bias out 中文意思是什麼

bias out 解釋
外對角接觸
  • bias : n 1 成見,先入之見,偏執,偏見 (opp Impartiality ); 傾向,嗜好;癖 (towards)。2 (衣服等上面...
  • out : adv 1 〈位置及運動的方向〉向外,向外部;在外,在外部;出去,出外,離開;離岸,向海面;(船等)開...
  1. Got his rag out that evening on the bowling green because i sailed inside him. pure fluke of mine : the bias

    那天傍晚在滾木球的草地上,由於我的球滾進他的內線,他就大發雷霆。
  2. It was specially pointed out that, when the tail water is constant maximum tide, the computed flood surface is higher than that of nonsteady current, so there is some safety superelevation. underestimation of the roughness will make downward bias to compute along - river surface and bring hidden trouble for flood control. to improve the section can decrease the water level or offset the water rise for increase of floodplains " roughness, but it need much engineering works

    特別提出,按照恆定流計算出來的設計水位比非恆定水位具有一定的安全儲備;而對于灘地糙率的低估又會造成設計水位的偏低,給防洪工作帶來隱患;如果利用改進斷面形式來降低水位或彌補糙率增加帶來的水位抬高,需要較大的工程量,所以平時應注意灘面的減糙管理工作。
  3. In addition, the importance of eliminating the instrumental bias during calculating the vtec is pointed out

    指出在計算vtec值的過程中,消除儀器偏差的重要性。
  4. According to the present status of studying the solar flare using gps, a new algorithm of processing gps data studying the solar flare is brought forward : after the instrumental bias has been determined, with the data of dual - frequency gps code and phase and navigation message, the vtec at the satellite ' s epp can be worked out

    根據現在研究太陽耀斑的實際情況,提出了利用gps研究太陽耀斑的數據處理方法:利用雙頻觀測值確定出儀器偏差后,再利用碼和相位觀測值,結合導航電文就可以求出電離層交叉點的沿天頂方向上的電子總量vtec值。
  5. The study on low temperature pvd deposited sic film was carried out - m - employing bias assisted magnetron sputtering. furthermore, pvd deposited sic film mainly containing cubic phase was achieved at room temperature for. the first time

    採用偏壓輔助rf濺射法,對低溫物理氣相沉積sic薄膜進行了研究,並首次在室溫下制備出含有? sic構相併以其為主的sic薄膜。
  6. ( 1 ) a detail analysis of the uncertainties existed in current design codes was carried out, which showed that the uncertainties in the serviceability design method played a major role and these uncertainties might result a bias of 80 %. compared with these, the bias due to uncertainties in the parameters is significantly less

    研究表明振動舒適度計算方法的不確定性是高層建築風振舒適度計算不確定性的主要來源,可以導致高達80的計算偏差,與此相比,參數不確定性導致的計算偏差要小很多。
  7. He pointed out that, starting in the 1990s, home bias began to decline discernibly, as a consequence of a dismantling of restrictions on capital flows and the advance of information and communication technologies that has effectively shrunk the time and distance that separate markets around the world

    他指出自九十年代開始,本土偏好的投資心態明顯減退,原因是對資金流動的限制陸續撤銷,以及資訊科技長足發展,大大拉近了世界各地不同的投資市場在時空上的距離。
  8. Particle ratios embody the chemical equilibrium driven by inelastic interaction during rapid expansion when the temperature decreases in the colliding system, the measured hadron ratios provide the chemical composition of the fireball at the chemical freeze - out point and access the baryon transporter stopping ) for the initial conditions at early stage of the collisions. in this paper, we study the anti - proton to proton ratio from ig7au + 197 au collisions, analyzing p / p ratio as functions of rapidity, transverse momentum and centrality at ^ / saw = 200gev and the dependence on the center of mass energy of p / p ratio, compared with the experimental results. it shows that the p / p ratio has n ' t obvious dependence on rapidity for mid - rapidity, but shows a slight increase trend with pt increasing in the range of pt < 1gev / c for mini - bias or central collisions, and rqmd shows a more remarkable correlation between p / p ratio and centrality than experiments do at snn = 200gev

    研究表明:對廠在中心快度區沒有明顯的快度依賴性,在越靠近邊緣快度區, p p呈下降趨勢;在對心碰撞或者最小無偏事件中, p p在低橫動量區域隨著橫動量的升高而增大; p隨著碰撞對心度的比實驗結果表現出稍強的隨對心度增大而減小的趨勢,尤其是有再散射ujrqmd模型;在中心快度區, p p隨著碰撞的質心能量的提高而快速的增大,與實驗結果一致;在低能,有末態粒子再散射的d較好的預言了的:但是在mc能量下,有末態粒子在散射的d所預言的p p值比實驗值要小。
  9. By means of questionnaire, interview and investigation about hangzhou residents ' entertainment and leisure activities in the evening, the author partially finds out the consumption characteristics of hangzhou residents ' entertainment and leisure in the evening, including consumption bias, influence factors, consuming rules, satisfaction appraisal and so on

    本文以杭州晚間娛樂休閑活動為樣本,通過問卷調查、走訪、實地考察等多種方式,初步摸清杭州市民晚間娛樂休閑活動的偏好、影響因素、消費規律、滿意度評價等消費特徵,針對消費活動中呈現的需求特徵、行為特徵和趨勢特徵,相應提出了基於消費觀念、消費環境及消費形式等不同層面的對策和建議。
  10. The sources of uncertainty components are analyzed through the analysis of the mathematic model of measurement system. furthermore, the change of measurement system bias is pointed out as the main reason which leads to the dynamic change of uncertain with the research on the element of dynamic uncertainty combined with the research of the law of metrological property variation of measurement system. it makes the academic model of dynamic uncertainty available

    通過對測量系統數學模型的研究,分析了測量不確定度分量的來源,進一步結合測量系統量值特性的變化規律,對測量不確定度的動態機理進行了研究,指出測量系統偏差的變化引起的不確定度分量是測量系統的結果的不確定度動態變化的主要原因,從而得到動態不確定度的原理模型。
  11. Aperture synthesis uses interferometry technique to improve the limitations set by antenna physical aperture while working at lower frequency. phase and amplitude calibration of the visibility samples must be carried out to compensate for system bias before measurement

    綜合孔徑技術利用了以小口徑天線陣列合成大的觀測口徑的技術,解決了在較低頻率時天線物理口徑要足夠大才能得到期望的空間解析度的嚴重缺陷。
  12. There were five reasons that created changsha ' s private enterprises ' lacking of confidence : firstly, influenced by the tranditional concept, there were still bias and discrimination in the society against private enterprises ; secondly, the backward management ' s concept of private enterprises made the enterprises lack of the long - term consciousness during manage, in short of cooperation ' s concept and be lacking in management ' s awareness, all of these gave rise to the badly behavious of short - term ; thirdly, the backward management ' s system caused the disadventagement of encouragement of private enterprises, and then created the problem of confidence ; forthly, the government ' s support and protection for the private enterprises were not enough, which harmed the legal rights and interests of private enterprises ; forthly, the organization of medium of the society were not enough perfect. the market ' s system had not set up. it is not enough to only rely on private enterprises themselves to solve the problem of lacking of confidence, which exsited in changsha ' s private enterprises at presently it also depended on the effort which made by enterprises, the government and the society. above all, private enterprises have to carry out the scientific management motivately, promote the enterprises ' confidence ; and then, the government should try to strenghthen the awareness of servation, improves the ensurance of confidence

    造成長沙民營企業信任缺乏的原因主要有五個方面:一是受傳統觀念的影響,社會對民營企業仍然存有偏見和歧視;二是民營企業落後的經營理念,使企業在經營中缺乏長遠意識、缺乏合作意識、缺乏管理意識,造成短期行為嚴重;三是民營企業落後的管理體制,造成企業的內部激勵不足,從而引起信任問題;四是政府對民營企業的支持與保護力度不夠,損害了民營企業的合法權益;五是社會中介機構不完善,市場機制尚未形成。要解決長沙民營企業目前存在的信任缺乏問題,單靠企業自身是不夠的,這有賴于企業、政府、社會三方面的共同努力。首先,民營企業要積極實行科學管理,提升企業信任度;其次,政府要努力增強服務意識,提供信任保障;最後,社會要大力培育中介機構,建設信用經濟。
  13. Using rqmd to generate 80, 000 monte carlo mini - bias events of 197au + 197 au collisions at snn = 200gev, we study the transverse momentum distribution, particle ratios and the freeze - out time and transverse radius distributions of final state hadronic system, comparing them with the reported experimental results

    通過研究末態強子的橫動量分佈以及粒子比,特別是對帶電、 k 、 p和( ? )的平均橫動量的研究及與實驗比較,我們試圖研究在高能核碰撞中早期部分子集體行為。
  14. Consider the hugeness and the extreme complexity of first - order rule space, in order to carry out an effective search, most ilp systems have used greedy search strategy and required to explicitly present strong language bias related to the mining task, the structure feature description of first - order rules explored in mining process, to reduce the search range or is used as heuristics to guide the search

    由於一階規則空間的龐大和復雜性,為了實現有效的搜索,絕大多數一階規則挖掘系統採用了貪婪的搜索策略,並需要對具體問題給出極其嚴格的語言偏向(即挖掘過程中待測規則構成的特徵描述)來縮小搜索的范圍或作為啟發知識來指導搜索過程。
  15. This paper finds out the mean value and variance of load sequence in a period of time based on statistics and then works out the bias ratio of every point in load sequence using corresponding calculation formula and at the same time compares it with threshold value so that " unhealthy data " can be removed and accurate and effective load forecasting can be ensured

    本文利用統計學的方法,求出某段時間內負荷序列中的均值與方差,再利用偏離率的計算公式計算出負荷序列中每一點的偏離率,並與閾值相比較,從而除去「不良數據」 ,為準確有效地進行負荷預測提供了保證。
分享友人