refining temperature 中文意思是什麼

refining temperature 解釋
澄清溫度
  1. But the temperature difference at the vertical direction in combustion chamber in lead column, that is said by operator, is over 60 ?. ( 2 ) according to the experiences in the practice, the second layer air and the second layer gas had a little effect of support burning, and the third air has little effect for combustion, and the power to drawing exhaust gas can only be adjusted in limited range. the problems, it is said above, restricted more advance of some kinds of technology and economy target in spelter refining in new jersey furnace

    由於鋅精餾爐產量提高,一些問題開始暴露出來: ( 1 )燃燒室?舶要求溫度差不超過10 ,而從現場反映的情況來看,燃燒室上、中、下部溫度差已超過60 ; ( 2 )在生產實踐中,發現燃燒室第二層空氣、第二層煤氣作用甚小,第三層空氣失去助燃作用,廢氣出口的抽力可調范圍有限;以上這些問題在客觀上制約了精餾塔在鋅精煉中各項技術經濟指標的進一步提高。
  2. Using the opened thermosiphon of 38x3 as experimental element and water as working fluid, the characteristics of dynamic low load boiling, stable severe boiling heat transfer coefficient and critical heat flux are gotten for the opened thermosiphon at the pressure of 0. 02 - 0. 1mpa and 0. 1 - 0. 8mpa respectively, which makes up the drawback that the opened thermisiphon has not yet accurate boiling heat transfer relationship formulas. by means of experimental results, an opened thermisiphon waste heat recovery boiler is designed for the high temperature gases that the positi e electrode copper refining furnace exhaust, which overcomes effectively the drawback of short life, little capacity and unable to inspect that the closed steel - water thermosion has

    本文以工程上常用的38 3的開口封底為實驗元件,以水為工質,對開啟式熱管內的動態低負荷沸騰、穩態旺盛沸騰及臨界沸騰特性進行系統的可視化實驗研究,實驗壓力為0 . 02 0 . 8mpa ,實驗得出了38 3的開口封底管在工作壓力為0 . 02 0 . 8mpa和0 . 1 0 . 8mpa下的管內沸騰傳熱系數及臨界熱負荷計算關聯式,彌補了開口封底管? ?這一新型傳熱元件尚無準確的沸騰換熱關聯式的缺陷。
  3. The result of research will resolve the problems due to increasing output, save energy, and prolong the service life of refining furnace, so a better base is built for the automatic measuring and control of temperature in pb column. keywords zinc refining ; lead c

    這粕陽呢馱割翻澆室內鐳愜8爾市與燃減冰頒俱勁嗆理,解決了因產量提高而暴露出來慚系列問題,將為瑚敘孰分j淺搞g , 36 lug 、 liffi !
  4. And the report has passed the analysis to ionic membrane caustic soda salt refining handicraft, has suggested that controlling a scheme comparatively rationally, calculation and driving force having carried out the ability choosing a type, circulating to the regulating valve on various appearance ( the temperature, pressure, rate of flow, liquid place, component ) supply a problem waiting for aspect to have done one by one also expound

    本報告通過對離子膜燒堿一次鹽水精製工藝的分析,提出了較為合理的控制方案,並對各種儀表(溫度、壓力、流量、液位、成分)進行了選型,對調節閥流通能力計算及動力供給問題等方面也都一一作了闡述。
  5. In order to solve the problems effectively, under the auspices of 863 plan in china, the synthesis diagnosis has been carried by means of measuring and numerical imitating the combustion chamber of refining column, and some conclusions is such as : ( 1 ) through measuring the temperature and combustion in the burning chamber of the refining column, the result shows the temperature difference on the same level is more than that in height direction, and there is a few of co in bottom of burning chamber. ( 2 ) in order to ensure normal work of flue system in lead column in the course of zinc refining, theoretic calculation and measure about the flow resistance of exhaust gas are carried through. the results of study reveal that drawing out force of chimney is inadequate, which is mainly caused by illogicality of flue construction

    在研究過程中,採取了現場實測和數值模擬手段對韶關冶煉廠鋅精餾鉛塔燃燒室及排煙系統進行了綜合診斷,具體結果包括如下: ( 1 )完成鋅精餾鉛塔燃燒室內溫度測試以及燃燒狀況的測試,結果發現:鉛塔燃燒室內水平方向的煙氣溫度並非均勻,而且其溫差比上下方向的溫差更大,以及鉛塔燃燒室尾部存在co未燃燼問題; ( 2 )為了保證鉛塔煙氣系統的正常工作,對煙道系統的阻力進行了理論計算及測試分析,結果發現:鋅精餾鉛塔煙氣系統中煙囪抽力不夠,這主要是煙道結構不合理所造成的。
  6. And length is up to 150m. these types have been applied for measuring temperature of torch systemsin zhenhai refining chemical and shanghai gaoqiao petrochemical

    產品已應用在鎮海煉化,上海高橋石化等火炬系統測溫。
  7. Welded edge sheathed thermocouple is used to measure surface temperature of heat furnace pipe and smoke pipeline and widely applicable for oil refining, power generation, metallurgy, chemical fibre and food etc

    刀刃式鎧裝熱電偶是用於測量加熱爐管和煙道管表面溫度的儀表,廣泛應用於煉油電力冶金化纖食品等
  8. Widely used in the industries of petrochemical, refining, dyestuff, printing, pesticide, pharmaceutical, rare earth and fertilizers, etc., this pump is an indispensable optimal choice to handle the corrosive medium, like various non - oxidated acid ( hydrochloric acid, thin sulfuric acid, formic acid, acetic acid and butyric acid ) not containing solid particles, not easily crystallized, and temperature not over 100

    本泵主要用於石化、冶煉、染料、印染、農藥、制藥、稀土、化肥等行業,輸送不含固體顆粒,不易結晶,溫度不高於100的各種非氧化性酸(鹽酸、稀硫酸、甲酸、醋酸、丁酸)等腐蝕介質必不可少的理想設備。
  9. Widely used in the industries of chemical, petrochemical, refining, dyestuff, pesticide, pharmaceutical, rare earth and fertilizers, etc., this pump is an optimal choice to handle the corrosive medium in storage tank, like various non - oxidated acid ( hydrochloric acid, thin sulfuric acid, formic acid, acetic acid and butyric acid ) not containing solid particles, not easily crystallized, and temperature not over 100

    本泵廣泛用於化工、石化、冶煉、染料、農藥、制藥、稀土、化肥等行業,在貯罐上輸送不含懸浮固體顆粒,不易結晶,溫度不高於100的各種非氧化性酸(鹽酸、稀硫酸、甲酸、醋酸、丁酸)等腐蝕介質的最理想設備。
  10. The company is specialized in producing of mesh - belt continuous sintering furnace 、 pusher - type high temperature sintering furnace 、 steel - belt iron powder refining reduction furnace ( electric - heating rbo furnace and direct gas - burning heating rbo furnace are also produced ) 、 pressure bell type furnace 、 carburizing quench furnace and some kinds of accessorial equipments

    目前生產項目有:網帶式連續燒結爐、推桿式高溫燒結爐、蒸汽處理爐、鋼帶式鐵粉還原爐(電加熱、氣體燃燒直接加熱rbo型均生產) 、加壓鐘罩爐、滲碳淬火爐及各種輔助設備。
  11. Refining measured water content values of wet snow - correcting errors arising from air temperature in t

    秋田穀式含水率計測量值的氣溫訂正
  12. Yes, high refining temperature can form a minima trans fatty acid. but usally is below 0. 5 %

    請問反式脂肪酸是如何形成的?所有的精煉油都有反式脂肪酸嗎
  13. High temperature corrosion problems are reviewed for chemical, petrochemical, petroleum refining, fossil energy, gas turbine and waste incineration industries

    摘要本文針對有關化學、石化、石油精煉、燃煤、渦輪引擎葉片及焚化爐等工業應用環境上,遭遇之高溫腐蝕問題作一回顧。
  14. Prediction model for temperature drop of steel in cas - ob refining with powder injection

    噴粉精煉溫降預測模型
  15. Following the development of catalytic cracking technology and the increase of refining temperature, this factory cooperates with china petrochemical ( beijing ) design institute to develop a series of refractories with high intensity, good insulation ability and small reheating linear change and good wearproof ability, whose physical and chemical property reaches or surpasses the level of the foreign product of the same kind

    催化裂化在煉油裝置中地位舉足輕重,近年來公司為適應催化、裂化技術的不斷發展,設計研製了一系列強度高、隔熱性能好、重燒線變化小、耐磨性能高的煉油裝置用隔熱耐磨襯里,產品理化性能國內領先,甚至達到或超過國外同類產品的指標。
  16. Fabricators of pressure vessel using alloy, carbon steel and high temperature alloy using in petrochemical and refining industries

    合金使用?力容器製作者、炭素鋼及高溫合金石油化學製品及精?業使用。
  17. Wear - proof and high temperature thermocouple and thermowell on oil refining catalytic device

    煉油催化裝置高溫耐磨熱電偶及套管
  18. 5 wear - proof and high temperature thermocouple and thermowell on oil refining catalytic device

    5煉油催化裝置高溫耐磨熱電偶及套管
  19. Connected with the program construction, the group will try its best to development new finishing technology, import advanced equipment such as digital printing, hi - temperature and hi - pressure refining, exert advanced technology such as connection lot dyeing, computer color matching, smooth and clean silk dyeing and quaclrochramatic printing, and make efforts to transfer our products to the first class

    結合項目建設,公司將全力發展新型印染后整理技術,引進數碼印花、高溫高壓精煉等先進設備,運用公司連缸染色計算機測配色、真絲綢無灰傷染色及四分色印花等先進技術,努力實現公司產品朝中、高檔產品的轉型。
分享友人