3
對貯氫合金材料粒度和成份進行了粒度分佈測試、成分分析和xrd掃描，並將材料制備成sc型電池進行大電流測試，結果顯示，合金粒度在50 m時，電池放電平臺高，富鑭合金的大電流性能好，富鈰合金有利於電池低溫高倍率放電性能，合金中鈷含量減少雖對電池的放電平臺有利，但循環壽命短。The porous lial - ce alloy anode has the best charge and discharge properties
添加鈰的多孔鋰鋁合金陽極具有理想的充放電性能。The discharge capacity and voltage of lithium - aluminium anode can be enhanced by adding 0. 5 % 1. 5 % ce and the surface quality of the anode can also be improved
在鋰鋁合金陽極中添加0 . 5 % 1 . 5 % （質量分數）鈰，可增大電池的放電容量和電壓，改善鋰鋁合金陽極的表面形貌。The rare earth ferro silicon cerium accounts for 46 - 50 % of total rare earth, we can accurately adjust the percentage content of rare earth alloy according to the clients request
稀土硅鐵合金鈰/占稀土總量的46 - 50 % ，根據用戶的需要，可準確地調整稀土合金的百分含量。Methods for chemical analysis of cast bearing metals - determination of antimony content - cerium sulfate titrimetric method
鑄造軸承合金化學分析方法銻量的測定硫酸鈰滴定法The widely used mg alloy zm5 is chose as the original alloy. on the surface of the molten alloy, a layer of protective film with dense structure is formed by the addition of la, ce or mischmetal. the film prevents the penetration of oxygen and volatilization of mg vapor, and then prevents the zm5 alloy from oxidation and burning
針對目前廣泛應用的zm5鎂合金，通過添加稀土鑭、鈰和混合稀土，在鎂合金液面上形成一層結構緻密並且具有耐久性的保護膜，阻止氧氣的進一步侵入和鎂蒸氣的向外揮發，不再產生鎂的劇烈氧化燃燒現象。The methods for chemical analysis of zinc and zinc alloys - the determination of lanthanum and cerium contents - the tri - bromide arsenazo spectrophotometric method
鋅及鋅合金化學分析方法鑭鈰合量的測定三溴偶氮胂分光光度法分享友人