epoxy content 中文意思是什麼

epoxy content 解釋
環氧基含量
  • epoxy : adj. 環氧的。n. 【化學】環氧樹脂。
  • content : n 1 容積，容量，含量，【數學】容度；收容量。2 【哲學】內容 （opp form）；要旨，真意。3 〈pl 〉內...
  1. Reacted with excessive epichlorohydrin and dipped in 2. 5 - 3. 0 m naoh solution, the content of epoxy groups in activated cell - ti was found to be up to 220 mol / ml. this content resulted in a high anion exchange capacity of 0. 2 mmol cl - / ml

    當naoh溶液濃度為2 . 5 3 . 0mol l且環氧氯丙烷相對過量時，活化基質中的環氧基含量達220 mol ml ，由此產生的陰離子吸附劑的離子交換容量為0 . 20mmolcl ~ - ml 。
  2. Plastics - epoxy resins - determination of chlorine content - part 2 : easily saponifiable chlorine iso 21627 - 2 : 2002 ; german version en iso 21627 - 2 : 2003

    塑料.環氧樹脂.氯含量的測定.第2部分:易皂化的氯
  3. Test methods for total chlorine content of epoxy resins

    環氧樹脂中總氯量的試驗方法
  4. This paper investigates the em properties of carbonyl - iron / epoxy ds, including measuring and calculating the em parameters of the ds, the influence of matrix, particles content and thickness on absorbing properties

    本文對羰基鐵粉環氧顆粒分散體系的電磁性能進行研究，包括體系的等效電磁參數的測量和計算，體系基體、顆粒含量、厚度等對吸波性能的影響等。
  5. Based on impedance theory of em wave transmitting in medium, we calculate the reflection of single - layer carbonyl - iron / epoxy ds and discuss the influence of matrix type, carbonyl - iron content and thickness on absorbing properties

    此外，根據電磁波在介質中傳輸的阻抗理論計算了單層羰基鐵粉分散體系的反射率，並考慮了不同基體、羰基鐵粉含量及體系厚度對反射率的影響。
  6. Standard test method for resin solids content of carbon fiber - epoxy prepreg

    碳纖維環氧樹脂預浸漬中樹脂固定含量的標準測試方法
  7. Evaluation of glass fiber / epoxy prepreg, aramiel fiber / epoxy prepreg and glass fiber / phenolic prepreg quality during storage was made using physicochemical analysis methods. the relation between reactive groups content in resin matrix and exposure temperature and time was studied. the changes of the mechanical properties of the composites made by the prepregs at different stages of the storage were shown

    研究了玻璃纖維環氧樹脂預浸料、芳綸纖維環氧樹脂預浸料以及玻璃纖維酚醛樹脂預浸料在儲存條件下，樹脂基體活性基團含量與儲存溫度、儲存時間的關系及對復合材料力學性能的影響，取得了預浸料體系的質量控制參數。
  8. Standard test method for epoxy content of epoxy resins

    環氧樹脂中環氧含量的標準試驗方法
  9. Solid epoxy resin with the low epoxy value is better than liquid epoxy resin to the magnetic performance, and the content is 2 % wt will do good to improve the magnetic characteristics of the bonded ndfeb magnet

    粘結劑選用固態環氧樹脂（ e - 12 ）且在ndfeb粘結磁體中的含量為2 3為最好。
  10. The results showed that the modification made interlaminar space of the montmorillonite greater, the addition of organic montmorillonite clay improved the mechanics properties of epoxy matrix, and when its content was 1 %, the mechanics properties of epoxy resin, such as flexural strength and impact strength, would obtain the biggest enhancement

    結果表明，改性使蒙脫土層間距增大，有機蒙脫土的加入改善了環氧樹脂基體的力學性能，當有機蒙脫土質量含量為1 %時，其彎曲強度、沖擊強度等力學性能得到了最大的提高。
  11. Plastics - epoxy resins - determination of chlorine content - easily saponifiable chlorine

    塑料.環氧樹脂.氯含量測定.易皂化氯
  12. Plastics - epoxy resins - determination of chlorine content - part 2 : easily saponifiable chlorine

    塑料.環氧樹脂.氯含量的測定.第2部分:易皂化氯
  13. Standard test methods for hydrolyzable chloride content of liquid epoxy resins

    液體環氧樹脂中水解氯含量的標準試驗方法
  14. The dependences of the magnetostriction of epoxy bonded smfe2 composites on binder content, model pressure and sample size were determined. the magnetostriction of samples is the maximum when the binder content is in a range of 4 % - 6 %, and it increases with increasing the model pressure from 16 mpa to 62 mpa

    當粘結劑與磁粉的質量比在4 ： 100到6 ： 100之間，粘結smfe _ 2具有最佳的磁致伸縮性能；當模壓壓力小於62mpa時，隨著壓力的增大粘結smfe _ 2合金的磁致伸縮增大。
  15. For exfoliated epoxy / clay nanocomposites, its mechanical properties were optimal when the content of the clay was about 2wt %

    在剝離型環氧/粘土納米復合材料中，當粘土含量為2 3wt時復合材料性能最好。
分享友人
分享到 Line

分享到臉書