飽和電平 的英文怎麼說

中文拼音 [bǎohédiànpíng]
飽和電平 英文
saturation level
  • 飽 : Ⅰ形容詞1 （吃足） have eaten one s fill; be full 2 （充實; 飽滿） full; plump Ⅱ副詞（充足; 充分）...
  • 和 : 和動詞（在粉狀物中加液體攪拌或揉弄使有黏性） mix （powder） with water, etc. : 和點兒灰泥 prepare some plaster
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 平 : Ⅰ形容詞1 （沒有高低凹凸 不頃斜） flat; level; even; smooth 2 （高度相同; 不相上下） on the same l...
  • 飽和 : （在一定溫度壓力下, 溶液可含溶質的量達到最大限度, 不能再溶解, 泛指事物達到最高限度） saturation; saturated
  1. The piezoelectric constant ( dji ) changes with the polarization time under saturated electric field. the d33 increases rapidly with the polarization time at the initial stages of polarization, and approaches constant after certain time

    在飽和電場（ es ）下，壓電常數（ d33 ）隨極化時間（ tp ）的變化而變化，極化初期d33隨tp的增加而迅速增高；極化一定時間后， d33趨于平緩。
  2. In this thesis, the image enhancement was also studied, such as dlti 、 dcti ( digital luminance 、 color transient improvement ), peaking ( luminance peaking ), ble ( black - level enhancement ), brightness 、 hue 、 contrast and saturation adjustment, and then the hardware circuit was designed

    研究了dlti （數字亮度瞬態增強） ， dcti （數字色度瞬態增強） ， peaking （亮度峰化） ， ble （黑電平延伸） ，亮度、色調、對比度和飽和度調整等圖像增強技術，並完成了圖像增強電路的設計。
  3. The energy density of the spot was 100 times the typical saturation level of the vidicons

    光點的能量密度為光導攝像管典型飽和電平的100倍
  4. Perfectly matched to power supplies where average power and peak power differ greatly, with magnetic saturation kept minimum.

    適用於平均功率與最高功率差距較大但磁飽和卻保持最小電源
  5. By successful solution of non - linear magnetic fields and revision of the program, we can reach following conclusions : in the computation of nonlinear magnetic fields, if iteration method is used, under - relaxation is necessary when amending the permeability distribution in soft magnetic materials ; and when < wp = 5 > calculating the equivalent current density in permanent magnets, under - relaxation is not a necessity ; when searching for permeability values by interpolation method on the demagnetization curve of soft magnetic materials, if a fixed saturation point is set, around this point an abrupt change of permeability values will be obtained ; this sudden change may cause a little problem in the smoothness of magnetic field distribution ; because the magnetic circuits of microwave tubes are too complicated, in the author ' s view, to describe the working state of a magnet system, the working points of magnets can not do it properly but average energy production of magnets will serve ; as to indicate the quality of a magnet system design for microwave tubes, the efficiency of magnetic energy utilization will be a very good criterion

    由此得出結論，在非線性磁場計算中：採用迭代法的情況下，在各迭代循環之間進行磁導率修正時，一個欠鬆弛迭代過程是必需的；對永磁體中的等效電流修正時可以不作欠鬆弛迭代；在純鐵的磁化曲線上指定某一個固定的磁感應強度為磁飽和值，會使得插值求出的磁導率在該磁飽和值附近有一突變，這一突變對計算結果中磁場分佈變化的光滑性稍有影響。在微波管磁系統設計中，由於微波管磁路比較復雜，作者認為磁體的工作點並不能很好地反映磁體的工作狀態，而採用平均磁能積為衡量磁體工作狀態的標準更加符合微波管磁系統的實際情況；要表示磁系統設計好壞的程度，則用磁能利用的效率為標準更好。
  6. Several kinds of er fluids with different concentration are prepared and their optical activity are measured with the changes of applied electric field and using a automatic polarimeter. experiments indicate that when none of the external electric field e, concentration c and 9 are equal to zero, er fluids appear optical activity. for a given concentration, optical rotation angle increases with electric field and concentration

    實驗發現:無外電場作用時，微乳液沒有旋光效應;當e > o且濃度c和0均不為零時，出現旋光效應且旋光角大小隨電場增加而增加;存在一個飽和電場值es ，當大於es時，旋光角平趨於一定值。
  7. At the operating voltage and current less than rated values, the amplifier provides a maximum of 5. 94 - w ( continuous wave ) output power when driven into saturation. the average combining efficiency over the operating band was estimated at 82 %. the maximum combining - efficiency and the overall power - added efficiency ( pae ) is 87 % and 13. 6 %, respectively

    該功率合成放大器在低於mmics功率單片額定工作值的情況下獲得了1 . 7ghz帶寬的最大飽和輸出功率5 . 94w （連續波） ;整個帶內合成效率估計平均為82 % ，最大合成效率達87 % ，功率相加效率（ pae ）約為13 . 6 % ;若電源達到mmics單片的額定值，估計最大輸出射頻功率將會達到7w 。
  8. The study results show that the minimum ac flashover voltage decreases with the increase of the ice amount accreted on the insulator surface by an exponential law, and the down - trend of the minimum ac flashover voltage will slow gradually with the bridging of the shed of the insulators by icicles, both the average saturated ice amount and the special exponent m of effect of ice amount for different insulators depend on the radius of shed and the air - gaps of the sheds of the insulators, and that the ac ice flashover voltage decrease with the decrease pressure ratio p / p0 ( rise of the altitude ) by power - law for different esdd and icing - states when the altitude is from 4000m to 5500m. the special exponent n, which show the effects of altitude on the flashover voltage, is various with the type of insulator, icing - states and the surface status of iced insulator etc., and that the minimum ac flashover voltage of iced insulators decreases by power - law with esdd or the freezing water conductivity for different ice amount and atmospheric

    研究結果表明：在不同海拔高度和等值鹽密esdd下，絕緣子的最低交流冰閃電壓均隨覆冰量的增加而呈指數規律降低；當覆冰量增加到一定程度后，最低交流冰閃電壓隨覆冰量增加而降低的趨勢趨于飽和；不同絕緣子串的平均飽和覆冰量及閃絡電壓的覆冰量影響特徵指數m均與絕緣子的盤徑和傘距等因素有關；在海拔4000 5500m之間，不同等值鹽密esdd和覆冰狀態下，絕緣子的交流冰閃電壓隨海拔高度的增加（氣壓的降低）與p / p0呈乘冪關系降低，氣壓影響特徵指數n與絕緣子類型、覆冰類型、覆冰表面狀況等因素有關；當覆冰量和氣壓一定時，絕緣子的最低冰閃電壓均隨著等值鹽密（ esdd ）或覆冰水電導率的增加而呈乘冪關系降低，並逐漸趨于飽和。
  9. Etc., cucr vacuum contacts vam - cucr25, vam - cucr40, vam - cucr45 and cucr50, etc. and dry - type unsaturated polyester moulding compounds, guilin coninst is in the leading position in china. a great part of the products has reached international quality level and has been applied by several internationally well - known devices manufacturers. guilin coninst enjoys a very good reputation in domestic market

    公司產品質量優異穩定，特別是銀基系列觸頭真空銅鉻觸頭和乾式不飽和聚酯模塑料三大系列產品，不論是產品製造技術與裝備還是產品性能質量均處于國內領先水平，部分已達到國際水平，並在多個國際著名電器製造商處獲得了應用，在國內享有良好的聲譽。
  10. Secondly, basing on the theory of on - off gain of small signal, the raman gain coefficient for frequency shift between 0. 5 and 20 thz of standard sigle mode optical fiber is measured by pump - probe method through a super luminescent diode ( sld ) as a broadband small signal probe source. thirdly, numerical simulation analysis of gain characteristic of raman fiber amplifier for c band wdm signal light is made according to the raman gain coefficient of the fiber measured before through target and four rank runge - kutta method. at the invariability of wavelength and maximum power of each of two pumps, schematic of powers of two pumps for best flatness on c band wdm optical gain was found out, at the same time, the factors of resulting in gain saturation is analyzed, too

    本文首先應用經典的電磁理論對拉曼光纖放大器的工作機制進行了分析，然後，根據小信號理論推導出的開關增益求出了光纖拉曼增益系數的表達式，採用泵浦-探測波的方法，利用超輻射激光二極體（ superluminescentdiode簡稱sld ）作為探測光源，測量了所用標準單模光纖頻移為0 . 5 - 20thz的拉曼增益系數，之後根據所測得的光纖的拉曼增益系數譜對應用該類光纖構成的放大c波段wdm光信號的拉曼光纖放大器的增益特性採用打靶法和四階龍格- - -庫塔進行了數值計算，在給定了兩個泵浦光源的波長和最大功率后，找出了反向泵浦情況下使c波段wdm光源增益最平坦的兩個泵浦的各自最佳功率，同時也分析了導致信號光飽和的原因。
  11. The demarcation point of, which is the parameter in erf ' s yield stress equation, is 2. 0. for, the dynamic characteristics of the clutch are remarkably different from those for. thirdly, the linear stability of plane shearing flow with non zero pressure gradient is studied

    論文第三部分對電流變液非零壓力梯度平板剪切流動的穩定性進行了分析，提出流場對屈服應力達到飽和的概念；並得出平板壁面剪切運動以及電流變液屈服應力的提高，都將使流動穩定性增強的結論。
  12. Hr 8209 is resin for bmc it has good mechnical strength, good heat distorition, good cure performance suitable for products with good surface and good electrical performance it can be used for electric parts, insustrial part, room, car parts

    Hr - 8209bmc專用樹脂hr 8209不飽和聚酯樹脂是一種高活性bmc用樹脂。制的bmc製件表面光亮平整機械強度高電氣性能優良。
  13. Hr 8520 is resin for smc bmc it has good mechanical strength, good heat distortion, good cure performance, suitable for products with good surface and good electrical performance it can be used for electric parts, industrial part, room, car parts

    Hr - 8520smc bmc樹脂hr 8520不飽和聚酯樹脂是一種smc bmc用樹脂。該樹脂製作的壓製件表面光亮平整機械強度高電氣性能優良
分享友人
分享到 Line

分享到臉書