次承壓水 的英文怎麼說
中文拼音 [cìchéngyāshuǐ]
次承壓水
英文
hypopiestic water-
The fault controlled the magmatism and metallization relevant to the contact zone, and deformed successively and produced cataclastic rocks and two sets of joints ; the second stage was from late cretaceous to eocene. the fault zone deformed right - laterally under ne - sw striking transtention, and new joints zone was produced at the end of the two main faults because of local stress concentration. the fault produced inchoative cataclastic rocks, and two sets of typical joints in plutons ; the third stage of deformation was relatively faint and only a little of microcracks was produced and infilled with vei ns in the deformed rocks, which was during the himalayan movement
其後的繼承性活動在斷裂帶內形成碎裂程度最強達到碎裂巖的碎裂巖系列構造巖，變形帶兩側發育兩組典型的共軛剪節理；第二次在晚白堊世?始新世，斷裂在北東?南西向近水平擠壓作用下右行張扭性活動，斷裂帶兩主斷裂在斜列重疊的端部由於局部應力集中進一步擴展形成節理帶，而斷裂在巖體區也發育兩組典型的共軛剪節理，斷裂內形成初碎裂巖為主的構造巖；第三次是喜山期以西側抬升、東側下降的強烈升降為主的活動，在基巖中，主斷層兩側圍巖出現微破裂。The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine
用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌：用xrd進行原料物相分析，及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度；用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性；用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化；用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試；採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定；用萊次偏光顯微鏡（ pm ）測試固體潤滑劑的硬度；用材料試驗機測試固體潤滑劑的抗壓強度等。Because there are several periods of tectonic movement and several tectonic zones " development and complex superposition at da gangshan hydropower staion, geological structure in dam area is great complex and water - bearing media has the characteristic if inhomogeneity, which make it difficult to further clarify the burial condition of different bearing aqueous structure and the development of ground water system at the dam area
由於大崗山水電站壩區存在多期次的構造運動以及多個構造帶的共同發育、復合疊加，使得壩區地質構造顯得錯綜復雜以及含水介質的不均一性，使得進一步闡明壩區不同承壓儲水構造埋藏條件和壩區地下水系的發育特點變得很困難。Warning : reinspection of t & p relief valve : temperature and pressure relief valves should be inspected at least once every three years by a licensed plumbing contractor or authorized inspection agency, to ensure that the product has not been affected by corrosive water conditions and to ensure that the valve and discharge line have not been altered or tampered with illegally
警告：重新檢查溫度壓力安全閥：溫度壓力安全閥每年應該由有資格證書的管道承包商或經過批準的檢查機構來至少檢查一次，以確保這種產品不會受到腐蝕性水的影響，確保閥門和排泄管道不會被不合理的更換或損壞。Then, mechanical responses of pavement structures were analyzed with elasticity theory, based on actually applied pattern of heavy loading, analysis method of ultimate bearing capacity of pavement structures was proposed, and the factors affecting ultimate bearing capacity were analyzed also, which provided a theoretical basis for the restriction of alex load
其次，根據實測荷載作用面積和計算輪胎接地壓力，計算了重荷載作用下水泥混凝土路面結構的力學響應，提出了分析混凝土路面極限承載力的方法，並分析了極限承載力的影響因素，為限載提供了理論依據。In this thesis the geological and hydrogeological conditions of the area are systematically analyzed, and, from top to bottom the primary exploitation layers are divided into five layers in order : the second confined aquifer, the second aquitard, the third confined aquifer, the third aquitard, and the forth confined aquifer
本論文在系統分析該地區水文地質條件的基礎上，將研究區主要開采層劃分為五層，由上到下依次為：第一層為第承壓含水層，第二層為第承壓弱含水層，第三層為第承壓含水層，第四層為第承壓弱含水層，第五層為第承壓含水層。The main contents are followed below : ( 1 ) for the aim of knowing the characteristics of main factory building structure frame columns of large - scale thermal power plants, nine high strength concrete frame columns with high axial compression ratio and six slender ordinary strength concrete frame columns with high axial compression ratio were tested under low reversed cyclic horizontal loading for the very first time, and thus the influencing factors of normal section bearing capacity, such as concrete intensity grade, axial compressive ratio, slendemess ratio, the type of stirrups and stirrup ratio, etc, the anti seismic deformation capability of frame columns were acquired
本文主要研究的內容有： （ 1 ）首次針對火電廠主廠房結構框架柱的特點，對9個高軸壓比高強混凝土框架柱和6個高軸壓比普通混凝土框架長柱進行了低周反復水平加載試驗，獲得混凝土等級、軸壓比、長細比、配箍形式及配筋率等對框架柱的抗彎及抗剪承載力、抗震變形能力的影響因素。分享友人