composite ion 中文意思是什麼

composite ion 解釋
混合離子
  • composite : adj 1 併合的，復合的，混成的，合成的，集成的。2 【建築】混合式的；【造船】鐵骨木殼的。3 【植物；...
  • ion : n. 【物理學】離子。 positive [negative] ion正[負]離子。
  1. Based on the result of the comparision static penetrat ion test and field vane shear test before and after the treatment of soft founda tions for a experimental section, and based on four static loading tests for two single piles and two composite foundation, behaviors of soil among piles before and after the construction of powder - spray piles and the pattern of the ch ange of the stress ratio between piles and soil are studied, a new determination met hod for bearing capacities of cement powder - spray piles and composite foundati on is proposed, and the formula for calculation of composite foundation bearing capacity are revised

    基於某試驗路段軟基處理前後靜力觸探、十字板試驗的對比測試和對兩根單樁、兩處單樁復合地基進行的4次靜載試驗，研究了樁間土性狀在施工水泥粉噴樁前後的變化和樁土應力比的變化規律，提出了根據靜載試驗確定粉噴樁及其復合地基承載力新的取值方法，並修正了復合地基承載力的計算公式。
  2. Abstract : based on the result of the comparision static penetrat ion test and field vane shear test before and after the treatment of soft founda tions for a experimental section, and based on four static loading tests for two single piles and two composite foundation, behaviors of soil among piles before and after the construction of powder - spray piles and the pattern of the ch ange of the stress ratio between piles and soil are studied, a new determination met hod for bearing capacities of cement powder - spray piles and composite foundati on is proposed, and the formula for calculation of composite foundation bearing capacity are revised

    文摘:基於某試驗路段軟基處理前後靜力觸探、十字板試驗的對比測試和對兩根單樁、兩處單樁復合地基進行的4次靜載試驗，研究了樁間土性狀在施工水泥粉噴樁前後的變化和樁土應力比的變化規律，提出了根據靜載試驗確定粉噴樁及其復合地基承載力新的取值方法，並修正了復合地基承載力的計算公式。
  3. In this paper, we reported the structural and luminescent properties of si - based oxide films containing semiconductor si, ge or metal al powders prepared by a dual - ion - beam co - sputtering method ( si - sio2 films and al - si - sio2 films ) or rf magnetron sputtering technique ( ge - sio2 films ), and analyze the pl and el mechanism. 1. the composite films of si - sio2 films were prepared by dual ion beam co - sputtering method from a composite target in argon atmosphere

    我們利用雙離子束共濺射和射頻磁控共濺射技術制備了一系列含有半導體si 、 ge顆粒及金屬顆粒al的薄膜，即si - sio _ 2薄膜、 ge - sio _ 2薄膜和al - si - sio _ 2薄膜，分別對它們的結構、光吸收以及發光性質進行了研究。
  4. As predicted theoretically, the ps polymer spreaded over the surface of the titania particles to form composite particles with core - shell structure. the influence of ph value and non - ion surfactant in heterocoagulation was discussed. the property of the coated particles was characterized by sem, and zeta potential, particle size distribution of the particles before and after encapsulation was obtained by laser particle size analyzer

    根據機械力化學的原理，採用自行制備的微米級ps和pmma （聚甲基丙稀酸甲酯）高聚物微球、金屬粒子、納米級的tio _ 2 、爐料為原料粒子，通過採用自行研製的乾式沖擊設備和lg攪拌磨製得以高聚物微球、金屬粒子為核，納米tio _ 2 、碳黑粒子等為包覆粒子的具有不同特殊功能的納米微米復合粒子。
  5. ( 1 ) first, metallizing abs plastics surface by chemical coarsing, metal ion absorption, metal ion reducing and chemical copper - plating. then, the copper - coating was thickened by electroplating in order to improve adhesion between following - coating and plastics matrix, and nickel was preplating. finally, ni - sic composite was plated

    （ 1 ）通過反復實驗，確定工藝流程：首先通過粗化、敏化、活化和化學鍍銅，使塑料表面金屬化，再電鍍銅加厚銅鍍層，增強后續鍍層與塑料基體的結合力，然後預鍍鎳，最後電鍍ni ? sic復合鍍層。
  6. Tribological properties of molybdenum ion - plated and ion - surfurized composite coating on mild steel

    鋼表面鉬沉積及滲硫復合改性層的摩擦學性能
  7. ( 5 ) cdse nano - wire arrays / aam composite, cdse nano - wire arrays and cdse nano - wire were prepared by template - electro - deposition in seleneous acid ( hasech ) solution and selenosulfite ion ( sesoa2 " ) solution. then the image, composition and structure of those products were investigated by sem, tem, eds, xps and x - ray diffraction ( xrd )

    （ 5 ）分別以hzseo3和seso32一為硒源，用模板一電沉積法在納米孔陣列aam模板中制備出cdse納米線陣列/ aam復合物，然後溶解掉納米孔陣列aam ，寧} ） ij得了cdse納米線陣列和cdse納米線。
  8. With the rapid progress of materials science, petroleum coke shows unique value in producing advanced materials, including high surface area activated carbon, nanometer sized carbide, advanced composite materials, electrorheological fluids, and electrodes for lithium ion batteries

    在快速發展的材料科學中，石油焦作為碳源材料顯示出獨特的作用，可以用來制備包括高比表面積活性炭、納米碳化物材料、先進復合材料、電流變材料和鋰離子電池負極材料等在內的新材料。
  9. This is to say, pu composite hollow fiber membranes pore size can become large with transmembrane pressure increasing, and can recover completely with transmembrane pressure reverting to original pressure at a specification condition. from the hagen - poiseuille equal ion, pu composite hollow fiber membrane pore radius magnification was calculated. in our experiment, the variation of membrane pore radius attained to much six times larger than the primitive membrane pore radius

    根據一般非變形膜的純水通量一壓力差的直線關系，首次提出了孔徑變化分離膜的純水通量一壓力差的曲線關系，並根據hagenf公式，理論上計算出了幾種pu復合中空纖維膜最大變形時的膜孔徑為原始膜孔徑的倍數，最小膜孔徑變化也達到原始孔徑的一倍多，最大膜孔徑變化達到原始孔徑的六倍多。
  10. Composite materials prepared by phenol resin coating on natural flake graphite and their use and performance as carbon anode materials in lithium ion secondary batteries

    酚醛樹脂包覆石墨作為鋰離子二次電池炭負極材料的研究
  11. Section 2 involves the preparation of the composite matrix and its derivation to function as ion exchangers

    第二部分主要敘述纖維素-鈦白粉復合擴張床基質和吸附劑的制備方法。
  12. Carbon materials with disordered carbon / graphite composite structure, produced from synthetic graphite coated with large molecule polymer and pyrolyzed at high temperature, are investigated as anodes for lithium ion batteries

    與國內外同類產品的比較結果表明，本研究的mcmb具有優異的充放電性能和循環穩定性，是一種較為理想的鋰離子電池負極材料。
  13. The composite films comprising europium - containing lanthanide polyoxometalates all exhibited the characteristic red light emissions of eu3 + ion and the emission intensity increased with the number of bilayers. the films made up of keggin - type [ a - siw12o40 ] 4 - polyanion and polyaniline had conductivities with a magnitude of 10 - 3 s cm - 1

    含銪多金屬氧酸鹽-聚電解質無機-有機復合膜在室溫下均顯示出eu ~ （ 3 + ）離子的特徵紅光發射，而且發射峰強度隨雙層數的增加而增長。
  14. Study on the tin - based composite oxide as anode materials for lithium ion batteries

    錫基復合氧化物負極材料的研究
  15. The analytic results of the effects on the micromorphological structure of the film by the electrochemical condition ' s showed that the carbon is apt to improve the boundary combination between the scfs and the surface of the cathode and the seperation of the films, and that the micromorphological structure of the mpgcfs is greatly affected by the dring and the power voltage, which remarkably affluence ion move in swelling cathode film, and that higher temperature and concentration of cu2 + in the medium solution are also advanagable to the deposition of cu in scfs. the plot of deformation behavior of mpgcfs showed that the maximum strench ratio decreases and the brittleness increases due to the existence of the metal phase, and that the strengh trend of the composite films is fistly up and down followed with the content of metal phase because of the change of the role of the metal phase from acting as the physical cross - linking to weakening the films due to destroying the whole structure of the polymer

    另外它作為基體的另一個突出的優點是制備的溶脹復合膜（ scf ）中的溶劑與電解液中的溶劑相同都是水，克服了以前膜內外不同溶劑之間擴散的問題，結果使得電流最終趨於一種穩態，因此可以更好實現用電化學條件來控制mpgcf的形態結構；硬質石墨材料的多孔的結構和石墨本身的結構性能特點使得碳作為陰極材料時有利於溶漲復合膜（ scf ）與電極表面的結合以及膜的剝離，因此是作為陰極的理想材料；電化學條件中的乾燥程度和電壓能夠明顯的影響離子在膜內的遷移，從而對mpgcf的形態結構造成較大的影響；而提高反應溫度和增大電解液中銅離子的濃度也有利於銅在膜中的沉積生長。
分享友人
分享到 Line

分享到臉書