靜態荷 的英文怎麼說

中文拼音 [jìngtàihé]
靜態荷 英文
static charge
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 荷 : 荷名詞（蓮） lotus
  • 靜態 : [物理學] static state; quiescent condition; steady state; statics; dead level; akinesis; akynesis...
  1. By using the maxwell ' s equations and axial symmetry, a method on calculating non - static axial symmetry fields with unstable charge source is given

    摘要利用麥克斯韋方程組和場的軸對稱性，給出了由對稱軸的非靜態電場計算含不穩定電荷源的軸對稱非靜態空間電磁場的一種方法。
  2. Sicp / al matrix composites, with 5, 15 and 25 % volume fraction of sic particles, were prepared by vacuum hot - pressing sintering processing in this paper. based on mechanics properties, sem observation and energy dispersive x - ray analysis, the interface reaction phenomenon of sicp / al composites made by vacuum hot - pressing sintering, as well as the reinforcement and fracture mechanisms of this composite were analyzed. the dynamic responses of sipc / al composites were studied by a split hopkinson high - speed pressure bar impact system which strain rate was from quasistatic state strain rate ( 3. 3 10 - 3s - 1 ) to dynamic state strain rate ( 5. 2 103 s - 1 )

    本研究以武裝直升飛機防護裝甲材料為研究對象，採用真空熱壓粉末冶金燒結工藝制備了含sic顆粒體積分數分別為5 、 15和25的sic顆粒增強鋁基復合材料，結合其力學性能、掃描電鏡和界面微區能譜分析結果，分析了sic _ p al復合材料的真空燒結過程中的界面現象，以及材料增強和斷裂機理，並利用hopkinson高速壓桿沖擊實驗系統對其從靜態到動態（應變率為3 . 3 10 ~ （ - 3 ） s ~ （ - 1 ） 5 . 2 10 ~ 3s ~ （ - 1 ） ）的壓縮破壞響應進行了研究，分析了不同體積分數sic _ p al復合材料高應變率壓縮載荷下，材料的變形和微觀損傷機理，以及利用高速沖擊空氣炮測定了改復合材料制備剃度復合板的穿透性能。
  3. Estimation of intramuscular load of the upper limb in static postures and repetitive work by surface electromyography

    手臂靜態姿勢和反復性操作負荷的肌電測定分析
  4. Changes of nerve growth factor protein and mrna in the vulva skin of rabbits after ultrasound irradiation

    脛骨骨折大鼠失神經支配條件下骨折愈合過程中最大載荷及靜態骨計量學參數變化
  5. In the second place, based on the asu of buggenum igcc plant in netherlands, both static and dynamical model for distillation tower of the asu are created and some valuable conclusions are gained as well. finally, a compartmental simplified model is created for distillation tower of the asu, in order to reduce the simulation time and increase the simulation efficiency. the new model will be helpful to the further simulation and on - line optimal control for the asu of the igcc plant

    其次，本文以荷蘭buggenum電站的空分系統為原型，基於matlab建立了空分系統精餾塔的半圖形化動、靜態數學模型，並通過模擬，得出了一些有價值的結論：當空分系統的壓力變化時，氧氣產品濃度的響應時間常數為兩小時左右，說明空分系統是igcc電站最大延遲環節；而且雖然氧氣濃度最後會穩定在igcc電站所要求的范圍之內，但在過渡過程中會超出限制，這些都為igcc電站的安全運行及控制系統設計提供了有價值的信息。
  6. With the development of the electric power system, static - state reactive power compensators ca n ' t have met the requirements of the actual production and operation, and the trend to the fast and dynamic compensation for reactive power become greater and greater. since ertan hydroplant and 500kv transmission systems in sichuan power system have been operated, many power plants of load center are forced to halt during the high - water period, because the great deal of power is transmitted to far - distance load center. thus the load center loses voltage sustentation and the level of the system stabilization is debased greatly

    四川電網的二灘水電站和500kv輸變電系統投入運行后，由於二灘水電站的大量電力遠距離輸送至負荷中心，迫使負荷中心的火電機組在豐水期大量停機，使負荷中心失去電壓支撐，大大降低了電網的電壓穩定水平；同時，因為四川電網中的無功補償裝置全為靜態無功補償電容器（或電抗器） ，這些設備只能在系統正常運行狀態下起到無功補償和電壓支撐的作用，而在電網出現事故時，不但不能起到電壓支撐作用，反而會促使電網電壓崩潰事故的發生。
  7. In addition, resovling the base for fixing actuator in the part of setting and debugging of whole test bench ; indicating performance of the test bench reliability and the test data is accord with correlative standard and may be taken as the bases of trouble shooting and maintain for tractor hydraulic lift system through testing the hydraulic lifter ' s static performance of tractor newholland 110 - 90. postgraduate : shenggang luan major : mechanism design and theory tutor : prof. bolin mi

    試驗臺的安裝與調試主要是完成加載油缸的地基處理，而在試驗部分通過對紐荷蘭110 - 90型拖拉機液壓提升器的靜態性能的檢測，表明本試驗臺性能可靠，所得到的試驗數據滿足相關標準中規定的精度要求，可以作為拖拉機液壓懸掛系統故障診斷和預知維修的依據。
  8. The subject of this thesis is to study ironless moving coil linear permanent magnet synchronous motor and the major works in this thesis are summarized as follows : 1 ) two analytical formulas are derived by concentrated current method and distributed current method to determine the magnetic field due to pm, based on the current model of pm. besides, two method ( magnetic charge method and solution by laplace equation method ) are also introduced with comparing their advantages and disadvantages. then the effects of the motor parameters on the flux distribution are discussed

    本文對空芯動圈式直線同步電動機進行了深入細致的研究，內容包括： （ 1 ）採用電流模型推導出兩種計算永磁磁極二維氣隙磁場的解析公式（集中電流法、分佈電流法） ，同時介紹了兩種永磁電機氣隙磁場計算方法（磁荷法，直接求解拉氏方程法） ，分析各種方法的優缺點，討論電機參數對氣隙磁密的影響； （ 2 ）介紹了單層同心繞組的布置方式，根據安培定律推導出空芯動圈式直線永磁同步電動機的靜推力計算公式，分析靜態力?位移特性； （ 3 ）建立空芯動圈式直線永磁同步電動機動態模擬模型，模擬不同驅動方式下電動機起動、穩態運行時電磁力、速度、位移的變化情況。
  9. The effects of static load on mitochondria function in rabbit muscle

    靜態負荷致骨骼肌損傷中線粒體功能的變化
  10. The response was compared with that obtained through simulation realized by the use of matlab and the actual process on different steam flow, feed water flow, fuel flow and control method

    並運用matlab模擬工具，針對鍋爐水位和汽壓調節對象模擬模型在不同的蒸汽負荷、不同給水量、不同燃油量和不同控制方式下的動、靜態情況進行模擬研究。
  11. By static tests, studied the uf characteristics of the uf membranes, which have two kinds of intercept molecular eight, and made from pes, pek, spes and spk ， in treating black liquid from basic straw pulp. the result showed : at the condition of static contacting, the pes and spes spk are polluted by composition of black liquid in a less degree, and the pek is in the heaviest edgree. the sulphonaled membranes with higher negative charge have better uf characteristics of black liquid. the uf membranes characteristics of 20 thousand intercept molecular weight are superior to 50 thousand intercept molecular weight

    通過靜態試驗，研究了兩種截留分子量的聚醚碸、聚醚酮、磺化聚碸/聚醚碸、磺化聚碸/聚醚酮等超濾膜處理堿法草漿黑液的超濾特性，結果表明：靜態接觸條件下，聚醚碸及磺化類膜受黑液組份的污染程度較輕，聚醚酮膜的污染程度最重；荷負電性較高的磺化類膜具有較好的黑液超濾特性；截留分子量2萬的超濾膜特性要優於5萬的膜。
  12. Rolling bearings - linear motion rolling bearings - part 2 : static load ratings

    滾動軸承.線性移動滾動軸承.第2部分:靜態荷載率
  13. And these different data also made up of different damage patterns used in the dynamic testing

    同時也通過靜力荷載為動力試驗製造所需的不同損傷狀態。
  14. Machine tools ; determination of the ratings of presses for sheet metal working under static load ; hydraulic presses

    機床.靜態負荷下板金加工沖壓參數的測定.第2部分:液
  15. Machine tools ; determination of the ratings of presses for sheet metal working under static load ; mechanical presses

    機床.靜態負荷下板金加工沖壓參數的測定.第1部分:機
  16. A group of calculated results is obtained when the train goes ahead a distance steps. thus, the results in a period are obtained. in addition, the local stress analysis and the shape optimization of locking hooks are done

    對于每種載荷情況計算都按照準靜態問題進行分析，不考慮結構的加速度，只考慮載荷作用點（火車車輪）的變化，列車每前進一段距離計算一個受力工況，得到一組數據，得到了一個周期的計算結果。
  17. Based on the accumulated engineering experience of cfb technology by tsinghua university, this paper develops a pseudo - static model to study the performance of a real 135mw cfb reheating boiler under partial load. this model is a semi - theoretical model in which some key parameters are according to the engineering experiences accumulated by department of thermal engineering, tsinghua university in the last fifteen years

    本文在國內外已有研究成果基礎上，尤其是根據清華大學熱能工程系多年來致力於流化床燃煤技術的研究與開發所積累的豐富的工程經驗，採用準靜態模型化方法，對135mw再熱循環流化床鍋爐的部分負荷性能進行了研究。
  18. After a short - term load forecasting method based analogous and linear extrapolation is proposed, the load forecast and the priority of equipment action are led into static reactive power optimization. the aim function is constructed for the practical situation of power system. on the basis of traditional genetic algorithm the fitness function and the holding of population diversity are improved

    在提出基於相似日和線性外推的短期負荷預測新方法的基礎上，將負荷預測和設備動作優先級引入靜態無功優化中，並結合電網實際情況，構造了實用的目標函數，對遺傳演算法的適應度函數和群體多樣性的保持進行了改進，採用鄰域搜索運算元增加遺傳演算法的局部尋優能力。
  19. Abstract : a previously proposed approximate quasi - static theoretical method is employed herein to examine the deformation and perforation of a simply - supported circular plate struck by a flat - faced projectile at normal incidence. based on the principle of virtual work, static load - displacement relationships are first obtained and then used to predict the energy - absorbing capacity of the plate subjected to relatively low speed impact. it is shown that good agreement is obtained between the theoretical predictions and the available experimental data, provided that adiabatic shear plugging failure does not occur, but the influence of strain rate sensitivity is taken into account

    文摘:採用準靜態近似理論方法分析簡支圓板在平頭彈丸正撞下的變形和穿透.首先基於虛功原理得到了靜態荷載位移關系，並將其用於預測低速沖擊下圓板的能量吸收能力.當考慮了材料的應變率敏感性，並且不發生絕熱剪切沖塞破壞的前提下，理論預測和實驗結果吻合良好
  20. Rolling bearings - linear motion rolling bearings - static load ratings

    滾動軸承.線性運動滾動軸承.靜態荷載額定值
分享友人
分享到 Line

分享到臉書