側架立柱 的英文怎麼說
中文拼音 [zhāijiàlìzhù]
側架立柱
英文
side frame column-
The main causes, which have effects on redistribution of internal force in the prestressed frame, including the relative height compressive zone of section, secondary moment and types of load applying are taken into account. the horizontal braces force which results from the tension of the prestressing steel, reduces the pre - compress stress is analyzed
並且探討了各影響因素對框架梁截面延性的影響和由於柱的抗側剛度在預應力鋼筋張拉時約束梁的軸向變形，從而影響預應力在梁中的建立所造成的梁中軸向預壓力的損失。Sizes of specimens are the same as those in practical engineering project. the lipped channel section is used as wall studs and its space is 500 millimeter. the wall sheathings are screwed on cold - formed steel studs, with 12mm gypsum board on one side and 9 mm oriented strand board ( osb ) on another side
試件的立柱骨架為間距為500mm的c型卷邊槽鋼，兩側墻面板分別是12mm厚的石膏板和9mm厚的osb定向刨花板，墻面板與立柱骨架用自鉆自攻螺釘連接。C ompared the results of structural period, displacement and internal forces of mode 1 with mode 3, we can know that the hypo - frame can increase the lateral stiffness of the mega steel - frame structures, decrease lateral - deformation of the structures, especially decrease the maximum inter - storey displacement obviously, and get the internal forces and deformation of the whole structure more uniform. from the analysis results, it can be found that the maximum axial force gets less with hypo - frame than without it, and the maximum shear force and bending moment get more with hypo - frame than without it. thus it can be seen that the mainframe can be an independent structure system by itself, but the cooperation of main and hypo frame should be considered for conducting the entire analysis and design, otherwise the mega structure can be unsafe, in addition, from the comparing analysis, it can be found that the shear force and bending moment of inside - row columns are increased much more than those of outside - row ones in a mega column
通過3個算例方案1和方案3結構周期、位移和內力反應的比較分析可知，次框架可以進一步增加巨型鋼框架結構的抗側剛度，減少結構側向變形，特別是明顯減少了結構最大層間位移，使整個結構的內力與變形分佈更為均勻；次框架的加入使主框架柱最大軸力較無次框架情況減少，而主框架柱的最大剪力和彎矩較無次框架情況都有所增加，由此可知，雖然主框架本身可以成為獨立的結構體系，但在分析設計時，還應該考慮主、次框架協同工作，進行整體分析、整體設計，否則結構會偏於不安全。
分享友人