高壓道電率 的英文怎麼說

中文拼音 [gāoyādàodiànlǜ]
高壓道電率 英文
high-voltage conductivity
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 壓 : 壓構詞成分。
  • 道 : Ⅰ名詞（道路） road; way; route; path 2 （水流通過的途徑） channel; course 3 （方向; 方法; 道理） ...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 高壓 : 1 （殘酷迫害; 極度壓制） high handed 2 [氣象學] （高氣壓） high pressure3 （高電壓） high tension...
  1. In view of this situation this article has conducted research to the design of metallurgy auxiliary biography with the frequency conversion table electrical machinery first multianalysis to the frequency changer and the frequency conversion table electrical machinery movement characteristic is carried out, the voltage waveform harmonious which the frequency changer outputs is big, attacks in a big way, and the voltage climbing rate reaches as high as 6600v / mu s which is 20 times ordinary sine alternating voltage, the rolling mill auxiliary biography table set the extremely strict request to the electrical machinery ; its movement frequency is very low, rate frequency in 8 - 20hz ; the velocity modulation scope is wide, the lowest movement frequency lowers to 1hz, and the starting number of times is quite frequently, each hour reaches as high as 600 - 800 time, the impact shoulders in a big way, the overload capacity request is high

    針對這一情況本文對冶金輔傳用變頻輥道電機的設計進行了系統研究。首先對變頻器和變頻輥道電機的運行特性進行詳細分析，變頻器輸出的電壓波形諧波大，沖擊大，電壓上升率高達6600v / s ，是普通正弦交流電壓的20倍;軋機輔傳輥道對電機提出了十分嚴格的要求:其運行頻率很低，額定頻率在8 - 20hz ;調速范圍寬，最低運行頻率低到0 . 5hz ，起動次數相當頻繁，每小時高達600 - 800次，沖擊負荷大，過載能力要求較高。
  2. The technology of alternating - current - boosting by way of constant current is successfully used to charge capacitors with 25 kilojoules of energy in only eight seconds. rail - gap switch with performances of long life and highly steady state are designed. and the high voltage pulse generator, which can produce low - excursion and fast - rise pulses, are designed by using double trigger circuit and hydro - thyristor as switch

    在大功率恆流充電技術上，成功的應用了交流調壓式恆流技術，可以在8s內讓電容器儲存25kj的能量;設計出了長壽命、高穩定的軌道開關;採用氫閘流管做開關，使用雙觸發電路，研製出了低抖動、快前沿的高壓脈沖發生器（點火機） ;採用單片機和pld ，研製出了精度為10ns的延時同步機。
  3. Based on the hydrodynamic energy transport model, the influence of variation of negative junction depth caused by concave depth on the characteristics of deep - sub - micron pmosfet has been studied. the results are explained by the interior physical mechanism and compared with that caused by the source / drain depth. research results indicate that with the increase of negative junction depth ( due to the increase of groove depth ), the threshold voltage increases, the sub - threshold characteristics and the drain current driving capability degrade, and the hot carrier immunity becomes better in deep - sub - micron pmosfet. the short - channel - effect suppression and hot - carrier - effect immunity are better, while the degradation of drain current driving ability is smaller than those with the increase of depth of negative junction caused by source / drain junction shallow. so the variation of concave depth is of great advantage to improve the characteristics of grooved - gate mosfet

    基於能量輸運模型對由凹槽深度改變引起的負結深的變化對深亞微米槽柵pmosfet性能的影響進行了分析，對所得結果從器件內部物理機制上進行了討論，最後與由漏源結深變化導致的負結深的改變對器件特性的影響進行了對比.研究結果表明隨著負結深（凹槽深度）的增大，槽柵器件的閾值電壓升高，亞閾斜率退化，漏極驅動能力減弱，器件短溝道效應的抑制更為有效，抗熱載流子性能的提高較大，且器件的漏極驅動能力的退化要比改變結深小.因此，改變槽深加大負結深更有利於器件性能的提高
  4. Transitional feature of the arc and metal droplet in the welding process with steam shielded arc is investigated by means of analysing the waveforms of welding voltage and current under different welding regimes and it is found that there are two types of arc process behavor ? " arc starting - arc blowing out - short - circuiting " and " arc - starting - short - circuiting ". under the condition of constant diameter of welding wire and its feeding speed, the arc process behavor can be changed by adjusting the inductance of welding circuit as well as the voltage of power supply. if arc process behaves as alternative process of " arc starting - arc blowing out - short - circuiting " with minimum time duration of arc blowing out and maximum frequency of short - circuit transition, the welding process will be stable with less spatter and smooth weld bead

    通過分析不同焊接規范下的焊接電壓和電流的波形.研究了水蒸氣保護下電弧及熔滴過渡的特點，發現其電弧過程行為有「燃弧?熄弧?短路」和「燃弧?短路」兩種形式.在焊絲直徑和送絲速度一定的情況下，通過調節焊接迴路中的電感量和電源電壓，可以改變電弧的過程行為形式.若電弧過程呈「燃弧?熄弧?短路」交替進行，並且熄弧時間最短時，短路過渡頻率最高，在這種情況下，飛濺小，焊道成型好，焊接過程穩定
  5. Our object is an intermediate frequency modem of a software defined radio transmitter - receiver of multi - service, multi - modulationmode and multi - processdatarate. first, related software defined radio theory is introduced ; later, channels of transmitter - receiver are designed with consideration of data format, modulation, fec, interwaving. and scrambling ; emphasis is placed on theory and implementation of an audio compression algorithm cvsd ( continuous variable slope delta modulation ) and a fec technique convolutional coding - decoding

    本文首先介紹了相關的軟體無線電理論；然後完成了包括數據格式，調制方式，糾錯碼方式，交織器和擾碼器等部分的中頻數據機通道設計；接著著重介紹了系統中使用的音頻壓縮演算法cvsd （連續可變斜率增量調制）的原理和實現，以及作為前向糾錯碼的卷積碼編碼理論和編解碼的高效實現。
  6. The measurement system consist of computer, 16 - channel high speed data acquisition board, spark plug pressure sensor, crank angle signal generator, charge amplifier and oscillograph. the max acquisition frequency of this system is 1mhz

    由通用微機、 16通道無相差高速數據採集卡、火花塞式壓力傳感器、角標信號發生器、電荷放大器、示波器組成的高速數據採集系統，最高總采樣頻率為1mhz 。
  7. This article describes the plc ’ s using enviroment and the users ’ needs in details, and then tells the differences between the dplc and the troditional plc. it also describes how to decimation and compress the tele - voice, how to deal with the data tunnels, and the multiplex data through the the line which ’ s bandwidth is changeable between 10. 8bps and 28. 8kbps this project uses the programmable vopp chips, the cpld for bus controlling, the fpga and the mcu with high processing ability. all of these ensure the high ability to process the signals and the operations

    本文詳細介紹了高壓電力線載波機的使用環境和用戶需求，全數字電力載波機和傳統模擬載波的的差異;按電力調度的需求設計完整的兩路語音、兩路數據的電力線載波通訊機。詳細描述電話語音的采樣，壓縮;數據通道的處理;及在10 . 8kbps 28 . 8kbps可變線路速率通道上的數據復接處理。從實現方法上看，該項目採用專用可編程vopp語音處理晶元， cpld晶元做為總線控制，大規模fpga集成電路，高處理能力的mcu 。
  8. This paper mainly discusses the design principles and chief techniques of a digital accessing system for power - line communication net ( plcn ). the technology of low bit rate speech compression high - speed modem based on plcn adaptive equalization to the channel anti - jamming and anti - fading are applied in this system. so speech tele - control data and tele - protection signals can be transmitted high quality in the band - limited channel

    該系統綜合應用了低比特率語音信號壓縮編碼技術、基於電力通信網的高速調制解調技術、信號傳輸的通道自適應均衡技術和抗干擾、抗衰減技術，可在帶限通道中高質量的傳輸語音、遠動數據和遠方保護等信號，具有較高的整體性能。
  9. The charge pump automatically switches between 1x / 1. 5x modes based on the input voltage, to maintain correct output levels at a high power efficiency. the led driver regulates the current of leds to a value configured by the outside control signal. the four led output channels are current matched for consistent led brightness

    電荷泵電路的功能是根據輸入電壓自動選擇1 . 5x或者1x電荷泵工作模式並輸出相應電壓信號，有較高的功率轉換效率;電流控制電路的功能是實現幾個並聯led通道的電流匹配並根據外加輸入信號控制led電流的大小。
  10. Modern cylinder pressure acquisition system is deeply affected by the advanced computer hardware technology. a / d card with the capabilities of high resolution, high sampling rate, non discrepancy and setting sampling rate at will is combined with a lot of excellent measuring equipment such as crank shaft angle encoder, charge amplifier, industrial control computer, etc. we use four type 6117a46 spark plug cylinder pressure sensors made by kistler corp.,

    高速發展的計算機硬體技術深刻影響著現代氣缸壓力數據採集系統的發展，高解析度、高採集率、多通道、無相差和可以任意設定采樣頻率等特性的a / d板卡及一大批性能優越的相關測試儀器如轉角信號發生器、電荷放大器、工控計算機等。
  11. Especially, some reports showed that elf - emf such as those from electric power transmission and distribution lines have been associated with increased risk of childhood leukemia, cancer of the nervous system, and lymphomas

    特別是有研究報道，由高壓輸電線等產生的工頻電磁場可增加兒童白血病，神經系統腫瘤及淋巴瘤發病的危險率。
分享友人
分享到 Line

分享到臉書