露點表 的英文怎麼說
中文拼音 [lòudiǎnbiǎo]
露點表
英文
dew point apparatus-
The surface temperature is less than 3 above the dew point
底材表面溫度沒有達到高於露點3以上的條件下。Product : tachometer 、 stroboscope 、 surface speed mter 、 anemometer 、 sound level meter 、 moisture meter 、 grain moisture meter 、 thickness meter 、 coating thickness meter 、 humidity meter 、 dew point meter 、 temp. meter 、 lux meter ect
主要產品:主要產品:轉速表、風速表、聲級計、 (噪音計) 、水份儀(水分儀) 、溫濕表、露點儀、測厚儀、塗層測厚儀、溫度表、照度表、頻閃轉表等。Quality one important shortcoming, is it have various to behave, one that is such as thready pulse form " water reveals the son ", " reed catkins " of the spot of design form of the reed, " clam " of clam s light, etc.
質地不均勻是一個重要缺點,表現有各種各樣,如細脈狀的「水露子」 ,蘆花色狀斑的「蘆花」 ,蚌?亮光的「蛤蜊性」等等。Based the humidity theory, the paper adopts the relative humidity as the character value and puts forward using 30 % rh and below 0c dew - point as the on - line monitoring critical value. it gives the method of volume ratio convert at the different temperature. with the standard value, we can conclude the result of moisture content
針對現有規程標準中控制水分的指標的缺點和局限,提出了採用相對濕度作為監測特徵量並轉換為露點以直觀表示設備絕緣狀況:採用30相對濕度及0以下露點作為監測的臨界值與允許值;同時推導出了體積比單位在不同溫度下的折算方法,以結合現有標準,綜合分析,做出判斷結論。Air temperature, dew point and relative humidity : digital thermometers with platinum resistance sensors have been used since 1982. mercury - in - glass thermometers are used for back - up purposes
氣溫露點及相對濕度:天文臺自一九八二年開始使用配備白金電阻感應元件的數字溫度表,水銀溫度表則用作后備。Results of calculation indicate that the bubble & dew points may be reduced extremely, but the relative volatility rises slightly and the separation of them is affected hardly by decreasing pressure. and this article puts forward more reasonable modifying suggestions after analyzing numerically in detail the common method of determining the position of sensitive plate in distillation tower and finds out something unsatisfactory about it
計算結果表明,減壓可大大降低乙苯?苯乙烯物系的泡、露點,但相對揮發度增加甚微,對其分離的難易程度幾乎無影響;對常用求取精餾塔靈敏板位置的方法進行了詳盡的數值分析,對其不合理性提出了改進措施。Abstract : the causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %
文摘:分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水,蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰,排煙溫度高,煙氣熱量未回收利用以及爐子保溫襯里效果差等問題,提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明,本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題,提高了保溫效果,減少散熱損失1 . 25 % ,排煙溫度降至170左右,裝置的爐效率由83 %左右提高到90 %以上The causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %
分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水,蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰,排煙溫度高,煙氣熱量未回收利用以及爐子保溫襯里效果差等問題,提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明,本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題,提高了保溫效果,減少散熱損失1 . 25 % ,排煙溫度降至170左右,裝置的爐效率由83 %左右提高到90 %以上3 move the dew - point meter and immediately check up the inside surface of insulating glass have not any dew or frost
3移開露點儀,立刻觀察玻璃試樣的內表面上有無結露或結霜。When the temperature get to the environment dew point, there will be dew on the surface, when the temperature is below zero, we even can find ice on the components. this is the external condensation problem. this problem is a great threat to the safety and service life of the pneumatic system. so this article is the research about it, we try to find out the principle of the external condensation and get a effective method to judge when it will happen, this will give great help to the designer
氣動系統在運行中會出現系統元件表面溫度下降的情況,當元件表面溫度達到環境露點溫度以下時就會發生結露,當溫度降到零度以下時就會發生結冰,這就是氣動系統的外部結露問題。外部結露對氣動系統的安全和使用壽命都有很大的影響,本文就是針對這一問題進行研究,通過對氣動系統外部結露的原理和實驗及模擬的分析,找出判斷一個氣動系統是否會發生外部結露方法,以對氣動系統的設計提供幫助。The surface temperature must be above the dew point. dry surface completely before application
表面溫度必須在露點以上,施工前徹底乾燥表面。It can be used as a general dew - point meter or a special industrial instrument
它可以作為通用露點測量儀和專用工業儀表使用。The measurement results and uncertainty analysis shows that in the dew point range of - 25 ~ + 25 the uncertainty less than 0. 04
測試結果和不確定度分析表明,該發生器在25 ~ + 25測量范圍內,露點溫度測量的不確定度不大於0 . 04 。Analysis of fuel gases - general methods - determination of water dew point and relative humidity - principles of cooled surface condensation hygrometers and general description of their use
氣體燃料分析.第10部分: :通用方法.第3節:水露點和相關濕度測定.第1小節:表面冷卻冷凝濕度計原理及使用說明The results are follows : chemical composition, tensile strength, yield strength and elongation accord with standard, part corrosion of outside is dew point corrosion, equable corrosion of inside is brought by deoxidized water
結果表明:其化學成份、抗拉強度、屈服強度、延伸率均符合標準要求,管材外表面局部腐蝕是因露點腐蝕造成,管材內表面受除氧水的作用均勻腐蝕。These skilled singers, led by joey yung, offer not only charming songs but also splendid dances. a creative, amusing, and enjoyable musical, safari the musical
至於王浩信穿上露點上衣, at17的ellen表演一字馬高難度動作, sun boy z三子在臺上勁歌熱舞,黃耀明與張敬軒的演出反應非常熱烈。Do not apply when the surface temperature is less than 3 above the dew point of the air
底材表面溫度應比空氣露點至少高3 ,否則不能施工。In view of smaller and thinner samples required in grinding slice for microprobe analysis, three steps are used : establishing a thinner grinding plane on the center of homogenized crystalloid melt inclusion sample, grinding the surrounding parts of the sample to the thickness as the center, polishing the grinded sample slice in order to expose the melt inclusion to the sample surface
摘要針對磨製樣品十分細小和較薄等特點,採用如下三個步驟磨製:以加熱過的細小樣品為中心創建一磨製平面;將樣品周圍的巖石薄塊磨至接近細小樣品的相同厚度;在拋光機上拋光,使包裹體完全露出表現。Monthly relative humidity, dew point, wet - bulb temperature and vapour pressure recorded at the observatory between 1961 - 1990
表5 . 1961 - 1990年天文臺錄得相對濕度露點濕球溫度Monthly relative humidity, dew point, wet - bulb temperature and vapour pressure recorded at the observatory between 1971 - 2000
表5 . 1971 - 2000年天文臺錄得相對濕度露點濕球溫度分享友人