靜態測試技術 的英文怎麼說

中文拼音 [jìngtàicèshìjìshù]
靜態測試技術 英文
static test technique
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 技 : 名詞（技能; 本領） skill; ability; trick; technique
  • 術 : 術名詞1. （技藝; 技術; 學術） art; skill; technique 2. （方法; 策略） method; tactics 3. （姓氏） a surname
  • 靜態 : [物理學] static state; quiescent condition; steady state; statics; dead level; akinesis; akynesis...
  • 測試 : test; testing; checkout; measurement
  1. In order to improve the technology level of testing static parameter of rocket bomb and increase its hit ratio, this paper describes in detail the measuring system of the moment of inertia of rocket bomb, the designing principle and realizing method

    為了提高我國航彈靜態參數測試的技術水平，增強航彈命中率，本文詳細論述了航彈極轉動慣量測量系統的設計原理及實現方法。
  2. This dissertation applies virtual instruments technique in the field of servo valve cat for the first time and makes a servo valve static and dynamic state characteristic test bedstand based on virtual instruments. relevant theories and methods are also studied

    本文首次將虛擬儀器技術應用在電液伺服閥cat領域，研製出一套基於虛擬儀器的電液伺服閥靜、動態特性測試綜合實驗臺，並對電液伺服閥靜、動態特性測試的有關理論及方法進行了研究和探索。
  3. Information technology - digital compression and coding of continuous - tone still images : compliance testing

    信息技術.連續色調靜態圖像的數字壓縮和編碼:一致性測試
  4. According to the request of the standard in electric industry in china named " on line check and test rules of analog and digital control system of power station ", every system is tested, and according to technological guides and operation rules, static and dynamic trial are required to be done, the quality of adjust, and response time also adapt to the requirement

    機組整套試運以後，各控制系統逐步投入。依據中華人民共和國電力行業標準《火力發電廠模擬量、開關量控制系統在線驗收測試規程》的要求進行測試，並按照技術指標及運行導則要求均做過靜態、動態特性試驗，調節品質、響應時間均符合要求。
  5. In iddq detecting area, the basic principle and strongpoint of iddq testing are introduced. then, the influence of deep - submicron technology on iddq testing is explained. and the improved iddq testing methods are also given

    在靜態電流檢測方面，首先闡述了iddq檢測的基本原理以及優缺點;分析了深亞微米技術對iddq測試的影響以及iddq的改進方法。
  6. Basic black - box testing and white - box testing are successfully carried out. in white - box testing, the statement coverage and branch coverage are achieved ; static analysis and dynamic analysis are also implemented. the static analysis mainly used to generate flow graph while the dynamic analysis serves program instrument, technique realization object, subprogram and the detailed coverage and the calculation of operation time of the documents

    原型系統實現了基本的黑盒和白盒測試，其中白盒測試實現了語句和分支覆蓋;實現了匯編測試的靜態分析和動態分析，靜態分析主要是生成程序的流程圖，動態分析主要是利用程序插樁技術實現語句和分支覆蓋率及在多個測試用例驅動下的綜合覆蓋率的計算和運行時間及內存使用情況的統計。
  7. The input value of static weighing system is instant and the interference is small. nsr is high, then interference signal is ease to dispose. while dynamic weighing systems have different signal modes, yawp interference magnitude size and mode when it is in different facilities and different testing objects. in this thesis has optimum attempt in this point and find a solution which has perfect practicality

    動態定量稱量技術是一項很有前景的技術，在我國發展也有很久了，但是這方面的技術還是不成熟，由於動態比靜態稱量要復雜得多，靜態稱量由於輸入值是恆定、干擾小、信噪比大，干擾信號易處理；而動態稱量系統對不同的設備、不同的測試對象產生的信號形式、噪聲干擾大小、方式均不同。
  8. The author is absorbed in research on technology of coprocessor design. in the floating - point addition the paper proposes a carry chain of dynamic and static mixed circuits and a good balance between speed and area of predicting leading - zero logic circuits, considering algorithm and construction of logic circuits. an approach of micro program controller design for coprocessor is put forward and a test bench is given to verify its function

    筆者研究協處理器的設計技術，在浮點加法器中提出動態與靜態結合設計進位鏈的方案以及前導零預測面積與速度的折衷方法；在微程序控制器的設計中提出一種協處理器微程序控制器的設計方法，並且給出其功能驗證的測試平臺。
  9. Therefore, the paper establishes the parallel computing platform and meets the demand of computing resources for large eddy simulation. it also studies the integration of cad / cam, grid generation system and cfd system, and brings the model computed in the paper into this system. on the bases of systematical and thorough numerical simulation researches in circular cylinder and the compares between instantaneous piv metrical results and numerical results of circular cylinder, the paper obtained some problems and several conclusions which should be noticed in les for making correct computatioa finally, by using these experiences and conclusions above and by putting them into an actual problem in engineering - optimized numerical simulation of static mixer, this paper achieved the turbulent high - level numerical simulation technique, i. e., system atical attempt in engineering application by les method

    為此，搭建了微機并行計算平臺，解決了大渦模擬對計算資源要求；對cad cam 、網格生成與cfd系統集成進行研究，並將論文中所要計算的模型納入到此系統內；在對圓柱繞流問題進行了系統和深入的數值模擬研究和對圓柱繞流瞬態piv測量結果與數值計算結果進行比較工作基礎上，得到大渦模擬方法正確計算所需要注意問題和若干結論；最後利用以上得出的計算經驗和結論，通過對一個實際工程問題? ?靜態混合器優化的數值計算，完成了cfd中湍流高級數值模擬技術? ?大渦模擬方法工程應用的系統嘗試。
  10. Contrast to such original place test method as static load method and drilling method, the method that applying transient rayleigh surface wave to inspect the compound foundation own many virtues as low cost, high efficiency, non - destruction, and it also can save much labour and effort. furthermore, it can implement the large - wide and comprehensive inspection and evaluation of compound foundation bearing capacity

    與靜載試驗、鉆孔法等原位測試方法相比，瞬態瑞雷波檢測復合地基技術具有成本顯著降低、效率高、無破損等特點，可節省大量的人力物力，從而可以實現復合地基承載力大范圍、全面的檢測和評價，打破以往只能局部抽檢的局面。
  11. The paper investigates deeply the loading effect and a variety of dynamic testing technique, suggests the reasonable design - size of the flattened brazilian disc ( fbd ) based on the successful experience in static loading. connecting with strain - gage method, a quick loading test is applied on the fbd on the material testing machine. the experiment obtains the elastic modulus and tensile strength of marble, the results show marble ' s properties be effected by loading, contracting which in static loading

    在靜態實驗成功的基礎上，提出了平臺巴西圓盤試樣（ flattenedbraziliandisc ? fbd ）較為合理的設計尺寸，並結合應變片技術，利用材料伺服實驗機對大理巖平臺巴西圓盤試樣進行了快速加載實驗，測得了大理巖在快速加載（ 10 ~ 2mpa s ）下的抗拉強度和彈性模量，並與靜態結果做了比較。
  12. By combining virtual instruments technique with the test technique of electro - hydraulic servo valve, the test system of electro - hydraulic servo valve based on virtual instruments has been developed by the graphics software - labview6. 1. the test principle and method of electro - hydraulic servo valve were discussed in this dissertation. the experimental results on a moog servo valve demonstrate that the design of electronic - hydraulic servo valve test system is valid

    本文將虛擬儀器技術和電液伺服閥性能測試技術結合起來，利用圖形化軟體工具? labview ，研製開發出了基於虛擬儀器的電液伺服閥性能測試系統，對電液伺服閥的靜、動態特性測試原理和方法進行了討論和研究，以moog伺服閥為測試對象進行了靜態特性測試和試驗結果分析，驗證了所開發的電液伺服閥測試系統設計方案的合理性。
  13. Based on analyzing the main characters and the limited aspects of many software testing management tools in existence, regarding the requirement of many domestic software companies, the author researched and developed a software testing management tool, which includes such characters as listing under : ( 1 ) testing running process management, separating the static information and dynamic information of the testing cases to manage the running process of the testing cases, supporting iterative testing and regressive testing ; ( 2 ) providing the individual setting of the classified properties of bug and testing case, which user can define in according to their requirements, and then providing corresponding querying and statistic functions ; ( 3 ) testing progress plan management, setting testing milestone and management check point to manage the testing progress plan ; ( 4 ) testing task management, using tier structure to express task ' s relationship, supporting task cooperative management based on work flow, monitoring the task ' s time, cost and performance during the whole process ; ( 5 ) testing evaluation, using testing cover rate and bug reports to evaluate a test

    本文分析了現有的軟體測試管理工具的主要特點和局限性，結合國內從事軟體開發的組織的實際需求，提出了一個具有下列技術特色的軟體測試管理工具： （ 1 ）測試運行管理，通過將測試用例的靜態信息和動態信息分離來進行測試用例運行的管理，為重復測試、回歸測試管理提供支持； （ 2 ）軟體缺陷和測試用例的分類屬性值的定製功能，使用戶可以根據自身組織的管理要求進行自定義，根據定製提供相應的分類查詢、統計等處理功能； （ 3 ）測試進度計劃管理，通過設定測試里程碑和管理檢查點來對測試進度計劃進行管理； （ 4 ）測試任務管理，使用層次結構表達任務的結構關系，提供基於工作流的任務協同管理，全過程監測任務的時間、成本和績效； （ 5 ）測試評價，通過測試覆蓋和缺陷報告等方法來進行測試評價。
  14. To satisfy domestic demand of testing tools for embedded assembly - language system, this thesis, based on a deep research of the current popular coverage and its realization methods, ascertains its technique route and designs a workable prototype testing platform originated from the 51 series for the embedded systems. the prototype system consists of modules of function testing, code testing, communication interface transfer module, data analysis and file report

    為了滿足國內用戶對嵌入式匯編應用程序進行測試的需求，本文在對當今主流的專業覆蓋測試工具及其實現方法進行深入研究的基礎上，結合課題確定了論文的需求和技術路線，設計並實現了基於軟體模擬的針對intel51系列單片機的匯編語言嵌入式軟體測試系統原型，原型系統由源程序詞語法分析、靜態結構分析、功能測試、代碼測試、數據分析與文檔報告等模塊組成。
分享友人
分享到 Line

分享到臉書