陶瓷壓電元件 的英文怎麼說

中文拼音 [táocíyādiànyuánjiàn]
陶瓷壓電元件 英文
ceramicator
  • 陶 : 陶名詞1. （窯） kiln2. （人名用字） a word used in person's name
  • 瓷 : 名詞（用高嶺土、長石、石英等燒製成的材料） porcelain; china
  • 壓 : 壓構詞成分。
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 件 : Ⅰ量詞（用於個體事物） piece; article; item Ⅱ名詞1. （指可以一一計算的事物） 2. （文件） letter; correspondence; paper; document
  • 陶瓷 : pottery and porcelain; ceramics陶瓷地磚 floor tile; 陶瓷電子管 ceramic tube; 陶瓷電阻器 ceramic r...
  1. To solve the problems above, this dissertation supported by the project of national natural science foundation ( nnsf ) : research on piezoceramic micro - actuator ’ s polarity modeling and controlling method ( code : 60274053 ) focuses on the research of driving and control technique of piezoceramic. the drivers based on voltage, current control had been designed with the high voltage amplifier as core component

    針對壓電陶瓷驅動存在的上述問題，本文結合國家自然基金項目「壓電陶瓷微驅動器件極化模型與驅動方法的研究」 （編號: 60274053 ） ，以高壓運算放大器為核心元件，通過分析電壓、電流型驅動器原理及電路參數，提出了一種彌補其不足的復合型驅動方法。
  2. Smart materials and structure have definite requirements of sensor components and driving components, for example, they can adhere well to the matrix and have higher strength, fatigue strength, more broad scope of frequency response and faster response speed, etc. piezodielectric ceramics have characteristic of easily preparing, heat - resistance, wet - resistance, high strength and broad scope of frequency response, etc. furthermore, it has piezoelectric effect and inverse piezoelectric effect, namely it can produce electric potential energy when it is transformed by mechanical strength and its mechanical dimension can be transformed when voltage is put on it

    壓電陶瓷能與基體材料很好結合，具有制備容易、耐熱、耐濕、強度高、頻響寬等特點，另外它具有正壓電效應和逆壓電效應，即當它受到機械力變形時，能產生電勢，對它施加電壓時，能改變其機械尺寸，因此它在智能材料結構中既能用作傳感元件又能用作驅動元件。
  3. Electronic ceramic parts. e. g. piezoelectronic devices

    電子陶瓷元件.如壓電陶瓷
  4. Bai shi new development over the years, the company ' s products are mainly trade sales world - renowned brands ; has formed a production and supply of quartz crystal and ceramic capacitors, thick film resistors based serial production lines. main products include : plug posted quartz crystal surface, the surface of quartz crystals and crystal oscillators, posted plug surface, quartz oscillator vco, stickers and vco plug - round version of ceramic capacitors and vertical and horizontal layer ceramic capacitors, chip resistors and resistor ranked / exclusion order and capacitance / second polar body / mixed network

    新佰仕經過多年的發展，公司貿易的產品主要銷售世界知名品牌電子元器件；現已形成了以生產及供應石英晶體?陶瓷電容器?厚膜電阻器為主的系列化產品生產線，主要產品包括：表面貼石英晶體?插件石英晶體?表面貼石英振蕩器?插件石英振蕩器?表面貼壓控振蕩器?插件壓控振蕩器?圓版型陶瓷電容?立式與臥式積層陶瓷電容?排列電阻器?晶元電阻/排阻?排列電容/二極體/混合網路。
  5. Zno varistors have been widely used in electronic and electrical power devices and systems because of excellent nonlinear v - i characteristics and high absorbance of electric current surges. with the smt ( surface mounted technology ) development, traditional zno varistors can not meet the multilayer thin films lamination structure nappe varistor ceramics and metal electrode low temperature co - fire need. however, the best character of zno - v2o5 varistor can sinter in common furnace during lower temperature ( 900 ), not only settling the problem relate to upon, but also saving energy sources

    Zno壓敏電阻因其優異的v ? i非線性和較高的浪涌吸收能力而廣泛應用在電子、電力設備系統上。然而，隨著表面貼裝技術（ smt ）的發展，傳統的zno壓敏陶瓷不能滿足多層膜獨石結構疊層壓敏電阻元件陶瓷與金屬電極低溫共燒的需要。而zno ? v2o5系壓敏陶瓷的最大優點是能用普通燒結爐在較低溫度（ 900 ）下燒結，不僅解決了以上問題，還大大節約了能源。
  6. Insulators for overhead lines with a nominal voltage above 1 kv - ceramic insulators for a. c. systems - characteristics of insulator units of the long rod type

    公稱電壓大於1 kv的架空線路用絕緣子.交流電系統用陶瓷絕緣子.長桿型絕緣子元件特性
  7. Generic specification for piezoelectric ceramic transducing elements

    壓電陶瓷換能元件總規范
  8. Mainly for capacitance, semiconductor, jingzhen, resistance, ic chips, jiechajian procedures, connecting pieces, switching devices, silicon, triode, diode, piezoelectric ceramic base films, tubes, electron tubes, electronic stamping, precision metal parts, production processes between cleansing processes

    晶元接插件連接件轉接器矽片三極體二極體壓電陶瓷基片顯象管電真空器件等內精密電子沖壓五金零件，生產加工過程工序間的清洗。
  9. The piezoelectric actuator becomes one of the most prospective components because of its outstanding advantage. but the hysteresis and creep character of the material restrict the development of this actuator. new stable characteristic tungsten bronze piezoelectric actuator was adopted as driving component in this article, we develop the anti - hysteresis control method through contrasting the crystal structure of the tungsten bronze actuator with which of the perovskite actuator, at the same time corresponding software and hardware were studied in order to prove the validity of this control method, and then demarcated the other characters of the actuators through lots of experiment results

    本研究選用了性能穩定的硬性鎢青銅型壓電陶瓷驅動器作為驅動元件，從壓電陶瓷驅動器遲滯產生的微觀機理入手，通過對比硬性鎢青銅型壓電陶瓷驅動器和軟性鈣鈦礦型壓電陶瓷驅動器的晶體結構，研製出壓電陶瓷驅動器抗遲滯驅動方法，設計了相應的軟硬體裝置以從實驗結果上證明這種方法的正確性，並對其他影響定位精度的因素進行了特性標定實驗。
  10. The ceramic componets are made of high stability piezoelectric ceramics that functions as a mechanical resonator

    陶瓷元件由高穩定性壓電陶瓷製成，其功能表現和機械諧振器一致。
  11. Surface acoustic wave components, capacitors, emc filters, ntc thermistors, ptc thermistors, ferrites & accessories, inductors, microwave ceramics, arrestors, rf modules etc

    聲表面波元件，電容器，電源濾波器，熱敏電阻，壓敏電阻，鐵氧體磁心與附件，電感器件，微波陶瓷元件，氣件放電管，射頻前羰模塊等等
  12. The core of the piezoelectric ultrasonic motor, piezoelectric ceramic is systematically researched. based on the piezoelectric effect, the piezoelectric equations are derived. from the piezoelectric equations, the important parameter of the piezoelectric ceramic ' s physical performance and the system equations of the vibrator are derived

    深入地研究了超聲波馬達的核心元件? ?壓電陶瓷，從壓電效應著手，推導了壓電方程，得到了描述壓電材料物理特性的幾個重要參數，並導出了壓電振子及壓電陶瓷的系統方程，論述了壓電振子的振動模態及諧振特性。
  13. Bourdon springs, diaphragms, capsule springs and magnetic pistons are used as the mechanical pressure sensing element ; electronic pressure gauges and switches are based on thin - film technique, ceramic - or piezoresistive semiconductor sensors

    機械壓力傳感器元件有波登彈簧，橫膈膜，圓柱體彈簧和磁感活塞。電子壓力儀表和開關則是基於薄膜技術，陶瓷或壓阻半導體傳感器。
  14. Firstly, the relationship of atomic force and distance is studied. the scan type of samples and the working mode of probe is confirmed, then pzt is chosen as actuator for micro scan displacement, and optical deflexion method is used to detect the deflexion value of cantilever. after all these work, the system light path design is finished, and its mathematical model is completed

    首先，分析了原子力探針系統的中原子力?距離的關系，並確定探針系統的探針的工作模式和樣品的掃描模式，從而選擇壓電陶瓷作為掃描微位移驅動器;採用光學偏轉法檢測微懸臂偏轉量，並選用了psd作為傳感元件，並在此基礎上進行了系統光路設計及其數學模型的建立。
  15. Insulators for overhead lines with a nominal voltage above 1 kv. ceramic or glass insulator units for a. c. systems. characteristics of insulator units of the cap and pin type

    公稱電壓大於1 kv的架空線路用絕緣子.交流系統用陶瓷或玻璃絕緣子元件.帽形和針形絕緣子元件的特性
  16. Traditional micro - displacement actuator always uses heat - expanded materials and piezoelectric ceramic. and these materials universally have many disadvantages, such as small expanding - contracting value, long reaction time, complex driving structure, easily aging and so on, which seriously influence output range and controlled precision

    傳統的微位移驅動器的驅動材料多採用熱膨脹元件和壓電陶瓷，由於在這類材料中普遍存在伸縮應變量小、反應時間長、驅動結構復雜、易老化等問題，嚴重影響了驅動器工作范圍的擴大和控制精度的提高。
  17. Piezoelectric ceramic filters for use in electronic equipment. a specification in the quality assessment system for electronic components. part 1 : generic specification - qualification approval

    電子設備用壓電陶瓷濾波器電子元器件質量評定體系規范第1部分:總規范鑒定批準
  18. The article put forward the general plan to realize intelligent pneumatic actuator and studied and analyzed on some of key technical questions : low power - consumption electrical - pneumatic converting unit and low power - consumption control circuit solution which is based on piezo ceramic principle and meet the requirements of intrinsically safe explosion - proof ( ib ct5 ) ; general software solution which realizes the goal of intelligence and hart communication function ; reliability design solution which answers the purpose of mtbf 16000 hours and regard electrocircuit, machine unit and software as main parts

    本課題以氣動調節閥的智能化為研究目標，提出了實現氣動執行器智能化的總體方案。並對其中幾個關鍵技術難題進行了研究分析：以滿足本安型防爆要求（ ib ct5 ）的基於壓電陶瓷原理的電氣（ i / p ）轉換單元、低功耗的控制電路方案；以實現智能化和hart網路通訊功能為目標軟體總體設計方案；以mtbf 16000小時為目標和以電子電路、機械零部件、軟體為主體的整機可靠性設計方案。
  19. For detecting of light power, the pre - amplify, filtrating wave and integration circuit is designed. after the design of system and selection of element are completed, pzt is out of shape instead of the elasticity element in experiment

    在完成系統設計和元件優化選擇后，以壓電陶瓷替代軋機內的彈性元件，通過在其內外表面加驅動電壓使其產生變形，用上述微分干涉式傳感器測量該應變。
  20. Shenzhen luguang electronic technology co., ltd is a high - new electronic technical enterprise, which is specializing in r & d, manufacturing, and selling of various piezoelectric materials, such as piezoelectric frequency components, diodes, transistors, digital television receiver, wireless controller, etc

    深圳市魯光電子科技有限公司，是一家專業研發、生產、銷售各種壓電陶瓷材料，壓電陶瓷晶體頻率元件?二極體?三極體?提供各種電路設計，模組化設計，無線控制器等各種電子產品的供應和技術應用的高新企業。
分享友人
分享到 Line

分享到臉書