非纖維成分 的英文怎麼說

中文拼音 [fēixiānwéichéngfēn]
非纖維成分 英文
non-fibrous component
  • 非 : Ⅰ名詞1 （錯誤） mistake; wrong; errors 2 （指非洲） short for africa 3 （姓氏） a surname Ⅱ動詞1 ...
  • 纖 : 纖形容詞（細小） fine; minute
  • 維 : Ⅰ動詞1 （連接） tie up; hold together; link 2 （保持; 保全） maintain; safeguard; preserve; keep ...
  • 成 : Ⅰ動詞1 （完成; 成功） accomplish; succeed 2 （成為; 變為） become; turn into 3 （成全） help comp...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 纖維 : fibre; staple; filamentary
  1. Nonwovens usually consist of at least two components; the fiber and the binder.

    非紡織物通常至少含有兩種成分，即纖維和粘合劑
  2. In this study, the recombinant fowl - poxvirus was transfected into expressing the vp3 gene of isolated gpv h1 strain into the cef cells with fpv - 017 by liposome, which have the lacz reporter gene, earlier / latter promoters lp2ep2 of fpv, promoters p7. 5 and p7. 1 of vaccinia virus, replication unnecessary region of fpv - 017. following 6 cycles screenings, clonings, purification of blue plaques, detection of pcr and dot - elisa, which verified the genetic stable vp3 - fowlpox virus recombinant constructed successfully. this study provided the theoretical and practical foundation for development of gpv recombinant fowl - poxvirus genetic engineering vaccine, as well as provided substance preparatory for prevention the high mortality gpv

    本研究採用脂質體轉染方法，將含有完整gpvh1分離株vp3基因、報告基因lacz 、禽痘病毒早晚期啟動子lp2ep2 、痘苗病毒啟動子p7 . 5 、 p11和fpv - 017復制非必須區的轉移載體質粒psy681vp3lacz與fpv - 017共轉染雞胚成纖維細胞，經6輪蝕斑克隆、篩選、表達， pcr鑒定和dot - elisa檢測，證明該重組病毒已構建成功，並獲得了遺傳性狀穩定的鵝細小病毒vp3基因的重組禽痘病毒。
  3. On the base of studying imaging theory of lens, the imaging theory of laser confocal scanning microscopy was analyzed in detail in this paper, and the advancement of that the optical fiber was applied to the system was described ; on the base of completed the demonstration for whole project, the experiment scheme was designed ; the relationship between the main parameters of key devices and the resolution was deduced, and the requirements of coupling efficiency and vignetting effects to optical system was analyzed ; the design of optical system and the planar scanning controlling circuit was completed ; a new method was put forward to resolved the inherent non - liner scanning problem of the galvanometer scanner by using software liner controlling in circuit design, and the perfect planar scanning was realized ; at last the low noise, high multiple and non - distortion amplify circuit of photoelectric detector was completed

    本文在透鏡成像理論的基礎上，系統、深入地分析了共焦掃描顯微成像的機理，論述了應用單模光纖的激光共焦掃描顯微成像系統的優點；進行了總體方案的論證，並設計確定了單模光纖激光共焦掃描顯微成像系統的總體方案；從理論上推導分析了解析度要求與試驗系統中相關器件主要參數之間的關系，分析了系統耦合效率和漸暈現象對光學系統的設計要求；完成了方案中光學系統和二維掃描控制電路的設計，並在電路設計中採用了用軟體解決檢流計式光學掃描器（振鏡）非線性問題的新方法，能夠實現較為理想的二維模擬掃描；完成了高增益、低噪聲和低失真的探測接收系統的設計和調試。
  4. Baby cow means the cow at the milk feeding stage. for the baby cow of eight weeks old, due to the surface layer had better fiber tissue, it is thus used to make very delicate and high price leather products

    若從年齡來分，可區分為牡牛，半成年牛及成年牛，牡牛指的還在哺乳階段，八個星期大的幼牛，這個時期因為皮層有較佳且柔軟的纖維組織，因此備用來製作非常精良且高價位的皮革產品。
  5. Hormone kind medicaments is to promote human body to metabolization and protein are decomposed and increase to use up and achieve the goal that reduces weight ; and cathartic and diuretic are excrete through increasing, discharge forcibly go human body is normal and humoral, and rather than is redundant and adipose, often cause dehydration ; food reduces weight to be comprised by fiber of unfavorable digestive plant more, there is full feeling after taking

    激素類藥物是促進人體代謝和蛋白質分解並增加消耗而達到減輕體重的目的；而瀉藥和利尿劑是通過增加排泄，強行排去人體正常體液，而非多餘脂肪，常造成脫水；食品減肥多由不宜消化的植物纖維組成，服用後有飽感。
  6. Second, many mechanical properties are tested, for example, tensile strength and tensile modulus, flexural strength and flextural modulus and impact strength. by the analysis of the tensile stress - strain curves and the flexural stress - strain curves, the results are as follows : 1 ) the voluminal content of fibre of composite making by vacuum assistant resin injection is more than other composites. 2 ) the mechanical properties of the needlepunching nonwoven fabric reinforced polymer composite are superior to these of the calendering nonwoven fabric reinforced polymer composite

    首先，採用不同的增強材料（針刺非織造布和熱軋非織造布） 、不同的基體材料（ 961樹脂和306樹脂）和不同的成型工藝方法（手糊法、真空袋法和真空輔助成型法）製造出了一系列非織造布增強復合材料，然後對它們的拉伸強度、拉仲彈性模量、彎曲強度、彎曲彈性模量和沖擊強度等力學性能進行了測試，並分析了它們的拉伸載荷? ?位移曲線和彎曲載荷? ?位移曲線，結果表明真空輔助成型工藝能大大提高纖維的體積含量；針刺非織造布增強復合材料各項力學性能優于熱軋非織造布增強復合材料。
  7. Experimental results are compared with results predicted by models. and the stress - strain relations of the models are compared with the simulate curve. at last, three models are chosen for dynamic response analysis of simulation structure situated at area of fortification intensity 8

    在此基礎上，將各模型計算機程序化，併入課題組編制完成的基於纖維（ fiber ）模型樑柱單元的三維空間框架非線性動力反應分析程序中，作為程序的混凝土材料庫。
  8. An optimized cvi - pip process has been achieved, by which the c / sic composites with 2. 1 ig / cm3 high density and uniformity are fabricated in 200 hours. the microstructure and composition of pyrolytic carbon interphase and cvi - pip silicon carbide matrix in the c / sic composites are investigated with the help of polarization microscope, scanning electron microscope, and x - ray diffraction technique, etc. the structure characteristic of pyrolytic carbon interphase and cvi - pip silicon carbide matrix, and effects of cvi - pip process on it are summarized and discussed. by growth course and feature of pyrolytic carbon interphase and cvi - pip silicon carbide matrix analyzed, a whole - course densification mechanism of lamellar - growth - pattern is proposed to explain the densification phenomenon, which makes a systematic understanding on the feature of pyrolytic carbon interphase and cvi - pip silicon carbide matrix, and the multiple stitching interface binding

    根據熱解碳中間相、 cvi - pip系sic基體相的組織構成與外貌特徵，通過對熱解碳中間相、 cvi - pip系sic基體相的生長過程和生長特徵進行分析，提出了基於層生長模式的緻密化過程理論，解釋了熱解碳中間相、 cvi - pip系sic基體相以及釘扎誘導結構多重界面的形成： （ 1 ）在1150下， cvi - sic亞基體相遵從「過飽和?凝聚?融合」機理沉積，以8f型? sic為主，同時還會有少量4h型? sic ，無游離si和游離c存在； （ 2 ） pip - sic亞基體相由非晶態sic以及彌散分佈的- sic微晶、 si - o - c和游離c組成； （ 3 ）熱解碳中間相與碳纖維增強相之間、 cvi - sic亞基體相之間形成滲透釘扎結構過渡界面， pip - sic亞基體相與摘要cvi一sic亞基體相之間形成誘導結構過渡界面。
  9. First, the constitutive model of concrete based on micropiane theory is studied and the constitutive behaviors of high - strength concrete and steel fiber reinforced concrete are described. second, the material nonlinear finite element analysis program of concrete plate, shell and box - section structures is developed. third, the sttuctural behaviors of test beams are simulated by the program developed by the aathol in the first part, the constitutive model of concrete, a key matter of material nonlinear finite element analysis of concrete structure, is studied

    作為整個課題的組成部分，筆者的博士論文中進行了以下幾個方面的研究： （ 1 ）基於微平面理論的混凝土本構模型的研究和基於該理論的高強混凝土與鋼纖維混凝土本構行為的描述； （ 2 ）混凝土板、殼及箱型結構非線性有限元分析的研究； （ 3 ）預應力高強混凝土變截面箱型連續梁結構行為的數值模擬。
  10. The results showed that it is impossible for " island - sea " structure non - compatible blend polymer to form interfacial phase separated micro - void after being drawn

    結果表明對于「海?島結構」非相容性共混高聚物中空纖維，經拉伸后，能形成相界面分離孔。
  11. 3. for the component of sub - eutectic, the cu - cr alloys are difficult to form complete eutectic tissue on the condition of non - equilibrium solidification. the general microstructure is of cellular primary a ( cu ) and circumference - distributed eutectic ( a + p ) where the former mainly acts as the conductor and the latter as the reinforce, together to be fibrous eutectic reinforced in - situ composites

    3在非平衡凝固條件下，亞共晶cu - cr合金凝固組織的一般特徵為柱狀的初生晶之間分佈著條狀的cu - cr共晶體，前者主要起導電作用，後者作為強化相，形成共晶纖維強化的自生復合材料。
  12. The proposed formula is in accordance with the old one, and the affect of nonlinear material properties of concrete and steel bars is considered by an adjusting coefficient. 6 ) based on theoretical and experimental research on material characters of steel fibered reinforced concrete, a finite element model for nonlinear analysis of steel fiber reinforced ( sfrc ) structures is presented. two - dimensional analysis on various sections of the orifice in the xiao wan arch dam is carried out

    6 ）根據已有的鋼纖維混凝土基本理論和試驗研究成果，建立了鋼纖維混凝土（ sfrc ）的有限元模型，對小灣拱壩的1 ~ #底孔斷面進行了非線性分析，研究了大連理工大學博士學位論文採用不同厚度的鋼纖維混凝上增強層和不同摻量的鋼纖維對孔口抗裂、限裂性能的影響。
分享友人
分享到 Line

分享到臉書