撓度試驗 的英文怎麼說

中文拼音 [náodùshìyàn]
撓度試驗 英文
deflection test
  • 撓 : 動詞1. （輕輕地抓） scratch 2. （擾亂;阻止） hinder 3. （彎曲,比喻屈服）yield;flinch:不屈不撓indomitable; unyielding
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 試驗 : trial; experiment; test
  1. Rubber vulcanized. determination of temperature rise and resistance to fatigue in compression flexometer testing

    硫化橡膠.用壓力撓度計試驗時對溫升和抗疲勞性能的測定
  2. Rubber, vulcanized and thermoplastic - determination of temperature rise and resistance to fatigue in flexometer testing

    硫化和熱塑橡膠.撓度計試驗中溫度上升和抗疲勞性的測定
  3. Meanwhile, according to the reduced theoretic of the open - web truss, the strength simplification computational method are proposed, and in comparison of the theoretical calculating value with the tested one and the behavior analysis of the tested beams during the process, the hypothesis and the theory of the beam are verified and the stress distribution of the circular hole castellated beam is also obtained

    通過費氏空腹桁架簡化計算理論值與實測值的對比分析以及對試驗梁在試驗過程中的性態分析，驗證了理論計算及各項假設的正確性，分析得出圓孔蜂窩梁圓孔周邊應力分佈特徵；並通過撓度分析，提出了實用的簡化計算式。
  4. Methods of test for adhesives - physical tests on hot - melt adhesives - determination of low temperature flexibility or cold crack temperature

    粘合劑試驗方法.第h2部分:熱熔粘合劑物理試驗.低溫撓性及冷爆裂溫度測定
  5. The research shows that : 1 ) the ductility of the hsc bending members constructed is much greater than 5 ; 2 ) increasing the vertical links and distribution steel can increase the deflection under ultimate moment ; 3 ) with appropriate compressive bars, vertical links and distribution steel the increase of moment after yield and the decrease of moment under ultimate moment can be ignored, so the ductility of the hsc bending member is much larger ; 3 ) the width / depth ratio of hsc bending member has no obvious effect on the ultimate compressive strain of concrete ; 4 ) the method used here to calculate the deflection is applicable ; 5 ) the location of crack coincides with the location of vertical links and distribution steel ; 6 ) the bending property of the hsc structure under the blast load can meet the demand of protective engineering

    研究表明：本文研究的梁、板構件的延性比遠大於5 ；增加箍筋（鉤筋、分佈筋）含量，可以提高壓區混凝土剝落時的撓度；在適當的受壓筋、箍筋（鉤筋、分佈筋）含量下，可以忽略壓區混凝土剝落瞬間的承載力下降，從而大大提高構件的延性；受彎構件的寬高比對壓區混凝土極限應變的影響不明顯；受彎構件的裂縫間距受箍筋（鉤筋、分佈筋）的布置影響；文中所用的承載力和變形計算方法是可行的。化爆試驗表明，高強混凝土構件的動載抗彎性能能夠滿足防護結構的要求。
  6. A load - displacement full - process analyzing program of cfrp - confined rc eccentrically loaded columns is given. the computed results of load - displacement coincide with test results

    編制荷載-撓度全過程計算程序對碳纖維布約束偏壓柱進行數值分析，程序計算曲線與試驗曲線吻合良好。
  7. The main factors including concrete cover and prestressing levels which may have influence on the fire resistance of the simply - supported slabs are examined. the deflection and prestress are presented. from the results of tests, the fire endurance of the simply - supported slabs are given

    在簡支板的火災行為試驗研究中主要考慮了普通鋼筋的保護層厚度和預應力度兩個因素，主要測試了構件的撓度變化及預應力的變化，並由此得出了其耐火極限。
  8. Study of deflection measure method on bridge load test

    橋梁荷載試驗撓度測試法研究
  9. Standard test methods for cold crushing strength and modulus of rupture of refractories

    耐火材料的冷破碎強度和撓折模量的標準試驗方法
  10. Test method for measuring warpage of ceramic tile

    測量瓷磚撓曲度的試驗方法
  11. Deflection test of diaphragms of steam turbines

    汽輪機隔板.撓度試驗方法
  12. Testing method for flexural strength modulus of rupture of fine ceramics

    精製陶瓷的撓曲強度試驗方法
  13. Testing method for flexural strength modulus of rupture of fine ceramics at elevated temperature

    高溫下精製陶瓷的撓曲強度試驗方法
  14. Rubber and plastics hoses - sub - ambiant temperature flexibility tests

    橡膠和塑料軟管.亞環境溫度撓性試驗
  15. En 538 clay roofing tiles for discontinuous laying. flexural strength test

    不連續鋪設用屋頂陶土瓦.抗撓強度試驗
  16. Standard test method for determination of slow crack growth parameters of advanced ceramics by constant stress - rate flexural testing at elevated temperatures

    高溫下用恆定應力速度撓曲試驗測定高級陶瓷的慢裂增長系數的標準試驗方法
  17. Advanced technical ceramics. monolithic ceramics. mechanical properties at room temperature. determination of subcritical crack growth parameters from constant stressing rate flexural strength tests

    高技術陶磁.整體陶磁.室溫下的機械性能.第3部分:從恆定應力率撓性強度試驗中測定亞臨界裂縫擴大參數值
  18. Test method for flexural strength of manufactured carbon and graphite articles using four - point loading at room temperature

    在室內溫度條件下利用四點加載進行碳與石墨人造物撓曲強度試驗方法
  19. Wire bending test procedure for insulation displacement contacts for electrical connectors

    電連接件的絕緣替代接頭idc的引線撓曲度試驗程序
  20. The tensile tests of rebar and bend tests of armor plates show that the produced fbgs have very good strain sensing attributes. the developed strain sensors using fbgs have good linearity, coincidence and high sensitivity

    通過鋼筋拉伸和鋼板撓曲試驗，說明所製作的光柵具有良好應變反應特性，利用光纖光柵所製作的應變傳感器具有非常好的線性、一致性及非常高的靈敏度。
分享友人
分享到 Line

分享到臉書