合凸凹針 的英文怎麼說

中文拼音 [āozhēn]
合凸凹針 英文
dimple pin
  • : 合量詞(容量單位) ge, a unit of dry measure for grain (=1 decilitre)
  • : Ⅰ動詞(高出) bulge; protrude Ⅱ形容詞(高於周圍) protruding; raised
  • : 凹名詞(凹陷的地方, 用於地名) low-lying area; depression (used in place names)
  • : Ⅰ名詞1 (縫衣物用的工具) needle 2 (細長像針的東西) needle like things 3 (針劑) injection; sh...
  1. Referring to three kinds of plan irregularity, structures individually with four kinds of irregularity as eccentricity in one direction, eccentricities in two directions, re - entrant corner irregularity and diaphragm discontinuity have been analyzed to investigate the relationship between torsion effects and parameters of above irregular structures. the parameters and the schemes for determining the scope of structures with different kind of irregularity considering seismic action in two directions simultaneously are proposed, some conclusions have been get as following : it is indicated by the analysis results that torsion effect has no dependency relation with eccentric torsional angel adopted in code for seismic design for buildings. it is suggested that the eccentric torsional angel should not be take as the parameter of torsion effect of structures considering seismic action in two directions simultaneously ; for the structures with regular plan and elevation and with eccentricity in one direction due to irregular mass layout, the relative eccentricity can be take as the parameter of torsion effect of structures considering seismic action in two directions simultaneously ; for the structures with regular plan and elevation and with eccentricities in two directions due to irregular mass layout, the ratio of relative eccentricities in two directions and the angel of them can be take as the parameters of torsion effect of structures considering seismic action in two directions simultaneously ; it is indicated by the analysis results that the torsion effect has no dependency relation with re - entrant corner ratio adopted in code for seismic design for buildings as

    所取得的主要結論有:結構的扭轉效應與《抗震規范》所採用的扭轉不規則指標即偏心扭轉角之間的相關性較差,偏心扭轉角不宜作為判斷結構是否計及扭轉效應及需考慮雙向水平地震作用的界定指標;對于樓層間均勻偏心的多層單向偏心結構,建議採用相對偏心距作為需考慮雙向水平地震作用的界定指標,並給出對不同平面尺寸的界限相對偏心距;對于樓層間均勻偏心的多層雙向偏心結構,建議採用兩個主軸方向的相對偏心距及其夾角作為界定指標,結單向偏心結構的界定方案進行需考慮雙向水平地震作用的結構范圍界定;不規則結構的扭轉效應與比例無正相關關系, 《抗震規范》要求所有平面布置不對稱的不規則結構計及扭轉效應的規定欠妥當,建議不規則界限值從30改為15 ,只要求分析採用空間模型比較適; 《抗震規范》關于有效樓板寬度較小的結構需計及扭轉效應的規定很有必要,樓板局部不連續的結構需採用符樓板實際剛度的計算模型予以分析,可使用相對偏心距(及其夾角)參照單向(和雙向)偏心結構的界定方案,界定樓板局部不連續結構是否需要計入雙向水平地震作用下的扭轉效應。
  2. In addition, in consideration of the non - convex and non - concave nature of the combinational optimization sub - problem, the branch and bound technique is adopted to obtain or approximate the global optimal solution

    對組優化子問題的非性,採用分支定界法,以求得或接近全局最優解。
分享友人