極限抗剪應力 的英文怎麼說

中文拼音 [jíxiànkàngjiǎnyīnglì]
極限抗剪應力 英文
ultimate shear stress
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 限 : Ⅰ名詞（指定的范圍; 限度） limit; bounds Ⅱ動詞（指定范圍, 不許超過） set a limit; limit; restrict
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 剪 : Ⅰ名詞1 （剪刀） scissors; shears; clippers2 （姓氏） a surname Ⅱ動詞1 （用剪刀等使細的或薄片的東...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 極限 : 1 （最高的限度） the limit; the maximum; the ultimate limit; limitation; extremity; tipping point...
  1. On the basis of investigations into the progressive yield process and the possible failure modes of rcc gravity dams, the quasi - elasticity design limit state of the ctrtical stability criterion is proposed and the real working state of the dams designed according to the ctriterion is discussed. a check formula using the material strength reducing factor as the safety index and a simplified formula similar to against sliding stability fromula are derived. finally, the corresponding design safety factors are given by using fem calculations with various influence parameters to be taken into account

    本文在研究碾壓混凝土重力壩漸進破壞過程和可能失穩方式的基礎上，提出了以準彈性臨界作為穩定臨界準則的設計極限狀態，分析了按該準則設計的大壩的實際工作狀態，導出了以準彈性強度儲備系數為設計安全指標的審查公式以及形式與抗剪斷公式相同的簡化公式，探討了定量計算考慮各種因素影響的相應設計安全系數的合理取值，並與現行規范方法進行了比較
  2. The consequence is, when the majority of structure does n ' t enter yield habitus, but the position of belly - board has been reached the ultimate habitus, it lead to material waste of the other positions, we should pay attention to the disastrous result it will bright to us

    它帶來的後果就是當結構的大部分處于彈性狀態時，箱梁腹板處由於剪力滯效應一般最先達到強度極限狀態，導致腹板間材料的抗力沒有得到充分的使用，如不引起重視會帶來災難性後果。
  3. Based on the pseudo - static experimental results of nine abnormal joints, the damage process of abnormal joint is divided into four stages of original crack, entire crack, ultimate state and failure, the effect of axial force ratio, stirrup ratio and height of column section on seismic behavior of abnormal joint are discussed, the conclusion that anti - shear capacity of abnormal joint are studied in entire crack state by studying the minor core of abnormal joint is made, the calculating formula for anti - shear capacity of abnormal joint is proposed with a view to asymmetry in stirrup yield

    摘要根據9個鋼筋混凝土框架異型節點試件的擬靜力試驗結果，指出異型節點受力過程分為初裂、通裂、極限和破壞4個階段；討論了軸壓比、節點核芯配箍率、柱截面高度變化對異型節點抗剪性能的影響；提出應考慮節點核芯區箍筋屈服的不均勻性並在通裂狀態下以「小核芯」為分析單元來研究此類節點抗剪承載力的建議；最終給出了異型節點抗剪承載力的計算公式。
  4. On the basic of former research men ' s experience, 18 experimental members ( including 9 simple beams and 9 restrained beams ) are designed and tested. in the experiment, phenomena are observed and record by taking photos in the whole process from the first crack appears to test members crash completely, experimental data is attained including load values of crack - appear load, critical load and terminal load, stress values of reinforcing steel bar stress, compressed concrete stress and beam flank stress and values of deflection etc. by analyzing the crack ' s appearing and developing form and stress values of concrete and steel bars, the crash modes of test beams are defined ; shearing force - deflection curves are contrasted and analyzed ; the effects on shear strength of the three factors as shear span ratio, concrete strength and restraining moment are also analyzed

    借鑒已有試驗的經驗，本文設計和完成了對18根超高強混凝土無腹筋梁（包括9根簡支梁和9根約束梁）在集中荷載下抗剪強度的試驗，觀察了試件從裂縫出現到完全破壞失去承載能力全過程的試驗現象並通過拍照進行記錄，獲得了試件的斜裂縫出現荷載、臨界斜裂縫荷載和極限荷載等荷載值和縱筋應變、混凝土受壓應變和梁側混凝土應變等應變值以及撓度值等。
  5. Considering the shear strenth of unsaturated soil, the method of analysis of limit equilibrium has been approved and it can be used in the analysis of the stability of saturated - unsaturated slopes

    在考慮非飽和區土體抗剪能力的情況下，對傳統的邊坡極限平衡分析方法作了改進，使之可應用與飽和?非飽和區土體的邊坡穩定問題。
  6. Based on the experimental study of shear performance of prestressing shearwall, this paper analyses the limit of the shear performance of sheawall added the prestress, and discusses the shearing bear capacity in shear breakage

    通過對預應力剪力墻的抗剪性能試驗研究，分析施加預應力對剪力墻結構的極限抗剪能力提高程度以及在剪壓破壞形式下抗剪承載力的提高程度。
  7. From the experiments, the number and width of fracture are obviously decreased, and pasting cfrp laminates play important role in improving rc construction durability ; with anchoring, premature is prevented and the ultimate shear capacity is increased ; taking properly anchoring measure, the ultimate shear capacity of rc t - section beams of initial loads is higher than that of no initial loads ; under non - anchoring case, because the rehabilitation of rc t - section beams with cfrp laminates are destroyed suddenly, the reinforcement effect maybe decrease

    試驗結果表明，粘貼碳纖維布顯著減小了鋼筋混凝土t梁的裂縫數量和寬度，抑制了裂縫的開展，對提高普通鋼筋混凝土構件耐久性有重要作用；採用適當的錨固措施可以有效防止構件發生早期破壞，提高構件的極限抗剪能力；對于有錨固的粘貼方式，有預加載的t梁抗剪極限承載力明顯高於無預加載的t梁。試驗還表明，在無錨固的情況下，用碳纖維布作抗剪加固后的t梁破壞較突然，有可能使梁的加固效果出現負效應。
分享友人
分享到 Line

分享到臉書