陶基微電路 的英文怎麼說

中文拼音 [táojīwéidiànlù]
陶基微電路 英文
ceramic-based microcircuit
  • 陶 : 陶名詞1. （窯） kiln2. （人名用字） a word used in person's name
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. To solve the problems above, this dissertation supported by the project of national natural science foundation ( nnsf ) : research on piezoceramic micro - actuator ’ s polarity modeling and controlling method ( code : 60274053 ) focuses on the research of driving and control technique of piezoceramic. the drivers based on voltage, current control had been designed with the high voltage amplifier as core component

    針對壓電陶瓷驅動存在的上述問題，本文結合國家自然基金項目「壓電陶瓷微驅動器件極化模型與驅動方法的研究」 （編號: 60274053 ） ，以高壓運算放大器為核心元件，通過分析電壓、電流型驅動器原理及電路參數，提出了一種彌補其不足的復合型驅動方法。
  2. The following results of recent researches were presented on measuring stiffness of a wide range of soils such as clay, sand and gravel, characterizing anisotropic properties of soil induced by external loading, measuring stiffness of base and subgrade materials in the pavement, determining soil properties in a centrifuge model during the flight of a centrifuge, and understanding wave propagation in granular materials under micro - gravity environment with this technique

    木文報道了壓電陶瓷傳感器應用於粘土、砂和礫石等不同種類土的研究成果，對應力導致土體各向異性的研究，對路基和地基土的力學特性檢測，在離心模型試驗中的應用，以及在微重力環境下的粒狀材料中波的傳播特性的研究等。
  3. This paper developed a micro angular rate gyro based on micro piezoelectric ceramic rod structure instead of the sensitive double - deck structure as well as piezoelectric ceramic strain foils, and designed a phase - sensitive detection circuit

    摘要研製了基於微型壓電陶瓷棒結構代替雙敏感梁結構及壓電陶瓷片的微型角速率陀螺，並設計了相敏檢波電路。
  4. Uniform and compact plzt and sno _ 2 ceramic targets, which diameter were 212mm and 221mm, respectively, had been successfully fabricated. ( 2 ) a rotating magnetic field rf magnetron sputtering system had been designed and set up, which showed high utilization efficiency of target, high films uniformity, and high deposition rate, etc. ( 3 ) the plzt and sno _ 2 thin films were investigated by afm, xrd, sem, and spectral photometer. the optimized processing parameters of preparing these films had been found

    並以此為基礎分別制備了緻密、均勻、平整、直徑為212mm的plzt和221mm的sno _ 2陶瓷濺射靶材; （ 2 ）為克服現有磁控濺射設備的不足，提出了一種新的磁控濺射方案，採用該方案的設備具有:靶材利用率高、鍍膜均勻、成膜速度快等特點; （ 3 ）運用afm 、 xrd 、 sem以及雙光路分光光度計等分析手段對plzt和sno _ 2薄膜的微結構和性能進行研究，找到了制備plzt電光薄膜和sno2透明電極材料的最佳工藝條件。
  5. The thesis mainly investigated the bati _ 4o _ 9 ( bt _ 4 ), which has the lowest dielectric loss in ba - ti system, and ( ba, sr ) tio _ 3, the a position substitute compound of batio _ 3. the dielectric properties of bt _ 4 / bst with different preparation way and different elements doping were investigated. a archimedes method, xrd, sem, impedance analyzer, network analyzer and hakki - coleman method were used to investigate the density, phase formation, microstructure, dielectric properties and doping mechanisms

    本論文以在ba - ti系中具有最低介電損耗的bati _ 4o _ 9 （ bt _ 4 ）高頻介質陶瓷和batio _ 3a位sr取代而得的（ ba ， sr ） tio _ 3 （ bst ）高頻介質陶瓷作為研究對象，對不同粉體制備方法制備的bt _ 4 / bst高頻電介質材料進行不同元素的摻雜，運用阿基米德方法， x射線衍射分析儀，掃描電子顯微鏡和阻抗分析儀，網路分析儀， hakki - coleman法等方法手段和測試儀器測試燒成樣品的密度，相組成情況，微觀結構和介電性能，探討造成介電性能起伏的形成機理。
  6. Firstly, the relationship of atomic force and distance is studied. the scan type of samples and the working mode of probe is confirmed, then pzt is chosen as actuator for micro scan displacement, and optical deflexion method is used to detect the deflexion value of cantilever. after all these work, the system light path design is finished, and its mathematical model is completed

    首先，分析了原子力探針系統的中原子力?距離的關系，並確定探針系統的探針的工作模式和樣品的掃描模式，從而選擇壓電陶瓷作為掃描微位移驅動器;採用光學偏轉法檢測微懸臂偏轉量，並選用了psd作為傳感元件，並在此基礎上進行了系統光路設計及其數學模型的建立。
  7. In this paper, the ceramic coatings were prepared in situ on ti - 6al - 4v alloy by micro - plasma oxidation ( mpo ). the phase composition, microstructure and corrosion resistance of the ceramic coatings were studied in detail and the technology of corrosion resistant coatings was optimized. the dissolution of the substrate and the changes of the elements in the electrolyte during the mpo process were studied to discuss the growing characters and the structure of the ceramic coatings

    本文通過微等離子體氧化（ mpo ）方法在ti - 6al - 4v鈦合金表面原位生長陶瓷膜，系統地研究陶瓷膜的相組成、微觀結構及膜層耐腐蝕性能，並優化耐蝕性陶瓷膜層制備工藝;分析基體在mpo過程中的溶解現象和電解液中離子濃度變化特點，探討電極表面陶瓷膜層生長規律和結構特點;研究膜層的等效電路、膜層結構與耐腐蝕性能的關系，並對優化工藝條件下制備的陶瓷膜層進行進一步的耐腐蝕性能測試和耐腐蝕機制研究。
  8. Alumina ceramic substrates for microwave integrated circuits

    微波集成電路用氧化鋁陶瓷基片
  9. The mixer is fabricated using hmic process based on the thin film ceramic substrate and tested

    該混頻器主要採用微帶混合集成電路，薄膜陶瓷基片製作。
分享友人
分享到 Line

分享到臉書