actuator valve 中文意思是什麼

actuator valve 解釋
起動器活門
  • actuator : n. 【機械工程】促動器；【電學】（電磁鐵）螺線管；【自動化】執行元件；激勵器。
  • valve : n 1 【機械工程】閥，活門，舌門；汽門。2 【解剖學；動物學】瓣，瓣膜；（貝）殼瓣；【植物；植物學】...
  1. Linear valve actuator attachment ; mating dimensions

    線性閥門操作機構.配合尺寸
  2. Psl straight travel electric actuator adopts two brackets and one connecter to joint with the valve

    Psl直行程電動直行機構設計採用兩個支架和一個連接件與閥門相連。
  3. Single er valve ' s control equation is derived two mathematic models of er valve - cylinder actuator is constructed according to control methods of er valve - cylinder. and a position control system based on er valve - bridge actuator is simulated. the result shows that the system has good dynamic performance

    根據電流變閥對液壓缸的控制方式，建立了兩種由電流變閥控制液壓缸組成的電流變閥控系統動力元件的數學模型，並對電流變閥橋路結構式的動力元件組成的閥控位置系統進行了模擬。
  4. After the introduction of the selected elements, the thesis gives out a design which includes a front control center based on siemens s7300 plc 、 a line connection of the master profibus and the distributed intelligent i / o et200m system 、 a real - time display system of pressure sensors and a gas supply system with stop valve and electric actuator

    本文在介紹了所選擇器件情況基礎上，設計了基於siemenss7300plc為前端控制中心，利用profibus總線接分散式智能i / o et200m系統，壓力傳感器現場顯示，截止閥加電動執行器實現配氣的方案。
  5. Then pid flow rate control algorithm is introduced. all experiments made in this chapter are about measuring the valve parameters according to spool positions, single actuator flow rate control by the calculated flow rate feedback control method, free flow rate dividing control under the sufficient pump discharge flow rate situation, proportion flow rate dividing and flow rate dividing based on meter - in flow rate feedback control method under insufficient pump discharge flow rate situation. the results of all experiments proved that the method presented in this thesis is an effective way to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads

    第四章介紹了多執行器復合控制實驗系統和實驗方法；介紹了實驗採用的流量控制的pid演算法；並測定了執行器控制閥和閥芯位移相關的系數；做了單個執行器計算流量反饋流量控制、流量足夠情況下多執行器流量任意分配、流量不足情況下多執行器按比例調節流量分配和多執行器進油側流量反饋分流控制實驗；通過實驗說明了論文提出的分流控制方法能實現大小慣性負載復合操作時的合理分流。
  6. It has the characteristic of non - gear - box, large output torque, small volume, easy control, fast response, high track precision, high reliability etc. the system has potential advantages over substituting for traditional hydraulic or pneumatic missile actuator servo control system and has wide prospect in the fields of aerial actuator, servo valve, robot, radar antenna etc. the system ' s operation principle, control idea, functions and realization of each component are discussed in detail

    該系統在取代傳統的液壓、氣動導彈舵機伺服控制系統方面有很大潛力，同時在航空舵機、伺服閥，以及機器人關節的直接驅動、雷達天線等領域具有廣闊的應用前景。論文詳述了系統的工作原理與控制思想，以及系統方案的設計和各組成部分的功能與實現方法。
  7. B ) the design of the new valve : for the displacement of the actuator, hydraulic magnify is used, and the stracture that has comparatively motion beteen harness and body and comparatively stillness between harness and body is adopted. the static characteristic of the new valve and also its dynamic characteristic, the factors that affect the valve ' s characteristic are analyzed

    設計新型高速開關閥：對驅動器位移採用了液壓式放大，並採用閥套與閥體之間有相對運動，閥芯相對閥體不動的結構。分析了新型高速開關閥靜動態特性以及影響其性能的主要因素。
  8. Industrial valves - multi - turn valve actuator attachments

    工業閥門.多回轉閥門驅動裝置的附件
  9. Intelligent actuator receives the output signal from the regulator and compares it with valve position feedback signal and obtains output signal which is directly proportional to the output signal of regulator according to the deviation between the signals and then control the pneumatic actuator

    智能執行器接受調節器的輸出信號，在與閥位反饋信號進行比較，然後根據兩者的偏差產生和調節器輸出信號成正比例的輸出信號控制執行器。
  10. To maintain the integrity of the process logic, manual air supply overrides for control and automated valve actuator solenoids are not permitted

    為保持工藝控制的完整性，控制器與自動閥門執行機構的電磁閥不許手動供氣取代自動控制。
  11. Selecting the actuator of deluge valve through observing an accidental discharge of a deluge system

    從一起雨淋系統誤噴事故看雨淋閥傳動裝置的選用
  12. Air filtration portfolio, air filters, valve, oil mist machine, filter valve, oil mist separator, micro - mist separator, stability activated solenoid valve, pressure gauge, micro - valve and vacuum valves, links the release of the closure - pressure valves, and pipe connection, a one - way valve, t - shelves, shelves, brackets, diaphragm - type flow switches, blades type flow switches, further growth actuator, the valve lock, precision valve, pressure switches, mechanical pressure switches, pneumatic control ratio positioning devices, and electric - gas ratio positioning devices, and telecommunications - pressure converters, electro - pneumatic proportional valve, filter valve, shuttle valve, gas - electric relay and gas indicator, delay pneumatic valve and cylinder fcl, plumbing fcl, mufflers and exhaust cleaner, the excess flow valve with silencer, a one - way valve, rapid valve, rapid joints, rapid valve with fcl, rapid joint sub - cluster gas, micro joints, gas pipes, pipe from the devices, and helical coils, pipes, channels, scissors, multiple fastener, high - speed rotary joint, 10000 threaded joints, and insert the tube joints, rotary joints began, 68. 25 rapid joints and hoses, hose fittings and rapid non - electrostatic

    空氣過濾組合空氣過濾器減壓閥油霧器過濾減壓閥油霧分離器微霧分離器穩定啟動電磁閥壓力表微型減壓閥減壓氣閥三通釋放式截流閥壓力開關管接頭單向閥t型隔板隔板托架膜片型流量開關漿葉型流量開關增速繼動器鎖定閥精密減壓閥壓力開關機械式壓力開關氣控比例定位器電-氣比例定位器電訊號-氣壓轉換器電-氣比例閥過濾減壓閥梭動閥氣-電繼電器氣源指示器氣動延時閥氣缸限流器管道限流器消聲器排氣潔凈器限流閥帶消聲器單向止回閥快速排氣閥快速接頭快速排氣閥帶限流器快速接頭集束分氣微型接頭氣喉管喉管脫離器螺旋管排管管道剪刀多管扣件高速旋轉接頭萬用螺紋接頭插入式管接頭旋式緊鎖接頭難燃性快速接頭和軟管不帶靜電快速接頭和軟管
  13. Please furnish the following information for verification of proper valve when ordering : valve type, working pressure, size materials of parts, working medium and temperature, the standard of flanges, actuator type, etc

    為了保證您使用的需要，在您訂貨時請詳細說明：閥門類型、工作壓力和規格、零件材質、使用介質和溫度，管路法蘭連接標注，法門驅動類型。
  14. Electronically - controlled hydraulic throttle actuator with high speed on - off valve

    高速開關閥控制的電液式節氣門執行器
  15. The hydraulically actuating, electronically controlled variable valve actuator, the common rail hydraulical source and the electronic control unit have been designed and developed. the primary control strategies of the valve timing in different conditions have been discussed. the performance of the system has been researched deeply by experiments, from which, plenty of rules have been obtained, and the way to adjust valve timing, lift and duration has been put forward

    研製了電控可變氣門系統的執行器? ?電控可變氣門驅動機構，設計了電控可變氣門系統的液壓驅動源? ?中壓共軌液壓源，開發了電控可變氣門系統的電子控制單元，實現了在不同工況下，氣門正時、氣門開啟持續期、氣門升程柔性的電子控制，並對不同工況下配氣正時的控制策略進行了初步探討。
  16. The design and develop of the intelligent valve electric actuator are expounded, the main functions and characteristics of which are introduced

    摘要論述了一種智能型閥門電動裝置的設計與開發，介紹了其主要性能特點。
  17. The open angle of the flow control valve is adjusted by electric actuator, which can be controlled remotely to meet the requirement of system measure

    流量控制閥由電動執行器調節開度，可實現遠距離控制閥門的開度，以滿足系統計量的要求。
  18. Yet, most existing high speed on / off valves use electromagnet as their electicity - mechanism conversion element, and good performant electromagnets have to be imported from other countries, in such situation, it is difficity to make excelent high speed electromagnet valve made in our country, even if we can make good performant high speed electromagnet valve in our country, it still has the shortcoming of not high enough respond speed, too small placket and big volumeo in this thesis, a new high speed on / off valve is developed based on two types of existing valves, this new valve has higher respond speed, a little big placket and little volume o for the new valve, several main task was made out as below : a ) several types of high speed on / off were first analyzed, then the basic performance of the actuator of the new valve was analyzed

    高速開關閥是20世紀80年代發展起來的一種具有響應速度快、抗污染能力強、與電子電路配合好等特點的一個良好的動力放大元件。但是現有的高速開關閥基本上採用電磁鐵為電?機轉換元件，高性能的電磁鐵又基本為進口，難以滿足高性能高速開關閥國產化的要求，即使是高性能的電磁鐵式高速開關閥，仍存在著響應速度不夠大、開口過小、體積較大的缺點。本文在現有兩種高速開關閥的基礎上，設計了一種新穎的高速開關閥，在提高其動態性能的同時，增大了閥的開口，減小了閥的體積。
  19. Control valve actuator

    閥控傳動機構
  20. The actuators are nozzle vetor controller, rotational measuring valve controller and vane controller. the smart actuators are capable of data collection, self - calibration, power - on self - test and local close - loop control, etc. a simplified mathematical model for the vector nozzle is constructed, and the relationship between the state of vector nozzle and actuator cylinders ’ position is obtained. the effect of the position controller is tested

    實現了智能執行機構的數據採集、自校準、上電自檢測和局部閉環控制等功能，建立了矢量噴口實驗件的簡化數學模型，推導了矢量噴口狀態和作動筒位置之間的關系，並在含實物平臺上對位置控制器的效果進行了實驗驗證。
分享友人
分享到 Line

分享到臉書