面間接觸 的英文怎麼說

中文拼音 [miànjiānjiēchù]
面間接觸 英文
interfacial contact
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 觸 : Ⅰ動詞1 （接觸） touch; contact 2 （碰; 撞） strike; hit 3 （觸動） touch 4 （感動） move sb ; sti...
  • 接觸 : 1. （交往） come into contact with; get in touch with 2. （沖突） engage 3. （挨上; 碰著） contact; touch
  1. The program can analyze the coactions of pile and soil, simulate the process of construction, and consider the two dimensional biot concretion

    還可以考慮樁土之間的相互作用，在樁土之間設置接觸面來模擬土與樁體的相互作用。
  2. The cause that it produces is to there exist a thin layer in the surface that liquid and the gas contact, to be called a surface layer, molecule inside the surface layer is more sparse than the inside of liquid, molecule room distance is a few bigger than the inside of liquid, molecule room coactions shows for the gravitation

    它產生的原因是液體跟氣體接觸的表面存在一個薄層，叫做表面層，表面層里的分子比液體內部稀疏，分子間的距離比液體內部大一些，分子間的相互作用表現為引力。
  3. A displacement ventilation system was provided, it can form the " air layer " at the bottom of room so that resistance dewiness air meet directly the cold floor surface

    本文採用房間下部送風的方式，使之形成地面「空氣湖」 ，阻隔潮濕空氣與室內地板表面的直接接觸。
  4. Many experiments indicate that flocculus steel balls possessing reticulate veins surface tend to elastic fluid kinetic lubricating layer and improves of the lubricating conditions of bearings. the bearings become quite, and have long life. therefore, in this paper we bring forward a new method to process flocculus steel balls possessing reticulate veins surface

    而且許多實驗表明：表面呈現網狀紋理形貌的「絨面」鋼球，有利於鋼球和套圈之間的點接觸區域形成全膜彈流潤滑層，使得軸承的潤滑狀態得到改善，從而實現軸承減振降噪和提高壽命的目的。
  5. The major function of having precious metals coated with carriers is that it can provide with larger touchable square measure. therefore, it can provide the largest surface square measure and held - up time. equilibrium tight intensity can provide gas with good mixable degree and even step - down in order not to cause slanting flow

    將貴金屬披覆于擔體上，主要功能為提供較大的接觸面積，因此可提供最大的表面積及滯留時間，均衡的緊密度可提供氣體好的混合程度及均勻的壓降，不致造成偏流。
  6. The particles distributed hi the matrix of grey cast iron, but some contact each other. the composite layer extend gradually into the substrate. when volume fraction of wc is 36 wt % and 27 wt %, the matrix of the composite is high chromium cast iron, consist of white carbide bars and the austenite. wc particles distributed uniformly, retaining approximately quondam granular form in the composite layer which has an evident interface area with the substrate, with good bonding strength

    對不同碳化鎢體積分數的灰鐵和低鉻鑄鐵基復合材料的微觀組織結構分析表明：碳化鎢體積分數為52時，復合層內基體為灰口鑄鐵組織，顆粒直接分佈在灰鐵基體上，部分碳化鎢顆粒有相互接觸的現象，基材與復合層之間沒有明顯的過渡；碳化鎢體積分數為36 、 27時，復合層內基體為高鉻鑄鐵，由面塊狀的奧氏體和白條狀碳化物組成，碳化鎢顆粒表面固溶於基體組織中，粒形基本保持完整，分佈均勻，與基體構成冶金結合，基材與復合層之間存在一個明顯的平緩過渡區。
  7. Iv ) revolute joint element, nonlinear spring - damper element, 3 - d 5 points contact element are applied to simulate the revolute restriction between two caterpillar boards, suspension nonlinear vibration, contact between wheels and caterpillar boards, and contact between caterpillar boards and ground are considered respectively. drucker - prager material is employed to simulate reinforced concrete

    4 、應用大幅度轉動約束單元、非線性彈簧阻尼單元、三維五節點接觸單元分別模擬自行火炮履帶板之間的轉動約束連接、懸掛非線性振動及負重輪與履帶板之間的接觸和履帶板與地面的接觸問題；根據材料非線性理論，提出利用drucker ? prager材料建立土壤的非線性有限元模型。
  8. The effective adhesion of permeable base and asphalt pavement, good residence of scouring property of mixture and good drainable property are benefit for undersurface of pavement and permeable base course to keep good successive contact condition

    大孔隙水泥穩定碎石排水基層和瀝青面層的有效聯結、混合料本身良好的抗沖刷性能和良好的排水性能，有利於瀝青下面層和排水基層的層間接觸條件維持在連續狀態。
  9. Course director, professor paul chan kay - sheung explains, because of the various interactions between human and animals, knowledge of zoonoses is of particular importance to local medical professionals for a better preparedness for different emerging infectious disease problems both locally and in the rest of asia - pacific

    課程主任陳基湘教授解釋：由於人類與動物間有著各方面的接觸，醫護人員有需要加強對寄生物病的認識，以及為本地及東亞地區爆發各種傳染病問題作好準備。
  10. Before studying the concrete composite deck pavement, we introduce the basic theory of touching analysis, and come up with the realization of touching analysis in the fem analysis considering the touch of concrete bridge cover plates, asphaltum concrete overlay with bridge cover etc. connect with the experiment on the spot of bridge, the software ansys is used to solidity modeling and analyzing an assembly simply supported bridge before adding overlap, after adding overlap etc., and study the influence of adding overlap on the underside bridge structures

    在進行裝配式混凝土簡支板橋復合鋪裝結構的探討性研究前，先介紹了接觸分析基本理論，並提出了考慮混凝土橋面板板間接觸、瀝青混凝土加鋪層與橋面接觸等接觸分析在有限元分析中的實現思路。結合一座裝配式簡支板橋現場試驗數據，採用ansys對該橋在加鋪前後進行了實體建模與計算分析，討論了瀝青混凝土加鋪層對下部結構物的影響。
  11. Principal conclusions were drawn as the following : the non compatibility of pressure or velocity of the gas on both sides of the contact surface is the cause of the formation of shock wave ; the heating effect of reflective shock wave to driving gas during charging or exhausting process is the internal mechanism of peak oscillating effect, and all the factors that influence the formation and the running of the shock wave will influence the peak oscillating frequency, cooling effect

    主要結論如下：熱分離機內激波形成的原因是射氣瞬間接觸面兩側壓力和速度不相容；峰值振蕩效應的內在機制為反射激波對充氣階段的驅動氣或低溫排氣的加熱，凡是影響激波形成及運動的因素都將對峰值振蕩頻率、冷效應及熱效應產生影響；當充、排氣時間比為0 . 1763時，最佳射流激勵頻率出現在高階峰值振蕩頻率上。
  12. Through structural analysis of traditional semi - rigid base course asphalt pavement which appears water damage, the paper reach the conclusion that water has an effect on material design parameter and pumping leading to the change of contact condition are the main factors

    通過對傳統的半剛性基層瀝青路面出現水損破壞進行結構分析，得知水對材料設計參數的影響和由於唧漿現象導致路面結構層層間接觸條件的變化是瀝青路面出現水損破壞的主要原因。
  13. Theoretically the varying contact rolling technology can increase the transverse stiffness of loaded roll gap, heighten the control effect of roll bending, improve the distribution of contact force between backup roll and work roll

    從理論上分析了變接觸軋制技術在提高承載輥縫橫向剛度、增加彎輥力調控功效、改善輥間接觸壓力分佈方面的作用。
  14. Considering different microstructures and properties of metal of hardened layer and the core of back - up roller, the distributions of shear stress below surface and the contact stress between work roller and back - up roller of a four - high - mill were simulated with nonlinear fem

    摘要考慮軋輥表面淬硬層與其心部金屬材料組織性能的差別，採用非線性有限元方法對四輥軋機的工作輥與支撐輥間接觸應力及輥內剪應力分佈進行模擬，並將模擬結果與傳統強度校核方法進行了對比分析，研究了軋輥淬硬層厚度對輥間接觸應力的影響規律。
  15. It is difficult to estimate indent depth in theory. this paper presents two methods to estimate the relationship between dent depth and contact force, respectively amend method and deflection compensate method, which are developed by using a clear geometrical relation to express indent, incursion profile and deflection difference

    本文以一種新的觀點，用一個明確的幾何關系來確定壓痕、壓頭與板的接觸面剖面及接觸中心點與邊界點之間的撓度差三者之間的關系，提出兩種近似預測接觸力與壓痕深度關系的方法? ?修正法和撓度補償法。
  16. The principle of precast segmental construction lies in that concrete segments are assembled as a whole structure to bear load through pressure acted on the segments by post - tensioning tendons

    預制節段拼裝原理是藉助預應力束施加於混凝土節段上的壓力，使得節段間接觸面緊密貼合，形成整體結構共同承擔荷載。
  17. In this paper, a three dimensional finite element analysis has been used to analyse the loading stress of utw pavement. the critical loading position of utw plate and the rules of the effect of the joint spacing of plate, the thickness of overlay, ec / es and the interface conditions between concrete overlay and existing ac on the stress are provided

    本文採用三維有限元法分析了utw路面荷載應力，確定了路面板的臨界荷位，得出了板接縫間距、厚度、板與地基模量比（ ec es ）和層間接觸狀況對應力的影響規律。
  18. Procaryotae diversity on the biofilm of carrier and their function to excess sludge demineralization in gravel contact oxidation reactor

    礫間接觸氧化反應器中填料表面細菌多樣性及其主要功能
  19. Email reduces face - to - face contact among co - workers and clients ; terse, poorly phrased messages further strain those relationships

    電子郵件減少了員工與同事和客戶之間面對面的接觸，而且措辭不好的郵件會進一步損害這種關系。
  20. In this paper, the block element method is used to simulate the discontinuities. the structural planes in rock masses are simulated by the contacted elements between block elements while the rheological property of the structural planes are considered by the usage of a complex rheological model describing elastic - viscoelastic - viscoplasticity as the constitutive relation of contacted elements

    本文採用塊體單元法來模擬巖體變形的不連續性，以塊體單元之間的接觸縫面單元來模擬巖體中的結構面，在接觸縫面單元的本構關繫上引入西原模型來研究巖體的流變性質，並進行了工程應用。
分享友人
分享到 Line

分享到臉書