initial vapour pressure 中文意思是什麼
initial vapour pressure
解釋
初始蒸汽壓-
The paper is on how to set up lab platform of vapour spewing to uppercooling water surface to coagulate directly and to observe and analyse which vapour coagulate on the water surface, the results enable people to know the security system of nuclear power. the range of the pressure parameters of prz is from 0. 2mpa to 0. 6mpa, and the range of the initial temperature parameters of cmt is from 23. 5 to 78. 5, all of the testing points are 30 and there are fifty thousand testing data. many results of vapour spewing to uppercooling water surface vertically to coagulate can get. for example : coagulating can make the water of cmt surge forcefully when vapour spews to uppercooling water surface, too many vapour - bubbles come into being and strike the water of cmt owing to rupture continually, all these will strengthen the surge because of the vapour pressure of cmt
實驗中prz飽和蒸汽壓力變化范圍為: 0 . 2mpa - 0 . 6mpa ， cmt中水初始溫度變化范圍: 23 . 5 - 78 . 5 ，實驗中測試工況30個左右，實驗測試數據50萬余個，得出了很多與非能動安全系統相關的蒸汽垂直噴向過冷水表面凝結時的結論：蒸汽垂直噴入過冷水表面凝結時會造成cmt中液面的強烈波動和振蕩，產生大量蒸汽汽泡，汽泡不斷破裂對cmt中液體帶來很大沖擊，勢必引起cmt中液體的振蕩，造成cmt汽空間汽壓不均勻，加強cmt液體的振蕩和波動。 -
There will be a hot water layer in the water of cmt when vapour spews to uppercooling water surface vertically and coagulates directly. the higher of the vapour pressure of prz and the initial water temperature of cmt are, the deeper the hot water layer is. and obtaining the experience formula of the hot water layer is as follows : the condensation coefficient is high when vapour coagulate at first, then it will lessen with the process of coagulation, the higher of the vapour pressure of prz and the initial water temperature of cmt are, the higher of condensation coefficient is
蒸汽垂直噴入過冷水表面凝結時， cmt中水有明顯熱分層現象， prz中飽和蒸汽壓力越高， cmt中水初始溫度越高，熱分層厚度越大，熱分層厚度的經驗關聯式為：凝結剛開始時，凝結換熱系數非常大， ，隨著凝結的進行，凝結換熱系數越來越小， prz中飽和蒸汽壓力越高， cmt中水初始溫度越高，凝結換熱系數越大。
分享友人