音速噴管 的英文怎麼說

中文拼音 [yīnpēnguǎn]
音速噴管 英文
sonic nozzle
  • : 名詞1. (聲音) sound 2. (消息) news; tidings 3. [物理學] (音質) tone 4. (姓氏) a surname
  • : Ⅰ形容詞(迅速; 快) fast; rapid; quick; speedy Ⅱ名詞1 (速度) speed; velocity 2 (姓氏) a surna...
  • : 噴動詞1. (液體等受壓力而射出) spurt; spout; gush; jet 2. (噴灑) spray; sprinkle
  • : Ⅰ名詞1 (管子) pipe; tube 2 (吹奏的樂器) wind musical instrument 3 (形狀似管的電器件) valve;...
  • 音速 : [物理學] velocity of sound; speed of sound; sound velocity
  1. As the velocity in the nozzle throat is sonic, the effect must be transmitted upstream through the boundary layer.

    喉部達到時,這種影響一定是通過附面層向上傳播而引起的。
  2. In final section of this paper, the flow field of two types of supersonic nozzle for scramjet is simulated and analyzed

    最後,本文針對兩種構型的超,對其流場進行了計算和分析。
  3. In conclusion we note the following general items concerning flow in supersonic nozzles.

    最後,我們歸納幾個關于超音速噴管流動的一般原則。
  4. At high speed and hot exhaust flow conditions, a preliminary experimental investigation on the divergent wall cooling of two dimensional c - d nozzle had been conducted

    摘要在高流條件下,對二元收擴段壁面的冷卻進行了初步試驗研究。
  5. With high temperature and high pressure in nozzle of wind tunnel, the effect of variable specific heat on nozzle design must be considered

    本文針對超、高超音速噴管內馬赫數、溫度變化劇烈的特點,研究了比熱容變化對設計型面產生的影響。
  6. Using the 3d program, hyten ( hypersonic, throat - ejecting ) nozzle, which is one of the three latest nozzles first designed in this paper, has been simulated

    利用建立的三維模擬程序,對本文設計的新? ?喉部引射注入的高超音速噴管( hyten )和光腔進行了數值模擬。
  7. Siemens vdo serves in the local china market covering the products of ems ( engine management system ), diesel system, tcu ( transmission control unit ), fuel rail, injector, sensor, fuel supply system, engine actuator, acu ( airbag control unit ), bcm ( carbody control module ), window lift motor, engine cooling module, abs motor, rke, instrument panel, audio system ( radio / cassette / cd ), navigation system, vdr ( commercial vehicle data recorder ), etc

    在中國市場上,西門子威迪歐汽車電子中國的產品系列包括ems (發動機電理系統) 、柴油機系統、發動機執行器、 tcu (自動變箱控制單元) 、油軌、燃油嘴、傳感器、油泵、 acu (安全氣囊控制單元) 、 bcm (車身控制模塊) 、搖窗電機、發動機冷卻模塊、 abs電機、駕駛臺儀表、響、導航和vdr (商用車行車記錄儀)等。
  8. This paper studies the diffuser ' s influence on the fadw ' s running properties experimentally including the inner wall and outer wall of diffuser and the backpressure of the diffuser. to prevent the gas of fadw from leaking into the laser cavity because of the effect of layer and turbulence the leak - proof flakes are designed. first the method of the leak - proof flake design is studied and then its influence on the properties of fadw is studied experimentally

    實驗研究了擴壓器對fadw工作性能的影響,提出了擴壓器結構和超音速噴管相對布局參考數據;研究了氣動窗口側壁防漏片的結構對氣動窗口性能的影響,並給出其工程設計方法;同時還研究了擴壓器不同的背壓對整個fadw作性能的影響,據此提出了擴壓器與引射器結合的設計方案,從而為大壓比、高性能的fadw的設計提供了進一步設計參考方法。
  9. The coatings deposited with a new subsonic flame spraying possess high bonding strength, low porosity and is low costly, at the same time, it is applied to the worksite of boiler tubes specially. the coatings applied to water wall tubes were deposited by subsonic flame spraying in this study

    本課題採用了一種新型亞火焰塗技術制備鍋爐水冷壁道塗層,其塗層不僅結合強度高、孔隙率較低,而且塗層制備的成本低,特別適用於鍋爐水冷壁的現場塗。
  10. The results show that to design a supersonic / hypersonic nozzle of wind tunnel must consider the effect of variable specific heat, which gives reference to nozzle and wind tunnel design

    考慮這一因素后,出口馬赫數接近設計馬赫數,其設計精度有較大提高。本方法可為超高超聲設計和反設計提供參考。
  11. To prove the accuracy of the mach number, and the parameter homogeneity of the design nozzle " s exit, cfd calculate has carried on the design results. under the condition of supersonic and hypersonic flow, and a certain range of temperature, and mach number, the conclusion of the influence of specific heat to nozzle design is drawn

    為了驗證所設計的出口馬赫數的大小和出口流場的均勻性,採用nnd格式和b l湍流模型求解雷諾平均n - s方程,對設計結果進行了cfd驗算,得出了在一定溫度范圍內,超、高超聲流動的條件下,不同馬赫數范圍內變比熱容對型面和出口馬赫數的影響。
  12. In the aspect of thermal spraying processes the main techniques applied to water wall tubes include flame spray, arc spraying, plasma spray and high velocity oxy - fuel spray ( hvof ). flame spray possesses the characteristics of simple equipment, easy of use and low operating cost, but the coating adhesive strength is low, and porosity and oxidation is high

    塗工藝方面,制備道塗層的方法主要有火焰塗、電弧塗、等離子塗、超火焰塗等。火焰塗具有設備簡單、使用方便、操作成本低的特點,但它的塗層結合強度低,氣孔率及氧化物含量高。
  13. The flow field of fadw is very complicated, especially in the free vortex jet zone. so the method is according to the ideal flow, including the design of the asymmetric supersonic laval nozzle and the diffuser

    所以,本文所建立的fadw的基本設計方法是理想狀態下的設計方法,其中主要包括非對稱超音速噴管的設計和氣動窗口擴壓器的設計方法。
  14. The engines would have variable nozzles, which would be fully opened on take - off and landing, so that the exhaust would be slow and relatively quiet, and narrowed when the aircraft was cruising, providing the necessary speed

    引擎將配有大小可以調節的尾:起飛和降落時會全部打開,這樣度會下降、噪也會更小;而巡航飛行過程中,尾將變小以保證必要的飛行度。
分享友人