報廢率 的英文怎麼說

中文拼音 [bàofèilǜ]
報廢率 英文
condemnation factor
  • 報 : Ⅰ動詞1 （告知; 報告） report; declare; announce 2 （回答） reply; respond; reciprocate 3 （答謝）...
  • 廢 : Ⅰ動詞（不再使用; 不再繼續） abandon; abolish; abrogate; discard; give up Ⅱ形容詞1 （沒用的; 失去...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 報廢 : announce invalidated check in paper; be declared worthless; discard as useless; dumping; scrap; r...
  1. This paper put forward a set of management method of equipment and technique in petroleum enterprise, such as equipment ' s evaluation in quantities, equipment ' s proper usage, equipment ' s maintenance and technical reform, equipment ' s status monitoring and diagnosing, em methods under hse management system, etc. this paper also put forward a series of economic management methods, such as the management of equipment depreciation fund, the management of equipment maintenance fee, equipment ' s activation, equipment ' s occupation for value, equipment ' s rental, management of abandoned equipment. the purpose of the author is trying to offer some valuable advice for promoting the scientific em in petroleum enterprise, organizing the equipment operation in the proper way, optimizing the equipment ' s readjustment and improving the equipment ' s intact rate and utilizing rate

    本著理論聯系實際的原則，採用模糊評價法、綜合分析法建立了石油專用設備投資評價體系及效益跟蹤考評方法；提出了一套石油企業設備技術管理的科學方法：設備量化評價考核、設備的合理使用、設備的維修與技術改造、設備的狀態監測與故障診斷技術的應用、 hse管理體系下的設備管理等方法；在經濟管理方面提出了設備折舊資金的管理、設備維修費用的管理、設備的盤活、有償佔用、租賃、設備的報廢管理等管理方法，為推進石油企業設備管理的科學化，組織好設備的運營，優化設備合理調配，提高設備完好率、利用率提供有效的參考建議。
  2. At the initial stage of planar technique, b was employed as ideal diffusion impurity in base - region of npn si planar devices because of the match of its solid - solubility and diffusion coefficient in si with those of p in emission - region, and the good shield effect of sio2 film to b. but because of the relatively large solubility ( 5 1020 / cm3 at 1000 ) and the small diffusion coefficient, the linear slowly - changed distribution of acceptor b in pn junction can not be formed, which could not cater to the requirement of high - reversal - voltage devics. thereafter b - a1 paste - layer diffusion technology and close - tube ga - diffusion technology had been developed, while the former can lead to relatively large the base - region deviation and abruptly varied region in si, which caused severe decentralization of current amplification parameter, bad thermal stability and high tr ; the latter needed the relatively difficult pack technique, with poor repeatability, high rejection ratio, and poor diffusion quality and productio n efficiency

    在平面工藝初期，由於b在硅中的固溶度、擴散系數與n型發射區的磷相匹配， sio _ 2對其又有良好的掩蔽作用，早被選為npn硅平面器件的理想基區擴散源，但b在硅中的固溶度大（ 1000時達到5 10 ~ （ 20 ） ，擴散系數小， b在硅中的雜質分佈不易形成pn結中雜質的線性緩變分佈，導致器件不能滿足高反壓的要求，隨之又出現了硼鋁塗層擴散工藝和閉管擴鎵工藝，前者會引起較大的基區偏差，雜質在硅內存在突變區域，導致放大系數分散嚴重，下降時間t _ f值較高，熱穩定性差；後者需要難度較大的真空封管技術，工藝重復性差，報廢率高，在擴散質量、生產效率諸方面均不能令人滿意。
  3. Assists in managing workers and production quality to minimized rejections

    協助監督工人工作及生產質量，最大限度地降低報廢率
  4. Lead team to continue improvement current process, improve product quality, reduce scrap rate

    帶領團隊不斷提高現有的工藝流程，提高產品質量，降低報廢率。
  5. Monitor and control mass production products status and take actions to reduce the scrap rate and improve the process capability

    控制/監控量產的品質狀況，採取行動降低報廢率，改善製程能力。
  6. Installations for application and drying of paints and varnishes. application and combined booths. application by spraying. methods of measurement of rejects to atmosphere

    塗料和清漆的應用及乾燥設施.應用和組合間.受大氣環境影響報廢率的測量方法
  7. Among hundreds of the six sigma projects in schneider electric around the world, the project " reducing scrap ratio of c1 cells " from schneider beijing low voltage co. ltd. ( sblv ) in china, was recognized by the quality director, an important vip of schneider electric and the black belt & green belt from many countries

    在施耐德全球近百個六西格瑪項目中，來自中國施耐德北京低壓電器有限公司（ sblv ）的項目"降低c1分斷單元報廢率」被施耐德電氣質量總監、施耐德電氣管理層及來自各個國家施耐德電氣實體的黑帶、綠帶們所認可。
  8. Analyze ipo, production reports, data, include : machine efficiency, man power, material consumption, wastage percentage, various between plan and fact. make suggestions for improving production and process management

    對生產訂單、報告、數據進行分析，包括：機器效率、人工時間、物料消耗、廢品率、計劃與差異等；為改進生產和過程管理提供依據和建議。
  9. Focus on production yield rate, test yield review and monitoring ; analyze exceptional process, the reject or complain from customer, improve process to match quality request, establish rework process or claim scrap

    關注製程良率的控制，時時追蹤檢討測試站良率;對生產過程異常，不良品或客戶投訴進行分析，修改更新工藝滿足品質要求，制定返工工藝或提請報廢
  10. Mis of measuring equipment is built with the methods of object oriented to support management process of the measuring equipment from selection, purchase and reject. with the implementation of bussiness process reengineering, measuring equipment management of jigang will reach a new level such as cost reduced, efficiency improved, process simplified and scientific decision making. a scientific, normative and modern management will be realized

    論文選擇了面向對象的方法進行業務流程的信息化改造，採用計算機網路技術和分散式數據庫建立科學高效的測量設備管理信息系統，支持測量設備從選配，采購到報廢管理全過程，達到削減成本、提高效率、簡化流程、科學決策的目標，實現管理的規范化、現代化、科學化。
分享友人
分享到 Line

分享到臉書