靶反射系數 的英文怎麼說

中文拼音 [bǎfǎnshèxìshǔ]
靶反射系數 英文
target reflection coefficient
  • 靶 : 1. （射擊的目標） target 2. （轡革; 韁繩） bridle; halter; reins
  • 反 : Ⅰ名詞1 （方向相背） reverse side 2 （造反） rebellion 3 （指反革命、反動派） counterrevolutionari...
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 系數 : [數學] coefficient; ratio; modulus; quotient; factor
  1. This article studies on a novel method about detector calibration and monochromator calibration by using silicon pin photodiode. the detector and the monochromator of one spectrum measurement system had been calibrated using the method, and the spectrum distribution of one laser - produced plasmas ( lpp ) source with jet gas target was measured. the use of a specific combination of the silicon photodiode and multiplayer reflect films is the notable character in monochromator calibration

    本文研究了一種利用光電二極體傳遞標準探測器標定普通探測器和單色儀系統的方法，實際標定了所用的探測器和單色儀系統，測得了噴氣靶激光等離子體光源的相對光譜分佈，設計出絕對光譜分佈的測量方法，並且利用labview的g語言及相應的數據採集卡等硬體設備構造出一套智能化、高效率的測量系統，完成了多層膜反射率測量工作。
  2. In this paper, the target radiate characteristics and waveband selection of the infrared system reviewed briefly ; the suppression of the stray radiation in the infrared sub - system is discussed ; the material selection, the support structure and optimization of the primary mirror in the infrared sub - system of the theodolite, every factor which will affect the surface figure of the mirror is discussed in detail and get the result that in the circumstance of shooting range, the primary factor which affects the surface figure of the mirror in the infrared sub - system is temperature changing, this ca n be resolved by using material of low expansion coefficient and using same material in the mirror and the mirror seat

    本文將對紅外系統的目標輻射特徵分析和波段選擇進行簡要回顧，討論紅外系統中雜散輻射的抑制，並詳盡分析經緯儀紅外光學系統設計中所涉及到的反射鏡的材料、支撐、結構和優化設計等問題，認真討論和分析影響主鏡的面形精度的各種可能因素。並指出：在靶場環境下影響經緯儀紅外分系統主鏡面形精度的主要原因是溫度的變化，這種情況可通過選擇低線膨脹系數的材料並且使鏡座和反射鏡採用相同的材料予以解決。
  3. With the material dynamic constitutive equation including damage and the effect of stain rate the predictable formula about ballistic limit velocity of fiber composite target. secondly based on the damage feature about ceramic / fiber composite target caused by impact load, analysis model about defense performance of ceramic / composite material target is formed and the predictable formula about ballistic limit velocity is also given. lastly using the reflection and projectile theory of stress wave the paper discusses the design of ceramic / composite material target, optimizes the design of double layer ceramic / composite targets, gains optimal coefficient under certain area density and discusses the variety relationship of area density and thickness with optimal coefficient u nder some ballistic limit velocity 3

    首先，分析了纖維類正交鋪層復合靶板在沖擊載荷作用下的損傷破壞機理，結合包含損傷和應變率效應的材料動態本構方程，建立了纖維復合材料板彈道極限速度的預測公式；其次，根據陶瓷/纖維材料復合靶板在沖擊載荷下的破壞特點，建立了陶瓷/復合材料靶板抗彈性能分析模型，給出了彈道極限速度預測公式；最後，利用應力波反射和透射理論討論了陶瓷/復合材料靶板的設計問題，對雙層陶瓷復合靶板的優化設計進行了分析，給出了在一定面密度下的最佳優化系數，討論了一定彈道極限速度下的面密度和厚度隨優化系數的變化關系。
  4. Secondly, basing on the theory of on - off gain of small signal, the raman gain coefficient for frequency shift between 0. 5 and 20 thz of standard sigle mode optical fiber is measured by pump - probe method through a super luminescent diode ( sld ) as a broadband small signal probe source. thirdly, numerical simulation analysis of gain characteristic of raman fiber amplifier for c band wdm signal light is made according to the raman gain coefficient of the fiber measured before through target and four rank runge - kutta method. at the invariability of wavelength and maximum power of each of two pumps, schematic of powers of two pumps for best flatness on c band wdm optical gain was found out, at the same time, the factors of resulting in gain saturation is analyzed, too

    本文首先應用經典的電磁理論對拉曼光纖放大器的工作機制進行了分析，然後，根據小信號理論推導出的開關增益求出了光纖拉曼增益系數的表達式，採用泵浦-探測波的方法，利用超輻射激光二極體（ superluminescentdiode簡稱sld ）作為探測光源，測量了所用標準單模光纖頻移為0 . 5 - 20thz的拉曼增益系數，之後根據所測得的光纖的拉曼增益系數譜對應用該類光纖構成的放大c波段wdm光信號的拉曼光纖放大器的增益特性採用打靶法和四階龍格- - -庫塔進行了數值計算，在給定了兩個泵浦光源的波長和最大功率后，找出了反向泵浦情況下使c波段wdm光源增益最平坦的兩個泵浦的各自最佳功率，同時也分析了導致信號光飽和的原因。
  5. The method has been used to separate the frequent spectra of incident waves and reflected waves of the composed wave that are simulated by a numerical method. the results shown that the frequent spectra of incident waves and reflected waves being computed are consistent with the target spectrum and the bulk reflection coefficient is too. the frequent spectrum of reflection coefficient is same as the input round the peak frequency

    將此方法用模擬合成波波列的分離計算，結果表明，分離的入、反射波頻譜與輸入的靶譜符合良好，且計算的總體反射系數與輸入的總體反射系數一致，計算得到的反射系數頻率譜在峰頻附近與輸入值符合良好，說明該分析方法是可靠的。
分享友人
分享到 Line

分享到臉書