電器噪聲 的英文怎麼說

中文拼音 [diànqìzàoshēng]
電器噪聲 英文
electrical equipment noise
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 噪 : 動詞1. （蟲或鳥叫） chirp 2. （大聲叫嚷） make noise; make an uproar; clamour
  • 電器 : electrical equipment [appliance]電器燈 electric appliance lamp; 電器乾燥爐 electrical drying furn...
  1. In designing analogic circuit, we adopt programmable filter max262 to meet the system ' s command. after the step, we can make the signal ' s frequency width is wider and noise level is lower. to make the signal ' s amplitude to meet the analogic to digital device ' s command, we adopt the max551 to finish the gain control

    在模擬電路部分，採用可編程濾波器max262 ，這樣就滿足了該數據採集裝置所採集的信號的頻率范圍較寬以及具有較低的噪聲水平的要求，為了使采樣到的信號的幅度滿足後面a d轉換器的要求，採用max551對采樣到的信號進行調理（增益控制） 。
  2. In digital relay, the percentage of noise will increase rapidly with the increase of sampling rate when derivation calculus is substituted by sampled difference term. to solve this problem, a new method using fragment function integrated with the least square algorithm is proposed in this paper. the influence of white noise is greatly reduced and the accuracy of the dead angle calculation is nicely improved after adopting the new method

    在數字式保護中，如果用差分代替求導將導致噪聲的百分比誤差隨著采樣頻率的提高而劇增，本文對此進行了分析並提出了用分段樣條函數最小二乘法來計算電流波形的導數值，以便在提高采樣率的同時降低噪聲誤差的影響，並將其應用於基於32位浮點dsp的新型變壓器保護裝置。
  3. There are over 80 sets test apparatus in tech - innovation centre, including : anechoic chamber, vibration tester, vibration measurement analysis, impact instrument, constant temperature and humidity facilities. salt spary test case, circle insulation withstand voltage tester, insulation resistance tester, withstand voltage tester, electric lead tester, electrical leakage tester, earth resistance tester, chassis dynamometer, chassis dynamometer control system, high stability dc resistance tester, electrical capacity tester, temperature rise test system

    中心擁有各類分析測試儀器和試驗裝置80餘臺套，包括：消音室振動臺噪聲振動測試分析系統沖擊儀恆溫恆濕實驗儀鹽霧試驗箱匝間耐壓分析儀絕緣電阻分析儀對地耐壓分析儀泄露電流測試儀對地電阻測試儀測功機測功機控制系統高精度直流電阻測試儀電參數測試儀帶電溫升測試儀復合式三坐標測量儀萬分投影儀及電功測試分析系統等。
  4. Again call the the ratio, namely the electric voltage of the enlarger s exportation signal with at the same time output s voice ratio for electric voltage, usually use the decibel number to mean. the equipments s letter the ratio is more our output of high enunciation is more little. by any large, letter the ratio is more big, and the elucidation is in the in the signal a the quantity for more smallly, voice returning putting is more high, otherwise contrary. letter the ratio should be generally not lower than 70 dbs, high the letter of the true box the ratio should attain 110 dbs are above

    又稱為訊噪比，即放大器的輸出信號的電壓與同時輸出的噪聲電壓的比，常常用分貝數表示。設備的信噪比越高表明它產生的雜音越少。一般來說，信噪比越大，說明混在信號里的噪聲越小，聲音回放的音質量越高，否則相反。
  5. Earphone cushion for audiometric testing

    聽力測試用電子噪聲發生器
  6. Using an lc circuit as a power supply filter can actually multiply the power supply noise at the filter " s resonant frequency. use inductor with low q to overcome this

    使用lc電路作為電源濾波器能精確地在濾波器的諧振頻率點處乘以電源噪聲，使用低q電感來應對。
  7. In electronic detectors such as photomultipliers and television tubes, noise manifests itself as random fluctuations in the output current.

    對于光電倍增管，電視攝像管之類的電子探測器，噪聲則表現為輸出電流的隨機起伏。
  8. Due to temperature performance of fbg, a reference fbg is adopted to compensate temperature and the compensation principle is expounded. moreover, this scheme not only realizes temperature compensation but also reduces repeatability error of ffptf and errors from power fluctuation of light source, noise of pd and noise of electro - circuit. in the end, temperature and strain performance of fbg is tested and

    基於光纖光柵的溫度響應特性，提出用一個參考光柵來進行光纖光柵傳感陣列溫度補償的設計方案，並論述了其補償原理，證明了該方法的可行性；同時可以看出，該方法不僅可以實現溫度補償，也可以減小光纖f - p可調諧濾波器的重復性誤差以及光源功率波動、探測器噪聲和電路噪聲等引起的誤差。
  9. The main testing parameters include : productivity, weight of specimen, electric power, the temperature of bearings and the noise from machinery etc. the main controlling parameters include : auto - taking of original seed, auto - controlling of two - directed valve, adjusting of productivity and automatic starting / stopping system for each equipment

    其主要檢測量有：生產率、接樣重量、耗電量、軸承溫升、機器噪聲等；主要控制量為：原始物料的自動接料、接樣三通的自動控制、喂入量調節、實驗臺各環節的自動開機關機等。
  10. This will be dealt with in this paper. the discrimination for noise source from qn700 indicates : the fan noise ( 625hz ), the electromagnetism noise ( 962hz ) and the burning noise are the main noise sources

    對汽車燃油空氣加熱器中具有典型代表結構的qn700型樣機的測試分析表明：風扇噪聲（ 625hz ） 、電機噪聲（ 962hz ）和燃燒噪聲是加熱器的主要噪聲源。
  11. Noise limit value for househould and similar electrical appliances

    家用和類似用途電器噪聲限值
  12. With the software cadence, model establishment and parasitic parameter extraction are made on the main pcb lines of the proposed circuits. equivalent circuit models of common mode combined with differential mode current and noise simulation models are also established on full bridge switching - mode converters. study on the simulation of conducted interference noise is made with the software saber and the effects on the circuits " noise by the main parasitic parameters are also analyzed

    在對全橋開關型變換器電路工作原理分析的基礎上，建立了全橋開關型變換器主要元器件的電磁干擾參數模型，利用cadence軟體對其pcb主要印製導線進行了建模分析和寄生參數的提取，得到了全橋開關型變換器傳導干擾的共模、差模噪聲電流等效電路模型以及噪聲模擬模型，並運用saber軟體進行了傳導性干擾噪聲的模擬研究，分析了主要寄生參數對電路噪聲的影響。
  13. Rc oscillator ’ s frequency is 1khz. the voltage reference of ic is 2. 2v, which can keep stabilization when the power supply is bigger than 2. 3v. in that case circuits can insulate yawp from power supply

    在穩壓源電路設計中，採用了運算放大器負反饋的形式，使參考電壓源為2 . 2v ，並在電源大於2 . 3v時保持穩定，隔離了電源噪聲。
  14. You can still hear a lot on shortwave, at least in locations without too much electrical noise from tvs, computers, rechargers etc

    您能在短波聽到好多電臺，至少當地不會從電視、計算機、充電器等發出許多電子噪聲。
  15. The most important parameters for data acquisition systems design are initial error, output voltage temperature coefficient ( tc ), thermal hysteresis, noise, and long - term stability of the voltage reference device

    對數據採集系統設計最重要的參數是器件的初始誤差、輸出電壓溫度系數、熱遲滯系數、輸出電壓噪聲、長期穩定度。
  16. Method of measurement of current noise generated in fixed resistors

    固定電阻器產生的電流噪聲的測量方法
  17. A kind way of current sharing composed of the droop method and the master - slaver method based on thermal stress and the random of the master is given, in this system an extra controller is attached ; all the software and hardware on can fieldbus communication part have accomplished, which guaranteed the communication of the charger high reliability and high real - time. the source and types of the noise from switching power are analyzed and some methods are introduced to restrain noise and strengthen the system performance of interference rejection

    提出了一種外加控制器基於熱應力均流的主從可轉換均流方法；對系統中can總線通信部分的軟硬體進行了設計，保證了系統通信的實時性和可靠性；對開關電源噪聲來源與種類進行了分析，介紹了一些抑制噪聲和增強系統抗干擾性能的措施。
  18. Not only regulator can transform a constant voltage to some kinds of various voltages, but also the transformed voltages must be not changeable with temperature changing ( i. e. zero temperature coefficient ). and it should be stable though the power supply is not immune. so the art of regulator design should be more challenging

    電壓調節器不僅要具有將某個固定電壓轉換成所需要數值的電壓的功能，而且轉換后的電壓須具有在一定的溫度范圍內不隨溫度的變化而變化（也即零溫度系數） ，以及不受輸入電壓噪聲影響的特點，這對電壓調節器的設計提出了更高的要求。
  19. Method for sound testing of portable household electric room air cleaners

    便攜式家用房間電動空氣清新器噪聲的試驗方法
  20. We choose hb qrc convert as the research object. this paper has completely analyzed the circuit work modes, designed an experimental device, analyzed the mam noise source, established the common - mode and different - mode noise current models, extracted the parasitic elements of four pcb layout and simulated each emi level. based on these, it has derived the element which have great effect on pcb emc and has designed the optimized pcb layout

    選擇一種半橋準諧振變換器作為研究對象，對其工作原理進行了詳細的分析，製作了實驗樣機，分析了它的主要干擾源，建立了它的共模、差模噪聲電流等效電路模型，對它的四種不同pcb布局進行了寄生參數提取和電磁兼容模擬，在此基礎上分析得到了影響其電磁噪聲水平的最重要因素，並設計出了最優的pcb布局。
分享友人
分享到 Line

分享到臉書