heat constant 中文意思是什麼

heat constant 解釋
熱力常數
  • heat : n 1 熱;熱力;熱度;熱量。2 體溫;發燒。3 (氣候的)高溫,暑氣。4 【冶金】熔煉的爐次;裝爐量;一...
  • constant : adj 1 恆定不變的,固定的,穩定的,恆久的;繼續不斷的。2 不屈不撓的,堅韌的。3 忠實的,有節操的。n...
  1. Using this method to dispose interference of output signal of sensing elements, the interference caused by fixed position heat source of constant and adagio variable temperature can be effectively eliminated in exterior

    用這種方法對敏感元件的輸出信號進行處理可以十分有效地消除位置固定(或移動速度很慢)的熱源所產生的干擾。
  2. Phenolic foam is a new generation heat preservation prevent fire soundproof material and polystyrene together ammonia ester foaming rubber etc, material to compare, and it is good that its biggest characteristics is a heat - proofound the low temperature contractility is smatt, and have te special prevent burning wit the size stability under 2000 heat, not burning, not melt not contract constant form not poisonous spirit hove no thick smoke, just surface formation layer

    信息內容:酚醛泡沫為新一代保溫防火隔音材料與聚苯乙烯聚氨脂發泡橡膠比,其最大特點是耐熱性好,低溫收縮性小,具有獨特的阻燃和尺寸穩定性,在焊槍火焰下,不燃燒不收縮不變形,無毒氣無濃煙,只是表面炭化,性質穩定,耐化學腐蝕抗老化。
  3. Fanned by a constant updraught of ventilation between the kitchen and the chimneyflue, ignition was communicated from the faggots of precombustible fuel to polyhedral masses of bituminous coal, containing in compressed mineral form the foliated fossilised decidua of primeval forests which had in turn derived their vegetative existence from the sun, primal source of heat radiant, transmitted through omnipresent luminiferous diathermanous ether

    自廚房至煙囪的孔道,不斷地向上通風,灼熱的火被它煽得從成束的易燃柴禾延燒到多面體煙煤堆上。這種煤炭含有原始森林的落葉堆積后凝縮而成的礦物狀化石森林之發育生長靠的是熱輻射性源-太陽,而熱又是由那普遍存在傳光並透熱的能媒33傳導的。
  4. Specific heat capacity at constant pressure

    定壓比熱容量
  5. Presents the steady - state programming with constant coolant average temperature and constant live steam pressure, an ideal programming for marine nuclear power plant ( npp ), under which, both the coolant average temperature and the live steam pressure of nuclear steam supply system ( nsss ) are constant when the steady state operating condition is varied, and points out that in comparison with the steadysate programming with constant coolant average temperature, the ideal programming can improve the overall operating performance of npp effectively, especially in low - load range, for instance, raise the heat efficiency of npp, decrease the operating noise of main coolant pump, and improve the conditions of design, operation and control of the secondary loop system

    雙恆定運行方案是船用壓水堆核動力裝置的理想運行方案.在這種運行方案下,當裝置穩態功率變化時,冷卻劑平均溫度與蒸汽壓都保持不變,與通常採用的冷卻劑平均溫度恆定運行方案相比,有效地改善了核動力裝置的總體運行性能,特別是在低負荷運行時,可以提高裝置經濟性、降低主泵運行噪聲、改善二迴路系統的設計、運行和控制條件,這對于提高船用核動力裝置的運行可靠性和安全性具有實際意義
  6. Having reacted with copper, paa becomes complex. the complex decomposes after heat treating and cause the increase in dielectric constant and reduction in dielectric breakdown strength. otherwise cu2o and cuo emerge from the complex, too

    N與cu反應后,形成絡合物,熱處理時自身降解,擊穿強度降低,介電常數提高; cz在熱處理后從絡合物離解出來形成cllo和cuzo 。
  7. Was established in 1996, grows fast as the development of the econnomy, we mainly research, develop and produce plastics, metal dustless coating macbine, transmission equipment, cprintedilk production line and all kinds of nonstandard industrial equipments, such as automatic constant temperature and constant humidity uv ray solidified production line, we also provide automatic electrostaric cleaning system and reciprocator, and piastic of coating cine mobile phone, camera, pda, dvd. stereos coating line, single or double core - strained powder - recycling system, full stainless steeled spraying. overflowing pre - treatmentsystem, gas or oil combustion machine, electric heat drying stove, workshop cleaing, air supplier cleaning equipment etc

    其中包括恆溫恆濕及全自動uv光固化生產線;全自動靜電除塵設備系統及往返系統;手面、相機、掌上電腦、 dvd 、多媒體音箱等塑膠外殼塗裝生產線『單、雙回收濾芯式粉體系統;全不銹鋼噴淋式、游浸式前外理;燃氣、燃油、電熱風烘乾爐;凈化車間、凈化供風設備等。
  8. 4 ) in a pre - swirl rotator - stator cavities with discrete pre - swirl nozzles and blade - cooling entry holes, the influences of pre - swirl angle and flow parameter on the flow and heat transfer characteristics were numerically investigated. the correlation for average nusselt number vs rotating reynold number or non - dimensional mass flowrate were established. the results show that : advantage of per - swirl inflow is the effect of cooling the blade - cooling entry holes ; pre - swirl inflow increases heat transfer in rotating disk of pre - swirl chamber ; as pre - swirl angle increases, local nusselt number decreases in pre - swirl chamber ; the temperature of stator of inner rotator - stator chamber and per - swirl chamber decreases as rotating reynold number increases ; when the axial mass flowrate maintains constant, heat transfer in the rotating disk of inner rotator - stator cavities does n ' t change as per - swirl mass flowrate increases, while heat transfer in the rotating disk of per - swirl chamber increases ; when the pre - swirl mass flowrate maintains constant, change of the axial mass flowrate has effect on the whole cavity

    結果表明,預旋進氣的優點在於增強了葉片冷卻孔附近的對流換熱效果,局部努謝爾數隨預旋角的增大而有所減小;隨旋轉雷諾數的增加,不論是內轉靜腔室還是預旋腔室的靜盤上的溫度都不同程度的降低:當軸向中心進氣質量流量不變時,隨預旋進氣的質量流量增加,內轉靜腔室的轉盤盤面上的換熱基本沒有變化,而預旋腔室的轉盤盤面上的換熱效果增強;當預旋進氣質量流量不變時,軸向中心進氣的質量流量的改變對整個盤腔都有影響。
  9. Wet and dry numerical simulation tests for explosive cyclone over western pacific were performed. by contrast the results show that : tropopause and constant temperature surface were raised by latent heat release in upper level and disturbance trough was produced because air flow ascended and became cold. owing to this process adaption, inertial instability emergenced

    對氣旋強烈爆發的過程進行干濕對比數值模擬試驗,得出:潛熱釋放使對流層項和等溫面抬高,氣流在高層的上升冷卻形成擾動槽,其適應過程使高層出現慣性不穩定。
  10. Ceramic fuel cells are electrochemical devices that directly convert fuels such as gasified coal or natural gas into electricity without the limitation of the carnot cycle ( an ideal thermodynamic cycle in which heat is taken onto a working fluid at a constant upper temperature and rejected at a constant lower temperature )

    陶瓷燃料電池是一種電氣化學裝置,能直接將煤氣、天然氣等燃料直接轉化為電能而不會受到卡諾循環(一種理想的熱力循環,熱量在恆定高溫下轉化成工作流體,在恆定低溫下被釋放)的限制。
  11. Abstract : determined the power - time curves of the promoter bacteria of ganoderma lucidum for e. coli, using 2277 thermal activity moniter, a new experimental model of promoter bacteria growth were established. the growth rate constant and heat output at different concentration of ganoderma lucidum have been calculated. from - c and q - c curves the optimum concentration has also been established

    文摘:用熱活性檢測儀測定了天然藥物靈芝對大腸桿菌起促菌作用的熱功率-時間曲線,並根據曲線建立了細菌生長的新的實驗模型,按新模型計算了促菌作用下的生長速率常數,發熱量及最佳促菌濃度。
  12. Molar heat capacity at constant pressure

    恆壓摩爾熱容
  13. Specific heat capacity at constant volume

    定容比熱容量
  14. Molar heat capacity at constant volume

    恆容摩爾熱容
  15. The extra heat energy required to expand a gas against a constant pressure.

    恆壓下需要額外熱能才能使氣體膨脹。
  16. The electric heat components and heated components in resistor furnace were regarded as research object, the simplified model was provided on the basis of simplification of studied objects, the thermotechnical theoretical calculation and analysis for it were done by utilizing radiation heat transfer theory, some main factors influencing the temperature of electric heat component were obtained on condition that the hot load for the heated component be constant, thermotechnical engineering scheme by which the service life for resistor component could be prolonged, was raised

    摘要以電阻爐中的電熱元件和被加熱元件為研究對象,經過簡化提出簡化模型,運用輻射換熱理論對其進行了熱工方面的理論計算和分析,在被加熱元件熱負荷一定的情況下,得出了影響電熱元件溫度的幾大要點,提出了延長電熱元件使用壽命的熱工技術方案。
  17. 2. nonlinear source term identification problem about a quasilinear parabolic heat equation is investigated. for the given function determined, the existence and the uniqueness of the solution of the state equation are proved and the dependence of the solution of the state equation on the identification parameter is discussed ; then the identifiability is verified ; through choosing suitable basic functions, the above identification problem can be transformed into a constant coefficients identification problem ; and an practical iterative algorithm for solving the identification problem is presented, the feasibility and validity of the algorithm is verified by the numerical experiments

    2 、研究一擬線性拋物型熱傳導方程非線性未知源項的識別問題;對于給定識別函數,論證了狀態方程解的存在惟一性、方程解與識別函數的依賴關系和可識別性;通過選取適當的基函數,把對非線性源項的識別轉化成常系數識別問題;給出了實現非線性源項識別的迭代演算法,通過數值實驗證明了演算法的有效性。
  18. The association chain implied is general reactivity, delocalization, heat of reaction, activation energy, velocity constant.

    和該量有牽連的因素是一般活性,離域作用,反應熱,活化能,速度常數。
  19. Besides, practical load of the ghes varies with time. the variable load of ghes is decomposed as a series of pulse load, and the superimposition principle is employed to obtain the real temperature response of the ghes on basis of the theoretical solutions of a single borehole experiencing a constant heat flux

    利用把具有摘要, . . . . . . . . . . . . . . .復雜邊界條件和熱源的問題分解為許多較簡單的問題的方法,把具有多個鉆孔的地熱換熱器溫度場化作許多單孔溫度場的益加,建立了多鉆孔地熱換熱器溫度場亞加模型。
  20. The equipment made by us of titanium, stainless steel, aluminum or plastics, mainly include column condenser ( heat exchanger ) ; coil hear exchanger ; membrane evaporator ; constant boil tower ; reactor ; pressure filter, storage tank ; blower, centrifuge and ta series corrosion - resist titanium pump, as well as variety of metal constructional member. they are widely applied in the industries of petrochmical engineering, smelt, pharmacy, chlorinate alkali, salt preparation, as well as electric chemical plant

    我廠生產鈦材,不銹鋼等各種材質的化工設備,主要有風機,離心機,鈦泵,鈦閥,列管式冷凝器(換熱器) ;盤管式換熱器;薄膜蒸發器;塔器;反應器;貯存容器;面向石油化工,冶煉,制藥,氯堿,制鹽食品,造紙,環保等化學工業領域及電化行業。
分享友人