電介通量密度 的英文怎麼說
中文拼音 [diànjiètōngliángmìdù]
電介通量密度
英文
dielectric flux density-
At this time, the approximate mechanical model of devices has been put forward, which frequency is 70 mhz, then we analyzed the euler ? bernoulli equation, find that the frequency is determined by the resonator ’ s density thickness and length ; the free - free - beam 、 coupled beam 、 support beam 、 transducer have been designed ; the model was simulated and modal analyzed on the coventorware and were consistent with the designed parameter. the silicon surface microfabrication process was developed and emphatically introduced several key surface microfabrication technologies, and was simulated by coventorware
本文通過分析歐拉-貝努立方程，得出濾波器的共振頻率主要由諧振梁的密度、厚度和長度決定，考慮切變形和轉動慣量的情況下，完成微機械諧振梁、支撐梁、驅動電容的設計;在coventorware軟體上進行模擬，分析結果與理論設計比較好地吻合;對微機械濾波器的加工工藝進行設計，給出器件的完整的工藝流程，重點介紹微機械表面加工工藝，並在coventorware上進行模擬。The two - dimensional axisymmetric subsonic - transonic - supersonic flow in an experimental arcjet thruster is simulated numerically using flux vector splitting method. the profiles of density, velocity, temperature, pressure and mach number can be obtained by the computation. the computation grid and some computed results are given here. the test equipment such as power supply system, ignition system, propellant supply system, arcjet thruster, thrust measuring device and vacuum system are introduced briefly. some working phenomena of the arcjet are observed and discussed. three different kinds of instability appeared in the process of the experiments. except some important parameters are measured, it is found that the operating stability of argon is better than that of nitrogen
對一實驗電弧加熱式發動機二維軸對稱亞跨超音速流動進行了數值模擬，所採用的方法是矢通量分裂演算法.通過計算可以得出密度、速度、溫度、壓力和馬赫數的分佈.給出了計算所使用的網格和一些計算結果.簡要介紹了實驗所使用的設備，如電源系統、點火系統、推進劑供給系統、電弧加熱式發動機、推力測量裝置和真空系統.對所觀察到的一些工作現象進行了討論.有三種不同的不穩定性出現于實驗過程.除了所測量的一些重要參數，通過實驗發現氬比氮工作更穩定
分享友人