水筒試驗 的英文怎麼說

中文拼音 [shuǐtǒngshìyàn]
水筒試驗 英文
water tunnel test
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 筒 : 名詞1 （粗大的竹管） a section of thick bamboo 2 （粗管狀物） thick tube shaped things 3 （衣服等...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 試驗 : trial; experiment; test
  1. Code for propeller cavitation tests in uniform flow carried out in cavitation tunnel

    空泡水筒均流中螺旋槳模型試驗規程
  2. Test method for purgeable organic compounds in water using headspace sampling

    用筒底間隙取樣技術對水中可提純有機化合物的試驗方法
  3. The following conclusions are gained : ( 1 ) the located shear band prongs the ligament near the top crack tip and the structure may occur shear - mode fracture at the angle of 155 ? to crack when load is 87. 92mpa ; the mode of fracture of the flange joint structure is not possible to be void - mode ; ( 2 ) it is proved that loading and then unloading repeatedly can not increase the possibility of invalidation of the structure when the times of loading and unloading are not too more when load is operating pressure ; the structure is safe when the vessel is operating ; ( 3 ) in the fe model of the thesis, not considering the influence of water pressure test which is in the process of fabrication of vessel in fe results in larger deviation in analysi

    得出了以下結論：在8792mpa的載荷下筒體一封頭連接結構處的集中剪切帶貫穿韌帶，可能發生沿與原裂紋線成155 「角方向剪切型斷裂；筒體一封頭連接結構不可能發生韌窩型斷裂； （ 2 ）在工作壓力下進行次數不多的反復加、卸載，結構不會破壞，也不會喪失安定性：結構在工作狀態下是安全的； m在本文的彈塑性有限元模擬計算中，對于裂紋尖端進行力學分析時，不考慮壓力容器製造過程中水壓試驗的影響，將導致計算結果出現較大的偏差； （ 4 ）筒體完全屈服時的載荷為92石3mpa ，封頭完全屈服時載荷為86
  4. In order to investigate the distribution regularities of axial direction of emerging object, experimental research of paddy threshing and separation used axial flow threshing and separation installation designed by ourselves of screw vane with shutter tooth was carried on

    摘要利用自行研製的螺旋葉片帶板齒式軸流脫粒與分離裝置，進行了水稻脫粒試驗研究，目的是研究脫出物沿滾筒軸向的分佈規律。
  5. By this means, the performance of the shock absorber is improved as well as the quality of suspension system. after tested on the testing equipment and on the road condition matched with the car, outer performance of the double - tube gas hydraulic shock absorber pr ove to be excellent and the indicator diagram are full and smooth. the operation and control of vehicle are also obviously improved. with the improvement of domestic components as well as gas charging equipment and gas charging workmanship, the double - tube hydraulic shock absorber meets domestic market requirements and will have a better prospect

    我們對研製的雙筒充氣液壓減振器進行了臺架試驗和裝車道路試驗，表明這種減振器具有優良的外特性，其示功圖豐滿、圓滑，車輛操縱性明顯改善。隨著我國零部件質量水平的提高，及充氣設備、充氣工藝的改進，雙筒充氣液壓減振器將有更廣闊的發展空間，適合我國的國情。
  6. To explore why the ratio of collectable wort extract is higher than that of non - extruded, the influences of all parameters of rice extrusion system ( barrel temperature, material moisture, screw speed ) on resistant starch content of extuded rice were studied by using second - order quadratic orthogonal rotating combination design method

    摘要為探索擠壓蒸煮大米啤酒輔料麥汁浸出物收得率高於傳統不擠壓蒸煮啤酒輔料收得率的原因，用二次正交旋轉組合試驗法設計安排試驗，研究了大米擠壓蒸煮系統諸參數（套筒溫度、物料含水量、螺桿轉速）對大米抗性澱粉含量的影響規律。
  7. Firstly the present situation of hydraulic fracturing of rock mass was talked about, then, the hydraulic fracturing of rock mass test was carried out with cement mortar ( analogue material of rock mass ) thick tube hollow cylinder through seepage - stress coupling apparatus that was developed by the laboratory of seepage control in hohai. through the analysis of data, the thesis discussed the mechanism of the hydraulic fracturing of rock mass

    首先對巖體水力劈裂研究的現狀作了較為詳細的綜述，然後應用河海大學滲流實驗室的滲流?應力耦合試驗儀對以水泥砂漿為巖石相似材料的厚壁圓筒試件進行了水力劈裂試驗，並對試驗結果進行詳細分析，對試件水力劈裂破壞機理進行了深入的探討。
  8. Using processed march cylinder, tapered circular mould, u - shaped instrument, l - shaped concrete fluidity instrument and some other testing instruments, and after research and study to physical and chemical property of various raw material. systematic tests have been carried out in respect of consistency between cement and additive, concrete fluidity, concrete filling - up - space and penetration capability and concrete anti - segregation property, basing on prudent and careful analysis to results of 34 - time tests a nd more than 500 data, and with utilization of combined additive, we finally conclude the proper mix design range for the self - densifying high performance concrete with ideal working performance at all respects

    通過加工的march筒、截錐形圓模、 u型儀、 l型混凝土流動儀等實驗儀器以及對各種原材料的物理及化學性能展開詳盡的調查研究，進行了多種材料下的水泥與外加劑相容性、混凝土的流動性、混凝土的填充性和鋼筋通過性、混凝土的抗離析性等系統試驗，在對34組試驗、 500多個數據的詳細認真分析的基礎上，利用復合后的外加劑，得出各項工作性能均較佳的自密實混凝土所用原材料比例范圍。
  9. On the base the damage models of concrete and analysis methods of horizontal loading capacity of pile are introduced. using the method mentioned above thin - wall cylinder piles of the out - gate the engineering in east punan shanghai are analyzed, and comparing with testing results it is prove that calculation results are reasonable

    在此基礎上引入了混凝土的損傷模型，提出了樁的水平承載力的分析方法，並利用該方法對上海浦南東片出海閘導流堤採用的薄壁筒樁進行了水平變力逐步加載分析，並與試驗結果進行比較，驗證了分析結果的合理性。
  10. Standard test method for compressive strength of molded soil - cement cylinders

    模製摻土水泥圓筒抗壓強度的標準試驗方法
  11. Experimental research on hydraulics characteristics of energy dissipation in vertical stilling well

    深筒式消力井水力特性試驗研究
  12. Abstract : this article researches the slurry performance of vehiele shock absorber, specifically the process that the slurry falls into shock absorber. we put forward a new utility engineering concept called critical slurry particle. we also discuss the compound and parameters of standard sturry the first time

    文摘:該文對車輛筒式減振器泥水特性與試驗、泥微粒進入減振器內部過程進行了探討，提出了臨界泥微粒等實用工程新概念.文中還對標準泥水的配製進行了探討並首次提出配製要求與參數
  13. This article researches the slurry performance of vehiele shock absorber, specifically the process that the slurry falls into shock absorber. we put forward a new utility engineering concept called critical slurry particle. we also discuss the compound and parameters of standard sturry the first time

    該文對車輛筒式減振器泥水特性與試驗、泥微粒進入減振器內部過程進行了探討，提出了臨界泥微粒等實用工程新概念.文中還對標準泥水的配製進行了探討並首次提出配製要求與參數
  14. By way of comparing the results obtained from netting theory, compound theory, nonlinear fem and experimental test, the conclusion could be drawn that matrix crack damage surely existed in the cylinder part of structure. when the structure was subject to internal pressure up to 6. 8mpa, which was the maximum loading of hydrostatic test, the deformation of the global structure and stress and strain distributed in any parts of structure were obtained

    通過對網格理論、復合理論和非線性有限元方法計算結果與試驗值之間的相互比較，可以看出：非線性有限元計算結果介於網格理論和復合理論之間，且有限元計算結果與復合理論結果更加接近，表明在水檢壓力下殼體筒段確實存在著基體開裂等損傷。
  15. The test on horizontal bearing capacity of thin - wall hollow pile is analyzed in the paper, which has been carried by shanghai investigation and design institute. the calculation results conform to the testing results. so, the analysis methods presented in the paper are validated by the results from field test

    文中對上海勘測設計院進行的薄壁筒樁水平承載能力試驗進行了相應的計算分析，所得結果規律與試驗結果較為吻合，使得本文提出的分析方法得到了現場試驗的驗證。
  16. According to that method, deformations and stresses of thin - walled cylindrical piles applied in some engineering under horizontal loads were analyzed, and the results were compared to those of in - situ test, and the practicability of the method mentioned in this paper was verified as well

    對某工程薄壁筒樁在水平荷載作用下的樁體變形和內力進行了分析，並與現場試驗結果進行了比較，驗證了本文分析方法的正確性。
分享友人
分享到 Line

分享到臉書