有效橫截面 的英文怎麼說

中文拼音 [yǒuxiàohéngjiémiàn]
有效橫截面 英文
effective cross section
  • : 有副詞[書面語] (表示整數之外再加零數): 30 有 5 thirty-five; 10 有 5年 fifteen years
  • : Ⅰ名詞(效果; 功用) effect; efficiency; result Ⅱ動詞1 (仿效) imitate; follow the example of 2 ...
  • : 橫形容詞1. (蠻橫; 兇暴) harsh and unreasonable; perverse 2. (不吉利的; 意外的) unexpected
  • : Ⅰ名詞1 (頭的前部; 臉) face 2 (物體的表面) surface; top 3 (外露的一層或正面) outside; the ri...
  • 有效 : effective; valid; efficacious
  1. The cyclo - hoop effect which steel tubular has exert to the concrete shows the character of heterogeneous in the arch rib section, the same to the axial direction. the paper verifies the change of the material poisson ration and the concrete grade will make the cyclo - hoop effect obvious alteration, the change of the cyclo - hoop effect and the stress redistribution of the section produced by the shrinking and creeping of the concrete and the expensive concrete on the section

    在鋼管混凝土拱肋斷上,鋼管對內填混凝土的環箍應具非均勻性,在拱軸方向上環箍應也呈現非均勻性。驗證了材料的向變形系數、混凝土標號等參數的變化將引起環箍應的明顯改變;混凝土的收縮、徐變和膨脹混凝土的應用導致鋼管混凝土的環箍應發生變化並使的應力發生重分佈;並總結了其變化的基本規律。
  2. Because the cross - section of the oversized rib waveguide we fabricated by wet - etching was trapeziform, we analyzed the transmission of oversized rib waveguide by combining effective refractive - index method. the influence of some factors on the optical transmission loss, such as material structure, the height of rib waveguide, and the thickness and refractive index of waveguide layer and up - layer of polymer material, was analyzed

    因為濕法腐蝕工藝製作的反脊波導是梯形狀的,因此論文中採用了一種簡單的方法,即折射率法,對梯形反脊波導的光傳輸損耗特性進行了分析,同時考慮金屬電極產生熱場對脊波導傳播特性的影響。
  3. Based upon virtual displacement method and the updated - lagrangian approach, stiffness matrices for two - dimensional elastic - plastic beam model in large displacement were proposed, in the derivation of which transverse stress was included because it was believed that part of the 2nd order effects of various stresses, which are in equilibrium with each other and with the external loads, will counteract each other and neglecting either part would possibly lead to incorrect results

    利用虛位移原理和更新的拉格朗日方法,導出了大位移彈塑性梁單元剛度矩陣的顯式表達式,在剛度矩陣推導中引入了內非線性剪應力和向應力的影響,剛度矩陣通過了剛體檢驗。之所以要引入向應力的影響,是因為本文認為,保持平衡所需的所應力,它們各自的二階應會相互抵消,因此忽略其中的任何一項都可能導致不正確的結果。
  4. Modeling the general solid web continuous box girder and opening - in - web ( open web ) continuous box girder by ansys finite element modeling tool, node stress of governing section and corresponding shear lag values are analyzed. the solution is validated by comparing with variational results and modeling test values. based on the model, the section shear lag induced by dead load, prestress tendons and car loads under the most unfavorable condition and lateral symmetry are also approached. the influence of shear lag effect in double - level continuous box girder is considered with opening - in - web and the web location. the analysis indicates that double - level - load arouses less shear lag effect than one - level - load. when self - weight and prestressed tendons act on together, the shear lag effect on box girder take on a evidently change

    基於所建立的限元模型,本文分別對實腹和腹板開孔兩種箱梁在恆載、車載、預應力荷載作用時,各主要的剪力滯應進行分析,通過施加縱向最不利的和向對稱的車輛荷載,研究實腹連續箱梁和空腹連續箱梁在承受雙層荷載和單層荷載時引起的剪力滯應,並考慮腹板開孔及開孔位置對于連續箱梁剪力滯應的影響。分析表明,雙層車載對于箱梁引起的剪力滯系數比單層車載的影響要小,對于箱梁中存在引起的剪力滯后現象一定的改善作用。
  5. The contents include : based on the previous research and the data of experimentations, the author researches and develops a kind of satisfactory semi - empirical formula of nonlinear temperature distribution, and calculates the temperature stress of rigid - framed arch bridge by the fem. the temperature effects of bridge structure by annual and sunlight temperature difference are discussed, it indicates that the temperature effect of annual temperature difference is small but the temperature effect of sunlight temperature difference is great and the temperature stress along beam depth resulted from sunlight temperature difference is nonlinear. with the comparison between the temperature effects of different position of bridge, the results show that where the section of bridge is small, the temperature stress of it is large

    本文主要包括以下內容:從理論上研究並結合實測資料發展了一種比較理想的半經驗溫度場非線性分佈公式,並將限元方法應用於剛架拱橋結構溫度應力的計算中,對橋梁結構進行整體溫度應力分析;討論了年溫差和日照溫差引起的橋梁結構的溫度應,表明年溫差引起的溫度應較小,而日照溫差引起的溫度應力較大且沿梁高呈非線性分佈;分析比較了橋梁結構各個部位的溫度應的大小,可知越小溫度拉應力越大,受力越不利;並對箱梁結構由於構造不同引起的縱向與向的溫度應大小進行了探討,發現在頂板下緣也會出現相當大的溫度拉應力,並且梗腋的存在反而增加了頂板底部的溫度拉應力;還對幾種相近的剛構式橋型的溫度應進行了分析對比,總結了這些橋型針對溫度應的優劣,並提出相應的針對性措施。
  6. The transverse expansion origins in early stages, but mainly develops and finishes during the late stage of the colliding. for those heavier particles, such as j /, e, and etc., becuase of their smaller hadronic cross section, they rarely participate the final state hadronic re - scattering, and depart the system much earlier. their transverse expansion maybe is the result of the cumulative collective effect during the early partonic stage

    這種向擴張起源於碰撞的初始階段,但是主要是在碰撞的後期完成,而一些重的粒子,如j 、和,由於具較小的強子散射,幾乎不參與末態強子的再散射,較早的離開碰撞系統,它們所表現出來的向擴張運動可能是來自碰撞初期部分子階段的部分子的集體應的累積結果。
  7. The feeder has a small cross - section, compact structure, and the advantage of high transmission efficiency, but also under some pressure in transmission materials, and no jet

    該喂料器具小、結構緊湊且輸送率高的優點,並能在一定壓力下進行輸送,物料不反噴。
  8. The effective stiffness are compared with the ones by nozaki for n = 4. numerical results show that the nature of the imperfect interface has significant effect on stiffness of a convex polygon - shaped fibers composites

    並以正四邊形纖維作為算例,將所得模量與nozaki結果比較,數值結果表明界的非完美性質對凸多邊形纖維增強復合材料的性能明顯影響。
  9. Finally, the mori - tanaka estimate is used to evaluate the effective moduli of polygon - shaped fibers composites having slightly weakened interface

    最後,採用mori - tanaka理論計算非完美界條件下纖維增強復合材料的模量,其中纖維的為凸多邊形。
  10. The software of analysis method of multi - armed caliper log imaging has been developed, and the on - site applied results show that the software can get the casing maximum drift diameter and effective drift diameter and simultaneously give the caliper hoop extension graph and cross section graph in arbitrary depth which can diagnose the sort and degree of casing deformation

    摘要研製了多臂井徑成像測井解釋方法軟體,現場應用結果表明:運行該軟體可以解釋得到套管最大通徑、通徑;同時給出任意深度井徑周向展開圖、圖,進而可判斷套變的種類和程度。
  11. Water cross section

    有效橫截面
  12. The paper concerns about the beams with consideration of residual stress under loading combined antisymmetric end moments with transverse uniformly distributed load, that formula for the linearly distributed moment used in gb50017 - 2003 should be modified for the nonlinearly distributed moment, and kirby, p. a & nethercot, d. a only suggested an empirical formula. therefore, it is of theoretical and practical value to investigate it

    對于本文所研究的既端彎矩又向均布荷載作用且考慮殘余應力的梁,由於其沿梁長方向的彎矩是非線性分佈的,上述公式適用性待進一步研究加以修正。而英國人kirby , p . a和nethercot , d . a .也只給出了彎矩非線性分佈梁的等彎矩系數經驗公式。
  13. Effective cross section

    有效橫截面
  14. The algorithm is applied to the fiber binary image and its efficiency and availability are proved

    實驗結果表明,該方法應用在纖維二值圖像處理中簡單、快速、實用的果。
分享友人