離聚物樹脂 的英文怎麼說

中文拼音 [líjùwùshùzhī]
離聚物樹脂 英文
ionomer resin
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 聚 : 動詞（聚集; 聚積） assemble; gather; get together
  • 物 : 名詞1 （東西） thing; matter; object 2 （指自己以外的人或與己相對的環境） other people; the outsi...
  • 樹 : Ⅰ名詞1 （木本植物的通稱） tree 2 （姓氏） a surname Ⅱ動詞1 （種植; 栽培） plant; cultivate 2 （樹...
  • 脂 : 名詞1. （動植物所含的油質） fat; grease; tallow 2. （胭脂） rouge 3. （姓氏） a surname
  • 樹脂 : resin; jaffaite; peucine
  1. The synthesis methods of isobutyl acetate catalyzed by p - toluene sulfonic acid, amino sulfonic acid, strongly acidic cationic exchange resin, ferric chloride hexahydrate, cupric chloride bi - hydrate, stannic chloride pentahydrate, ammonium ferric sulfate dodecahydrate, sodium bisulfate monohydrate, potassium bisulfate, chitosan sulfate, sodium dihydrogen phosphate, rare earth metallic oxide, solid super acid, heteropoly acid and molecular sieve etal were reviewed

    摘要評述了對甲苯磺酸、氨基磺酸、強酸性陽離子交換樹脂、六水三氯化鐵、二水氯化銅、五水四氯化錫、十二水合硫酸鐵銨、一水硫酸氫鈉、硫酸氫鉀、殼聚糖硫酸鹽、磷酸二氫鈉、稀土金屬氧化物、固體超強酸、雜多酸和分子篩等催化劑催化合成乙酸異丁酯的方法。
  2. Using non - saturable polyester resin as its basal masal and unidirectional fiberglass woven fabrics as its skel eton, the frp pole is taken shape by ce - ntrifugal kr twine forming process and has high axial strength and its content if fiberglass is over 50 %. the frp light pole

    Frp燈桿系採用不飽和聚酯樹脂為基材，以單向布為主的玻璃纖維織物為骨架，採用離必成型工藝或發纖維骨架通過纏繞成型工藝製作而成，玻璃纖維含量在家50 %以上，軸向強度很高。
  3. The polymer - supported catalysts were used in different kinds of reaction, such as ion - exchange resins, polymer - supported phase transfer catalysts, polymer - supported acid catalysts, polymer - supported base catalysts, polymer - supported metal catalysts, polymer - supported biological catalyst and so on

    介紹的聚合物固載催化劑有6類，包括離子交換樹脂催化劑、聚合物固載的相轉移催化劑、聚合物固載的酸催化劑、聚合物固載的堿催化劑、聚合物固載的金屬催化劑、聚合物固載的生物催化劑等。
  4. Testing of ion exchangers - recycling method for testing ion exchangers and polymer adsorption resins

    離子交換器的檢驗.離子交換器和聚合物吸附樹脂的循環
  5. The results from basic properties, shear resistance, pressure strength and point film test show that different low molecular polyamide may affect extrodinary by the properties of cured expoxy resin the higher viscosity, the lower cured activity ( rate ) ; the higher amine number, the stronger cure construction. the cured expoxy resin will prossess unfavourable mechanics when it is cured by the polyamide with both too high viscosity and amine number

    用基本性能、剪切強度、抗壓強度、塗膜性能測定等方法研究了3種不同胺值及粘度的低分子量聚酰胺對環氧樹脂固化物性能的影響.結果表明，聚酰胺粘度大使固化交聯變難，胺值過高易造成固化收縮；同時粘度過大、游離胺含量過高的產品將對固化物各項力學性能不利
  6. The paper consists of the following parts : ( 1 ) synthesis of a novel resol with dibenzyl ether bond ; ( 2 ) preparation of the phenolic resin / layered silicates nanocomposites ( rplsn ) and investigating the melt intercalation and curing behavior ; ( 3 ) discussing mechanical properties and its related influence factor

    本文分為三個部分：首先合成帶芐基醚鍵的熱固性酚醛樹脂，然後制備粘土聚合物納米復合材料討論其熔融插層和剝離行為，最後討論各種因素對力學性能的影響。一帶芐基醚鍵的無氨熱固性酚醛樹脂的合成。
  7. The intercalation and exfoliation behavior of lamellar clay in the thermoset resin / clay composites during curing was studied in this paper. for epoxy / organoclay system, intercalation and exfoliation behavior of organoclays in epoxy resin has been investigated

    本論文以熱固性樹脂/粘土復合體系為研究對象，主要研究了分散在聚合物基質中的層狀粘土在固化過程中插層和剝離行為。
  8. Four types of starch derivatives containing azo groups were used in removal of some metal ions from their solutions, and the different factors affecting metal ions adsorption on these copolymers, such as ph, metal ion concentration, types of starch derivatives, treatment time and temperature was premarily studied at first

    摘要合成了4種偶氮化合物與澱粉的接枝共聚物的不溶性樹脂，首次用以吸附二價金屬離子，研究了其靜態吸附量以及各種相關因素對吸附的影響。
  9. The general applications for spme are that fused silicate fibers were coated with various liquid polymeric coatings, such as polydimethylsiloxane ( pdms ) and polyacrylate ( pa ). lately, other more specialized materials have been developed, including ion - exchange coatings, liquid crystalline films, carbowax and nafion coatings

    后來又發展了一些有特點的塗層材料，如離子交換塗層、極性的nation全氟化樹脂塗層、導電聚合物聚吡咯（ ppy ）和聚- n -苯基吡咯（ pppy ）等。
  10. Base on our experimental results, a conclusion can be deduced. when the polymer and silicate layers have some capacity, the polymer chains with great molecular weight can exert much greater shear and stress, which is favorable to the exfoliation. while, the huge molecular weight could lead to the loss of fluidity of the polymer melt

    在樹脂基體于粘土片層具有一定相容性的前提下，分子量較大的分子鏈對粘土片層可產生較大的作用力，利於粘土片層的剝離；但過大的分子量又降低了聚合物熔體的流動性，妨礙了粘土的進一步插層。
分享友人
分享到 Line

分享到臉書