撓曲線平面 的英文怎麼說

中文拼音 [náoqūxiànpíngmiàn]
撓曲線平面 英文
flexural plane
  • 撓 : 動詞1. （輕輕地抓） scratch 2. （擾亂;阻止） hinder 3. （彎曲,比喻屈服）yield;flinch:不屈不撓indomitable; unyielding
  • 曲 : 曲名詞1 （一種韻文形式） qu a type of verse for singing which emerged in the southern song and ji...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 平 : Ⅰ形容詞1 （沒有高低凹凸 不頃斜） flat; level; even; smooth 2 （高度相同; 不相上下） on the same l...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 曲線 : [數學] curve; bight; bought; profile; net曲線板 french curve; irregular curve; curve board; splin...
  1. According to eigenvalue equation ( general formula ) of the energy method of the plane steel frame structure stability, and considering the restriction of the end of the column of the main steel frame and function of deflection curve gained from the differential balance equation general resolution, we get the equation for calculating the length coefficient of the main frame structure stability of the steel arch gate and the resolutions are also given

    根據平面剛架穩定性能量法特徵值方程（通式） ，考慮弧形鋼閘門主框架柱的柱端約束的特殊情況，求出撓曲線函數（試解函數）通解，得到弧形鋼閘門主框架柱穩定性計算長度系數方程。其中弧門主框架主橫梁式形框架的臨界荷載比較現行規范推薦的有限元法簡單方便、結果精確及物理概念明確等優點。
  2. In the procedure, the column is first divided into a finite number of small segments in equal length. the deflection - curvature relation of each segment is determined using the finite - difference method. the final nonlinear algebraic equations are then obtained by means of the equilibrium condition for each segment

    運用這種方法，先將長柱離散成若干等長的柱段，利用差分方法求得各柱段截面上的撓度與曲率的關系，再根據各截面上外力與抵抗力的平衡條件，得到一組關于荷載與變形關系的非線性代數方程組；本文對該方程組採用載荷增量法進行迭代求解。
  3. 4. choosing the reasonable deflection curve function. according to the energy method and the constrained condition of column end of the steel arch gate, the article presents a practical calculating formula for the stability of the main frame structure of the steel arch gate

    選擇合理的撓曲線函數（試解函數） ，根據能量法及弧門柱端約束條件，提出弧形鋼閘門主框架（平面鋼框架）穩定性計算的實用解析計算公式，並根據影響弧門主框架穩定性的因素對該公式進行修正。
  4. At first, the experiment carried out by tianjin university has been analysed according to the " nonlinear balance trying calculation " method, and the values of yield load and ultimate load agree with the test result better, and the curve of bending moment - curvature, bending moment - deflection can agree with the results. the second, the simplified formula for evaluation the ultimate flexural capacity of cfrp strengthened rc members is presented according to the three probable failure modes ( compression failure ; cfrp rupture ; crushing of the concrete in compression before yielding of the reinforcing steel ). it is applicable to both singly and doubly reinforced rectangular sections, as well as flanged sections

    首先利用鋼筋混凝土非線性平衡試演算法對天津大學試驗進行了理論分析，所得分析值與試驗結果相比，加固梁的屈服荷載、極限荷載能夠很好地吻合，彎矩曲率關系曲線及彎矩撓度關系曲線較為吻合；其次，為了滿足實際工程的需要，根據碳纖維布加固構件可能發生的三種破壞形態（壓區混凝土壓碎破壞、碳纖維布拉斷破壞以及受拉鋼筋尚未屈服時壓區混凝土已壓碎破壞） ，區別三種鋼筋混凝土構件截面形式（單筋矩形截面、雙筋矩形截面、 t形截面） ，分別給出了碳纖維布加固混凝土構件抗彎承載力的簡化計算公式和適用條件，並進一步探討了這三種截面形式下進行加固設計和復核的步驟。
  5. The progress of this method can be divided into two steps. one is found the relations of the moment, compression force and the curvature on the base of the balance of the internal force. the other step is to found the relation of the flexibility, corner and the curvature through the elemental deformation curve

    該方法的計算過程可分為兩大步驟：第一步根據截面內力平衡條件建立彎矩、壓力和曲率之間的關系；第二步根據構件的變形曲線建立撓度、轉角和曲率之間的關系。
分享友人
分享到 Line

分享到臉書