measured pressure distribution 中文意思是什麼

measured pressure distribution 解釋
實際壓力分佈
  • measured : adj. 1. 量過的,合標準的;適度的。 2. 慎重的,仔細想[考慮]過的(話等)。3. 整齊的(步調等)。adv. -ly
  • pressure : n 1 壓;按;擠;榨。2 【物理學】壓力,壓強;大氣壓力;電壓。3 精神壓力,政治[經濟、輿論等]壓力。4...
  • distribution : n 1 分配,分發,配給;分配裝置[系統];配給品;配給量;【經濟學】配給方法,配給過程;分紅;【法律...
  1. In this thesis hydraulic experimental studies and theoretical analyses on the vortex - flow drop shaft were conduced and the following results were accomplished : ( 1 ) in the model test some hydraulic characteristics including the shape of air core in the center of the drop shaft, the radial distribution of water flow velocity and the distribution of pressure on the wall of the drop shaft were measured under the condition of high water head above 250m and large discharge above 1400m3 / s. ( 2 ) a kind of computational method for the spiral water flow in the air core region of drop shaft was discussed and applied and the results agree the experimental data well. ( 3 ) the total ratio of energy dissipation in the drop shaft can reach 90 % and the energy dissipation in every region was discussed quantitatively

    本文通過試驗研究與理論分析對旋流式豎井泄洪洞應用於高水頭、大泄流量情況時存在的一些水力學問題進行了研究和探討,取得以下主要成果:一、結合小灣工程導流洞改建,對高水頭( 252m ) 、大泄流量( 1400m ~ 3 s )條件下旋流式豎井中的水流運動特徵進行了比較全面的測量,包括空腔形態、徑向流速分佈及井壁壓強等;二、提出了豎井空腔段螺旋水流水力計算方法,其計算結果與實測值吻合良好;三、利用試驗與計算結果,對旋流式豎井的消能機理進行了探討,對豎井各部分的消能能力有了總體認識;四、對豎井下部消力井的合理井深進行了優化試驗研究,發現消力井合理深度為0 . 9d左右;五、通過試驗研究,歸納出豎井水流總摻氣量估算方法,為導流洞排氣方案的設計提供了參考依據;六、在高水頭、大流量條件下,豎井空腔段下部流速很高,盡管水流螺旋運動引起的離心力可以確保井壁壓強保持正壓,但空化數依然較低,因此豎井的空化空蝕始終是工程界關注的重大問題。
  2. The principle, method and procedure for adjusting loop flow distribution by measured network data ( pressure and flow of feature node ) in the hydraulic calculation of city gas network are introduced, and the cause of errors occurring when using this method is analyzed

    摘要介紹了城市燃氣管網水力計算中利用實測管網數據(特徵節點的壓力和流量)調整環流量分配的原理、方法和步驟,分析了該方法出現偏差的原因。
  3. Radial distribution of the static pressure at stator surface was measured in a rotor - stator disk cavity with centric inflow and two outflows

    摘要中心進氣具有兩個出口的旋轉盤系統中靜盤表面沿半徑方向的靜壓分佈由實驗方法獲得。
  4. In the experiment, the infrared radiation and axial distribution of wall temperature and near wall flow pressure were measured with and without film cooling

    得到了各冷卻方案噴管的壁面壓力分佈、壁溫分佈和紅外輻射特性。
  5. In this paper, based on the navier - stokes equation and the k - turbulent model, the numerical simulation of the 3d turbulent flow in a centrifugal impeller, of which specific speed is 93. the distribution of the velocity and pressure in the blade - to - blade passage are presented at the design and off - design operating conditions. the simulation results were verifiable with the results measured by piv

    本文基於n ? s方程和標準的k ?雙方程紊流模型,採用商用cfx - tascflow計算軟體對一離心泵葉輪模型進行了葉輪內部三維紊流數值模擬,得到了三個典型工況下、從輪轂到前蓋板每一個斷面上的速度和壓力分佈。
  6. L. the experiment measured the flow field of pump inlet by seven - hole cone probes under two kinds of flux, and gained pressure and speed distribution in this field, then obtained the rule of vortex field distribution

    採用七孔測針對兩種流量下泵入口流場進行了測量,得出了流場的壓力和速度分佈,在此基礎上,擬合出了渦量場分佈規律。 2
  7. At the time of image processing, both size and shape of defects may be analyzed and measured according to the sound pressure distribution of focusing probe. and essence of the defects can be judged

    在處理圖像時,通過對聚焦換能器聲場中聲壓分佈的特性分析獲得了缺陷的尺寸和形狀,由此判定缺陷的性質,實現了對缺陷的定性和定量研究。
分享友人