比粘合 的英文怎麼說

中文拼音 [bǐniángě]
比粘合 英文
specific adhesion
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  1. The research results show that, from the viewpoint of second phase morphologies, there exist quite differences between the grain - type materials ( such as wc / bcu brazing deposit material, wrs1000 and 1zt tungsten carbide strengthening overlaying material, as well as the wear - resistant material of polymer adhesive coating etc. ), and the aggregation - type as well as dispersion - type ones ( such as zg35simn, wrd - 1 and khc - k2 depositing material ) in the wear - resistance and sand slurry abrasion mechanism. the sand slurry abrasion mechanisms are brought forward, of new wear - resistant materials with the features of grain - type second phase morphologies

    研究發現，與聚合型、彌散型第二相的材料（如zg35simn 、 wrd ? 1和khc ? k2熔敷材料等）相比，顆粒型第二相的材料（如wc bcu釬焊熔敷耐磨材料、 wrs1000型耐磨材料、 1zt碳化鎢顆粒增強熔敷材料及ktc ? 1耐磨膠粘塗層材料等）在耐磨性能和磨損機理等方面均有不同，總結提出了以「顆粒型第二相」為特徵的耐磨新材料泥沙磨損機理。
  2. Later, a more stable aqueous suspension was obtained by using a mixture of bentonite powder in the following formula.

    后來按下列公式應用一種美粘土粉做成的混合液，才獲得一種比較穩定的水混懸液。
  3. In order to solve the above - mentioned problems, the present invention provides a method for plating a polymer material with a metal film, which can form the film on the surface of polymer materials, which are difficult to plate by the prior wet plating method, at a relatively low cost in comparison to the dry plating method and exhibits a uniform thickness and a good adhesion of the metal film and further, shows a good reproducibility

    為了解決上述問題，本發明提供了一種給聚合物材料上鍍金屬膜的方法，用該方法可以在聚合物材料表面形成膜層，這是原來的工藝難于做到的，而且比干鍍成本低，鍍層厚度均勻，金屬膜的粘附性好，最後，還顯示出好的重現性。
  4. Since hf forms only a two-dimensional polymer it is less viscous than water.

    由於HF只形成二維聚合體，所以它的粘性比水的小。
  5. The effect of reynolds number on rudder hydrodynamic performance is also analyzed. up to the stall angle the computed lift and drag agree well with measurements and other author ' s calculations, whereas stall angle, lift and drag beyond the stall angle are slightly under - predicted. the solver is used to investigate laminar and turbulent separated flows around a 6 : 1 prolate spheroid at high incidence angles and their effects on hydrodynamic forces

    應用所開發的求解器，以naca0015翼型舵為算例計算了船舵在不同雷諾武漢理三;大學博士學位論文數下大舵角范圍內的三維粘性流場及水動力，成功地預報了舵的失速角和最大升力，並初步探討了雷諾數對舵水動力的影響;計算結果與現有試驗和計算數據比較，吻合程度相當好，初步檢驗和驗證了該求解器精確模擬粘性流動和計算水動力的能力。
  6. In this paper, a high performance sma system applied to steel bridge deck is put forth in allusion to the pavement project of the wuhan junshan yangtze river highway bridge. it comprises steel slab, zn coating layer, closing layer, adhesive, pre - mixed asphalt stone and dual layer sma from bottom to top. it is based on the fea results of the forces and deformation of the pavement layer by means of the algor feas, according to this bridge ' s traffic and the ambient temperature varying range of the pavement layer

    本文針對武漢軍山長江公路大橋鋼箱梁橋面鋪裝工程，從鋪裝層環境溫度變化范圍、交通量等使用條件出發，在用algorfeas有限元分析軟體分析鋪裝層受力變形基礎上，提出了（即鋼板+金屬鋅塗層+封閉層+粘接劑+預拌瀝青碎石+雙層sma ）的高性能鋼橋面sma鋪裝體系，並對這種sma的組成材料，包括改性瀝青、集料、礦粉、纖維進行了比較研究，設計了這種sma的配合比，對sma混合料的性能進行了對比試驗，對這種sma方案進行了疲勞性能研究，驗證了所選擇sma方案的可行性。
  7. When fillings is other materials ( unprocessed montmorillonite, powder coal ash, co - composite of powder coal ash and organo - montmorillonite, co - composite ofcarbonizing calcium and organo - montmorillonite ) in the binder and content of organo - montmorillonite in the binder is five percent decided by tensile - shear experiment, tensile - shear strength of binder is up to tiptop ; at the same time, this paper carries out abrasion experiment, and, by comparison, concludes abrasion property of coating is optimum when content of organo - montmorillonite in the binder coating is five percent, and observes abrasion sample under set

    當膠粘劑中填料為其它物質（未處理蒙脫土、粉煤灰、粉煤灰和有機化蒙脫土共復合、碳化鈣和有機化蒙脫土共復合）時，通過拉伸剪切試驗確定膠粘劑中有機化蒙脫土含量為5時，膠粘劑的拉伸剪切強度最高；同時進行了沖蝕磨損試驗，通過比較得出，當膠粘劑塗層中有機化蒙脫土含量達到5時，塗層的耐沖蝕磨損性能最佳，並對沖蝕磨損試樣在掃描電子顯微鏡（ set ）上進行觀察。
  8. ( 2 ) from the equilibrium conditions of the isolated segment from a beam - column sub - assemblage, it is clarified for the first time that the bond stress along the beam rebars passing through the joint transfers into the column end to balance shear at this column end at the same ratio as that of the compression force in the compressed concrete at beam ends

    通過對樑柱組合體柱脫離體的平衡條件，首次明確了貫穿節點梁筋粘結應力和梁端受壓混凝土的壓力以相同的比例傳入柱端以平衡柱端剪力，從而對節點區的傳力機理重慶大學博士學位論文結出了完整的和具有說服力的解釋。
  9. In this paper, the technological conditions for use of dry binder in zinc smelting process with vertical distillator were presented and the optimal formula of dry binder was proposed through the contrast test of dry to liquid binders

    敘述了乾粉粘合劑在豎罐煉鋅生產中應用的條件，並對乾粉粘合劑及液體粘合劑進行了對比試驗，提出了應用乾粉粘合劑的最佳配比。
  10. Abstract : in this paper, the technological conditions for use of dry binder in zinc smelting process with vertical distillator were presented and the optimal formula of dry binder was proposed through the contrast test of dry to liquid binders

    文摘:敘述了乾粉粘合劑在豎罐煉鋅生產中應用的條件，並對乾粉粘合劑及液體粘合劑進行了對比試驗，提出了應用乾粉粘合劑的最佳配比。
  11. Such as paints, thinner, adhesives

    ，比如油漆，稀釋劑體，粘合劑
  12. Road testing. measurement of the rate of hydraulic binders and additives in the cementitious materials. part 1 : chemical method for the determination of the cement content in a new mixed material

    道路試驗.粘結性材料中水壓粘合劑和添加劑比率測量.第1部分:新混材料中膠接劑含量測定的化學方法
  13. The cue tip should be larger in diameter than the ferrule so that it can be properly shaped. make sure the glue is completely dry before shaping

    粘合上的皮頭應該是比先角大上一圈的，待會我們會對它進行切割成型。在切割皮頭使其成型前要先確保膠水已經干透。
  14. The seamless fusing machine belt is longer in service life than that of any seamed teflon conveyor belt

    無縫粘合機帶壽命比任何有接縫的鐵氟龍輸送帶壽命都要長。
  15. Hydrocarbon binders. determination of the carbochemical heavy distillates content of mixed bitumens. densimeter method

    氫碳粘合劑.混合瀝青中碳化重餾分含量的測定.比重計法
  16. Theuhmwpe fiber has the high strength and high modulus characteristics, and the other mechanical properties are as well more outstanding, so the uhmwpe fiber gets the extensive application development in the each realm, particularly in the military protection realm. but the uhmwpe fiber exsits surfacial nonreactivity, with the weakness of the poor adhesion ability with the other materials

    超高分子量聚乙烯（ uhmwpe ）纖維具有高模、高強的特性，其他機械性能亦比較突出，故uhmwpe纖維在各個領域尤其在軍事防護領域得到日益廣泛的應用。但是， uhmwpe纖維存在表面惰性，與其他材料的粘合能力差的缺點。
  17. The conjoint affection of ruo _ 2 power on ta foil is also discussed here, including : selection and ratio of adhesive, selection and ratio of conductive agent, temperature and time of heat - press treatment of electrode. research indicated that temperature and time of heat - press treatment of electrode have the most effect on electrochemical properties of as - produced electrode

    然後討論了粉體與鉭片基體結合的影響因素，包括:粘合劑的選擇和比例、導電劑的選擇和比例、熱壓溫度和時間對電極片的電化學性能的影響，研究表明:熱壓溫度和時間對電極片電化學性能影響較大。
  18. With the fly - ash used as the main material, the modulus and specific gravity of the bond are studied and the influence of solidifying agent f on strengthening anti - acid capability of the particles is analyzed

    摘要以粉煤灰為主要原料研究了粘合劑的模數、比重以及固化劑f等因素對粒子增強耐酸復合材料性能的影響。
  19. Two kinds of polymer modified mortar with good toughness and high bond strength were produced by investigating how five different polymers affect mortar mechanical performance ( the compressive strength, the flexural strength, the ratio of flexural strength to compressive strength, the bond strength ) in different polymer content and in different curing condition

    通過系統研究五種不同的聚合物及不同的摻量對砂漿力學性能的影響（抗壓強度、抗折強度、折壓比、粘結強度） ，不同的養護制度條件下力學性能的變化情況，本文得到了兩種具有韌性好、粘結強度高的聚合物改性砂漿。
  20. Compared with other dampers, vdw has its specific advantages such as the full utilization of space, the provision of larger damping force, the convenience of installation, and the low cost of maintenance and so on. vdw not only can be applied in the earthquake - reduction design of new buildings, but also be used in the aseismatic retrofitting of existing buildings

    與其它阻尼器相比，粘滯阻尼墻可充分利用墻體所提供的空間，產生足夠大的阻尼力；既適合新建工程的減振設計，又能用於現有結構的抗震加固，且安裝方便、維護成本低，是目前較為理想的阻尼消能元件。
分享友人
分享到 Line

分享到臉書