heat exchange section 中文意思是什麼

heat exchange section 解釋
熱交換段
  • heat : n 1 熱；熱力；熱度；熱量。2 體溫；發燒。3 （氣候的）高溫，暑氣。4 【冶金】熔煉的爐次；裝爐量；一...
  • exchange : vt 1 （以某物與另一物）交換，調換 （for） 2 互換，交流，交易。3 兌換。 vi 1 兌換 （for） 2 交換；...
  • section : n 1 （外科、解剖的）切斷；切割；切開。2 【外科】切片，【金相】磨石。3 （果子的）瓣。4 【數學】截...
  1. Slow cooling section is next the fast cooling section, cooling tiles slowly by exchange heat between hot gas in the tunnel and the environment air, which is sucked into pipes stick in the tunnel and been heated there, and been sent to dryer to dry biscuits

    緩冷段不直接打冷卻風，它通過抽熱風機將環境空氣吸入，進入窯內導熱良好的鋼管，並將換熱后的熱空氣送入乾燥窯內，冷空氣在換熱過程中，使製品得到間接的冷卻，讓製品安全度過573的晶型轉換階段。
  2. The optimum inclination angle is between 15 ~ 20, the length of thermosyphon will not change the phase - change heat transfer coefficient of the evaporation section and the condensation, which will enlarge heat transfer area of thermosyphon and increase the heat exchange capacity. the head - on speed of wind only stranger the heat transfer of the evaporation section and the condensation section. the experiment shows that the mathematic model closely fits to the thermosyphon, moreover, the one key to resolve the thermosyphon effect lies in decreasing the thermoresistance of evaporating section and condensation section. this study can provide directions and experience in the future research

    傾斜角越大，熱虹吸管總熱阻越大，最佳傾角在15 20之間;充液率過多或過少都會對傳熱性能產生不利影響，對于本實驗採用的1 . 75m 、 2m 、 2 . 5m 、 3m熱虹吸管，最佳充液率在20 % 35 %之間;管長對傳熱也有影響，管長不改變熱虹吸管蒸發段和冷凝段的換熱系數，只增加了熱虹吸管的換熱面積，增大換熱量;迎面風速的大小，起到強化熱虹吸管蒸發段和冷凝段換熱的目的。
分享友人
分享到 Line

分享到臉書