排氣閥開 的英文怎麼說

中文拼音 [bèikāi]
排氣閥開 英文
exhaust valve open
  • : 排構詞成分。
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : 名詞1 (指在某方面有支配勢力的人物或家族) established house or power group; a powerful person or...
  • 排氣 : [機械工程] exhaust; aerofluxus; air out; exit gas; ventilate; atmosphere; vent排氣泵 exhaust pump...
  1. On top of one of the fast - opening ends that closed to the pig receiver & launcher shall assemble vent valve, safety valve and pressure gauge, and at the bottom shall assemble drain valve, sideway inlet and vent valve to take out medium from the main pipe as the power of forcing pig and conveyance medium

    靠近收發球筒快盲板一端上部應設防空、安全及壓力表、下部設、側面設進、出油(、水),以便從干管中取介質作為驅動清管器的動力及輸出介質。
  2. Air vacuuming : to turn two stop - valves of solar panel loose completely to allow air to expel from low - pressure tripe - pipe - valve of outdoor parts

    除空,要將太陽能集熱轉換器上的兩個截止完全打。從室外機組的低壓三通的加液口出空
  3. Connect vent hose loosely to test cock # 1. open valve a to vent air from vent hose, tighten vent hose at test cock # 1, open test cock # 1

    軟管鬆弛地連接到測試旋塞1號。門a從軟管處出空。緊固測試旋塞1號上的軟管,啟測試旋塞1號。
  4. Connect vent hose loosely to test cock # 1. open valve a to vent air from the vent hose. tighten vent hose at test cock # 1, open test cock # 1

    軟管鬆弛地連接到測試旋塞1號。門a從軟管處出空。緊固測試旋塞1號上的軟管,啟測試旋塞1號。
  5. Stand clear of the regulator and valve outlet, while opening the valve

    門時,躲調整器和口。
  6. Loosen the valve outlet seal slowly when preparing to connect a cylinder

    準備連接鋼瓶時,慢慢地松口密封。
  7. Conversely, by opening the bleed, line pressure will blow out any accumulation when the plug is lifted

    反過來,通過裝置,當塞升起時,管路壓力將吹出任何累積物。
  8. Taking the method of pressing - off inlet valve in partial stroke as the theory foundation, a new stepless capacity control system is developed

    本文以部分行程頂進行量調節為理論基礎,研製發了一種新型量無級調節系統,其核心部件為可調迴流
  9. Paved secondary containment, waste water collection and biological treatment systems for pollution prevention. pressurised fire water system including dual diesel driven high capacity pumps with automatic tart on demand, and monitors in all operating areas

    時,門打向火炬泄放體,火炬處設有水封、阻火器和電點火系統,蒸汽在此系統完全燃燒后達到環保要求的放標準。
  10. Valves for heating installations ; filling and evacuating taps pn 12. 5 ; dimensions, materials

    供暖設備. pn12 . 5注水和關.尺寸.材料
  11. Fini air treatment systems for industry are composed of refrigerating dryers, filters for separating impurities, condensate drain cocks, water - oil separators, tanks and all other components necessary for adapting the compressor room to your needs

    工業用的fini空處理系統由冷藏乾燥器組成,專用於壓縮機房的空壓機由濾波器分雜質,,水油分離器,罐和全部必要的其他零部件等適合你的需要。
  12. Company business scope : research, develop and assembly filler caps, flvv, roll valve, inlet check valve and related products, sale the products and provide the related services

    公司經營范圍:研究,發,生產和組裝油箱蓋,燃油放控制,加油控制和油泄漏探測器及其他相關產品,銷售本公司所生產的產品並提供相關服務。
  13. The timing - and - quantitation precision injection of lpg was realized with high - speed lpg solenoid valve and a set of electronic control system, which was designed by the author and can flexibly control the gas supply system of lpg. based on the analysis of experimental data got by comparing the performances before and after the application of the set of equipment on lr6105q12 diesel engine, the effects of load, speed and replace ratio, etc on the emissions of smoke, hc and co of dual fuel engine were expounded. through optimization, the smoke emission was utmostly reduced and the emissions of hc and co were within the government restriction

    為此,本文通過對各個方案進行詳細比較,選擇了電控多點順序噴射的供方案;利用高速lpg噴射和自己獨立發出一套電子控制系統對lpg供進行靈活地控制,實現了lpg的定時定量噴射,並把這套裝置應用到中國一拖生產的lr6105q12柴油機上,在對改裝前後的發動機進行大量試驗和分析的基礎上,闡明了負荷、轉速、摻燒比等因素對雙燃料發動機的煙度、 hc 、 co等放的影響情況,並且通過優化,最大限度地降低了發動機的煙度放,同時使hc 、 co放限制在國家標準規定的范圍之內。
  14. Air filtration portfolio, air filters, valve, oil mist machine, filter valve, oil mist separator, micro - mist separator, stability activated solenoid valve, pressure gauge, micro - valve and vacuum valves, links the release of the closure - pressure valves, and pipe connection, a one - way valve, t - shelves, shelves, brackets, diaphragm - type flow switches, blades type flow switches, further growth actuator, the valve lock, precision valve, pressure switches, mechanical pressure switches, pneumatic control ratio positioning devices, and electric - gas ratio positioning devices, and telecommunications - pressure converters, electro - pneumatic proportional valve, filter valve, shuttle valve, gas - electric relay and gas indicator, delay pneumatic valve and cylinder fcl, plumbing fcl, mufflers and exhaust cleaner, the excess flow valve with silencer, a one - way valve, rapid valve, rapid joints, rapid valve with fcl, rapid joint sub - cluster gas, micro joints, gas pipes, pipe from the devices, and helical coils, pipes, channels, scissors, multiple fastener, high - speed rotary joint, 10000 threaded joints, and insert the tube joints, rotary joints began, 68. 25 rapid joints and hoses, hose fittings and rapid non - electrostatic

    過濾組合空過濾器減壓油霧器過濾減壓油霧分離器微霧分離器穩定啟動電磁壓力表微型減壓減壓三通釋放式截流壓力關管接頭單向t型隔板隔板托架膜片型流量關漿葉型流量關增速繼動器鎖定精密減壓壓力關機械式壓力控比例定位器電-比例定位器電訊號-壓轉換器電-比例過濾減壓梭動-電繼電器源指示器動延時缸限流器管道限流器消聲器潔凈器限流帶消聲器單向止回快速快速接頭快速帶限流器快速接頭集束分微型接頭喉管喉管脫離器螺旋管管管道剪刀多管扣件高速旋轉接頭萬用螺紋接頭插入式管接頭旋式緊鎖接頭難燃性快速接頭和軟管不帶靜電快速接頭和軟管
  15. Open needle valve " a " high side and vent needle valve to vent air from bypass hose

    啟針形「 a 」高端和針形,從旁路軟管放空
  16. Move the high side hose to test cock # 4, low side to test cock # 3 and open both test cock # 3 and test cock # 4. remove vent hose from test cock # 1, open shutoff # 1

    將高端軟管移到測試旋塞4號,低端軟管移到測試旋塞3號,並啟測試旋塞3號和測試旋塞4號。從測試旋塞1號上拆卸軟管,啟關閉1號。
  17. Open the inlet water valve and press the top discharge valve to discharge the air in the filter at the same time

    進水門,同時按下頂上,使濾器內空出即可。
  18. Meanwhile, the air valves make the gleithretter of the air valve open and close automatically with the changing of gas pressure in the air cylinder to finish gas entry and exhaust automatically

    同時,隨著缸內體壓力的變化而使的滑片自動啟和關閉,所以可自動完成進的過程。
  19. Open the air - release valve of the trap beforework to discharge a large quantity of non - frozen gas. then drivetightly the air - release valve and preheat gradually. the preheatrate should not be more than 36 / minutes

    疏水在工作前需打,使不凝結體大量出,然後擰緊放,並逐漸預熱,預熱率不超過36 / 8分鐘。
  20. Pressing - off inlet valve in partial stroke is one of the methods of air - regulating for reciprocating compressor, and it has economic, safe and well - fixing character

    部分行程頂進行量調節是活塞式壓縮機量調節方法中的一種,具有經濟、可靠和安裝方便等特點。
分享友人