有限伸長 的英文怎麼說

中文拼音 [yǒuxiànshēnzhǎng]
有限伸長 英文
finite extension
  • 有 : 有副詞[書面語] （表示整數之外再加零數）: 30 有 5 thirty-five; 10 有 5年 fifteen years
  • 限 : Ⅰ名詞（指定的范圍; 限度） limit; bounds Ⅱ動詞（指定范圍, 不許超過） set a limit; limit; restrict
  • 伸 : Ⅰ動詞（展開） stretch; extend Ⅱ名詞（姓氏） a surname
  • 長 : 長Ⅰ形容詞1 （年紀較大） older; elder; senior 2 （排行最大） eldest; oldest Ⅱ名詞（領導人） chief;...
  • 有限 : limited; restricted; finite; a little; not much
  • 伸長 : prolongation; extension; elongation; extend; elongate
  1. Both of forward and back bearings have been integrated into one box to make full use of the length of base frame that the motor formerly mounted on, and short the shaft extended lengths in both end with the strengthening connection between bearing housing and screw thread of base

    將前後兩支承設計為一個整體軸承座，充分利用原電動機安裝底座的有效長度，最大限度地縮短了軸的懸伸量，提高了軸承座與底座的螺紋聯接強度。
  2. Theoretical models were used to predict the effects of microcrack - density to effective tensile modulus of cf / ep laminates for long - term duration exposure for it difficult to get from tests. a uniaxial zero - expansion model was established based on the analysis of thermal stress and the coefficient of thermal expansion of the laminates

    由於受到試驗周期的限制，對于長期暴露于空間環境中的層合板材料，其有效拉伸模量很難用試驗方法直接測量，本文採用理論模型進行分析。
  3. Finite difference time - domain method is used to calculate the reflection for these probes and absorbing boundary condition is used to deal with the singularity in the axis of the coaxial - line in the simulation. by comparing the reflection of different probes, the best probe has been selected according to sensitive requirement. the influence of parameters : such as thickness of protective film, length of protruding inner conductor of the coaxial - line probe to the measurement has been studied

    通過時域有限差分法進行數值模擬分析，並採用吸收邊界處理同軸線軸心奇異點，計算出各種探頭測量相同溶液的反射系數，根據其測量的靈敏度，選出最優設計；並通過分析所選探頭的各種設計參數，如薄膜厚度、內導體伸出長度等的變化對測量結果的影響，找出該探頭各參數的最佳范圍，使其具有高度靈敏性，以適用於測量化學反應溶液的介電常數。
  4. Formulas of inversion and cosine transform spectrum of gravity anomaly of sphere, infinite horizontal cylinder, infinite and finite stretched staircase were deduced

    推導出球體、無限長水平圓柱體、無限和有限延伸垂直臺階的重力異常餘弦變換譜及反演表達式。
  5. The cosine transform spectrum of sphere are about the same as that of infinite horizontal cylinder, and that of infinite stretched staircase are very sharp, but that of finite stretched staircase presents well - regulated leap

    球體與無限長水平圓柱體的餘弦變換譜相似，無限延伸垂直臺階的變化很尖銳，有限臺階的表現為上、下有規律的跳躍。
  6. Influence of soil body behind the abutment stress distribution and stress carry - over length due to different coefficient of friction is analysised, through the experimental results and the space finite element analysis results of the model, actual measurement results tally with the computing results well. ( 4 ) new type semi - integral abutment bridge is from optimization design of conventional abutment bridge - dashuiting middle bridge. not only bridge at both ends

    分析了不同摩阻系數對臺後土體應力分佈和應力傳遞長度的影響，並對試驗結果和有限元分析進行了對比，實測結果和計算結果吻合良好; （ 4 ）將有縫橋-大水町中橋優化設計為新型半整體式無縫橋，橋梁兩端均不設伸縮縫，路面也不設任何接縫。
  7. This paper, in allusion to damage of expansion joint of bridge, introduces a sort of new structure of jointless device - semi - integral abutment jointless bridge, and establishes model of general structure finite element of this bridge, and in details analyses its qualities of stress. the model considers the interaction of superstructure - substructure - soil. resistance of the soil behind abutment adopts still soil pressure and elastic resistance when the temperature rising, but active soil pressure when dropping. analysis of qualities stress of bridge includes of action of dead load, car load, temperature load of season character. taking an 100m length pc semi - integral abutment jointless bridge as instance, the paper establishes the model of plane frame by applying large common software - anasys, and analyses it by elastane and large deformation to imitate character of stress and deformation of general bridge. at the same time corresponding models of finite element of joint bridge and integral abutment bridge are established, and unique stress and performance of structure of semi - integral abutment jointless bridge are researched by comparing and analysing character of three different models under same loading, and controlling factor of design and constitution are generalized. in conclusion, for semi - integral abutment jointless bridge, on one hand shear, moment and deflection of the main beam and axis force of substructure are approximate with that of joint bridge, and integral stifmess of structure is increased and damage of expansion joint is eliminated, on the other hand there is axis force in main beam, shear and moment of substructure are bigger than that of joint bridge. in all this type of jointless bridge has rational stress and is worth of application and popularization

    半整體式橋臺無縫橋梁計算模型考慮了上部結構-下部結構-土的共同作用；臺後土抗力升溫時採用靜止土壓力加彈性土抗力，降溫時採用主動土壓力；分析橋梁受力性能時考慮了結構自重、車輛荷載和季節性溫變荷載的作用。以一座橋長100mpc半整體式橋臺無縫橋梁為實例，採用大型通用軟體ansys建立平面框架模型，進行彈性、大變形分析，模擬全橋受力和變形特點；同時建立與此對應的有伸縮縫橋梁和整體式橋臺無縫橋梁有限元模型，通過三種橋型同步加載對比分析，研究半整體式橋臺無縫橋梁獨特的受力特點和結構性能，總結其設計控制因素和構造要求。通過本文研究知：半整體式橋臺無縫橋梁主梁的剪力、彎矩、撓度和下部結構的軸力與梁式橋相近，結構整體剛度增大，併除去了伸縮縫病害；但主梁增加了軸力，下部結構剪力、彎矩較梁式橋大；綜合分析是一種受力合理有實踐和推廣價值的橋型。
  8. Firstly, the domestic researches, which have been reported, are introduced. then the characteristic of the system in estimation of prestressing losses is analyzed by theoretical method, and the reasons that the elimination of tendon is large and test results are not consistent are pointed. using fem software ansys, anchorage zone of pylon are analyzed

    論文首先介紹了國內現階段對該問題的一些研究成果，然後從理論上分析了小半徑大噸位環向預應力體系在計算預應力損失方面的特點和造成張拉伸長量偏大且實測的數據離散性較大的原因，並採用國際權威的有限元分析軟體? ? ansys從理論上進行分析和索塔錨固區最不利節段的足尺寸模型試驗進行校驗。
  9. To generalize the eccentricity ratio effect on ultimate tensile strength of ductile plates, the elesto - plastic finite element method is undertaken and a mathematical transition expression of normalized ultimate tensile strength of center - cracked, eccentrically cracked, edge - cracked plates is accordingly deduced

    對于偏心裂紋延性板，採用彈塑性有限元進行了大量的組合計算，分析了相對裂紋長度、材料屈強比和裂紋偏心度對板的拉伸極限強度的影響，並給出了方便計算的回歸公式。
  10. We analyes post - tensioned prestressing properties and comparing with practiced results. we analyse one - way precast slab sandwich negative moment section resistant crack properties and two - way precast slabs sandwich under plane resistant crack at unprestressed section and second - prestressing propties. we compare canceling bonded reinforcement with laying on bonded reinforcement resistant crack properties and deformation. auxiliary lab include : concrete resistant pollution intensity. concrete resistant compressing intensity and elastic modulus, compare with results of code. analyse sandwich ' s strain and long - time stress, strain and introduce a new method through theory calculating long - time stress and strain

    配套的試驗研究有：混凝土的抗拉強度和彈性模量試驗及混凝土的抗壓強度和彈性模量試驗，混凝土的極限抗拉強度和極限拉伸應變試驗，並與《混凝土結構規范》 （ gb50010 - 2002 ） ，結果進行了對比；單塊夾層板放張階段的彈性應力、應變分析和長期應力、應變分析，並詳細介紹了按混凝土徐變理論進行長期應力、應變分析的方法。
  11. Products and systems for the protection and repair of concrete structures - test methods - adhesion and elongation capacity of injection products with limited ductility

    混凝土結構的防護和修理用產品和系統.試驗方法.測定有限延展性的噴射產品的粘結性和伸長能力
分享友人
分享到 Line

分享到臉書