fillers 中文意思是什麼

fillers 解釋
填充劑
  1. Ptfe has many excellent properties such as : bonzer self - lubrication ^ low fricatiom chemistry stabilization and thermal stabilization, but its wear resistance is very low to improve the wear resistance of ptfe a lot of researches have been down by means of adding fillers to it, there are still less report on nano - inorganic filler filled ptfe composites to change properties. in this paper, experimental study was made to question above problem

    Ptfe具有優異的自潤滑、低摩擦、化學穩定性和熱穩定性,但耐磨性較差,因而人們在利用不同種類的填料對ptfe進行填充改性,提高耐磨性方面作了大量研究工作,但在使用納米無機填料填充改性ptfe方面研究很少,因此本課題主要探討這一方面的問題。
  2. Different sizes of cartons, protective fillers and bubble wraps are available. the service counter is located at check - in aisle h on level 7

    這服務同時備有不同尺碼的紙箱,內層保護及泡狀包裝物料以供旅客選購。
  3. Different sizes of cartons, protective fillers and bubble wraps are available. the service counter is located at check - in aisle h on level 7 of terminal 1

    這服務同時備有不同尺碼的紙箱,內層保護及泡狀包裝物料以供旅客選購。
  4. Analysis of tobacco and tobacco products - determination of size of the fillers of cigars and cigarillos by means of sieve analysis

    煙草和煙草製品的分析.通過篩分法測定雪茄煙過濾嘴的
  5. Results showed that spatial constitution form of the fillers had important effect on the oil removal efficiency of coalescence ; and that as the collision coalescence mechanism and the wetting coalescence mechanism were coexistent and the efficiency of coalescence was enhanced remarkably

    結果表明,填料的空間構成形式對聚結除油效率有重要影響,當潤濕聚結機理和碰撞聚結機理同時存在時,聚結效率可得到大幅度地提高。
  6. Study on surface modification of calcined kaolinite diatomite composite fillers

    硅藻土復合填料表面改性研究
  7. Composition cork - expansion joint fillers - test methods

    復合軟木.膨脹連接填充料.試驗方法
  8. All fillers lowered the maximum exotherm.

    所有填料都降低放熱效應。
  9. Fillers include modifiers, extenders, plasticizer and low friction additives.

    填料包括改性劑,填充劑,增塑劑和低摩擦添加劑。
  10. We find relatively large volumes of particulate fillers being used in many composites.

    我們發現在許多復合材料中正在採用較多量的粉狀填料。
  11. The surface reactivity of many nonblack fillers generally precludes strong bonding with this type of matrix.

    許多非碳黑填料的表面反應性一般阻礙與該種基質形成牢固的粘結。
  12. The silane effect noted with some of these fillers and pigments in common thermoplastics will be described specifically.

    下面將具體敘述觀察到的硅烷在常用的熱塑料中與幾種填料和顏料的反應。
  13. Aiming at improving the lipophilic property of the conductive fillers, surface modification of conductive tio2 powders and conductive mica powders has been researched by 5 kinds of coupling agents

    摘要為了提高無機導電填料的表面親油性,選擇5種偶聯劑分別對導電二氧化鈦粉體及導電雲母粉體進行了表面改性,活化指數評定了改性效果。
  14. When incorporation content of nano - al2o3 is 20 phr, fillers show conglomeration, which reduces the ability of fillers to link the molecular chain of pa6

    因此,為了提高填充粒子與基體的結合能力,有效的降低材料的磨損,對填充粒子作有機化處理是必要的。
  15. The tem analysis of pa6 composites shows that optimal incorporation of nano - al2o3 into pa6 is at 10 phr of nano - al2o3, and that fillers can equably disperse in matrix

    另一方面,透射電鏡分析表明,添加量為10phr的試樣中納米a12o3粒子可以在尼龍6基體中均勻的分散。
  16. Conglomeration of fillers also easily fall off from the matrix, and all these result in wear mass loss increasing. the worn surfaces of the composites having 5 phr, 10plir, 20 phr nano - al2o3 are respectively studied by using the scanning electron microscopy ( sem )

    另外,在相同滑動條件下,隨著粒徑的增大,尼龍6 / a120 :復合材料的磨損量上升,納米級粒子填充的復合材料較微米粒子填充的復合材料耐磨性能要好。
  17. Standard specification for preformed sponge rubber cork and recycled pvc expansion joint fillers for concrete paving and structural construction

    混凝土鋪面和結構建築用預制微孔橡膠軟木和可回收的pvc膨脹接縫填料的標準規范
  18. Several kinds of fillers, i. e., phenol - formaldehyde, alkyd, polyester, polyurethane and poly - vinyl - acetate, were tried to coat surface of wheat straw board ( wsb ) in this paper

    摘要對麥?人造板表面分別試驗了酚醛樹脂、醇酸樹脂、聚酯樹脂、聚氨酯、聚醋酸乙烯酯膩子,塗刮膩子后再噴塗丙烯酸漆,並測定漆膜附著力。
  19. Automotive paints are a mixture of ingredients including resins, binders, fillers, additives, and carrying agents ( typically solvents, sometimes water )

    車漆是樹脂、黏合物、加重劑等成分的組合(典型的說,是溶液,有時候是水) 。
  20. We select polyethelyne as fundamental resin, natural scale graphite, expanded graphite by self - made, expanded graphite as conductive fillers to synthesize conductive composite through different techniques of compound mixing. the effects of the conductive composites of different conductive fillers and the different dosage of conductive fillers, different technology and the different dosage of compatibilizer ( mah grafted pe ) were studied respectively

    本論文就是據于這種思考,選用聚乙烯為基體樹脂,天然鱗片石墨、膨脹石墨、膨化石墨為導電填料,通過選用不同的混合方法合成復合導電材料。研究了不同的導電填料及其用量、不同的工藝方法及相容劑的不同用量對復合體系性能的影響。
分享友人