波段變換器 的英文怎麼說

中文拼音 [bōduànbiànhuànqì]
波段變換器 英文
wave changement
  • 波 : Ⅰ名詞1 （波浪） wave 2 [物理學] （振動傳播的過程） wave 3 （意外變化） an unexpected turn of even...
  • 段 : Ⅰ量詞（部分） section; segment; part; paragraph; passage Ⅱ名詞（姓氏） a surname
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 波段 : [電學] wave band; wave range; band; range; frequency range; frequency band
  1. The specific research methods are listed : 1. matched filter taking the max ouput snr as the best rule correlates nonstop divided signal and divided echo to detect low snr target signal. then all one dimension divided correlation outs and done fft in portrait to leach interferential signal such as static or low rate mussy meaves, many pathway echo and so on and to take target ' s time difference and doppler frequency that combine parameters that target ' s direction taken from antenna and so on to implement target ' s orientation and tracking

    具體研究方法如下： 1 、採用以輸出信噪比最大為準則的最佳匹配濾波器來對分段的參考和目標信號作相關處理來檢測低信噪比目標信號，然後對一維分段相關輸出組作縱向傅立葉變換來濾除靜態或低速的雜波、多徑回波等干擾信號，並提取目標的時差和多普勒頻率，再結合由天線獲得的目標方向等參數，就可以實現目標的定位和跟蹤。
  2. Firstly. operation principle of induction heating is introduced and the actuality of the power supply for induction heating is summarized. then, the scheme of structure of the power supply is established : uncontrolled rectifier and buck chopper constitute dc circuit. in this part, operation principle of a kind of soft switching buck chopper is presented mainly and the conclusion that the power semiconductor devices operate in soft switching is also illustrated by analysing the operation principle of all stages ; series resonant inverter is selected as inverter circuit via comparing the advantage and shortcoming of parallel resonant and series resonant. moreover. the work principle of series resonant inverter is analysed and the calculating method of the best dead time is put forward as well

    文中首先介紹了感應加熱電源的工作原理並綜述了國內外的研究現狀。接下來分析並制定了電源主電路的構成方案：在對比幾種功率調節方式的基礎上選擇了不控整流加斬波調壓作為直流部分。在這部分里，重點研究了一種軟開關buck變換器，通過分析各階段的工作原理說明了開關器件如何工作在軟開關狀態；對于逆變器部分，在比較了串、並聯逆變器優缺點的基礎上選擇了串聯諧振逆變器，並詳細分析了串聯逆變器的工作原理，提出了最佳死區的計算方法。
  3. At present, people usually use birefrigence and quasi - phase - matching methods to achieve higher effiency in the process of conversion. a significant advantage of quasi - phase - matching method is that the interaction is occurred through the largest element of the x ( 2 ) tensor ; the period of optical superlattice can be designed randomly, and any interaction can be matched without walk - off angle ; they are fitted to be used in frequency conversion of lower power especially. the quasi - phase - matching method has some advantages over birefrigence method, improving the efficiency of frequency conversion ; the range of frequency conversion covers its whole transperant wavelength

    由於準相位匹配技術有其獨特的優勢，可以利用非線性光學晶體的最大二階極化張量，如ppln 、 pplt 、 ppktp用的非線性極化張量都是d _ （ 33 ） ，其有效非線性系數高出普通非線性光學介質（如bbo 、 lbo 、 ktp ）一個數量級，而且可以人為靈活設計調制周期，通過周期設計其頻率變換范圍可以覆蓋準相位匹配介質的整個透明波段，選擇無走離效應，解決了常規pm難以解決的問題，拓寬了非線性晶體的應用范圍，極大地提高了頻率轉換效率，已成為非線性光學材料和固體激光器的研究熱點之一。
  4. In the traditional wavelet transform, because the wavelet filter and coefficient is fixed, as a result, when the discontinuous signal is analyzed, it will produce a lot of big wavelet coefficients in the transition, which makes against the compression. in the image processing, some image is roughness, and it may has sharp edges and oddity parts

    由於傳統小波變換的濾波器長度和系數是固定不變的，不能適應輸入信號而變化，這使得在分析非連續信號時，在躍變點兩側會產生大的小波系數;對具有尖銳邊緣、分段光滑或奇異點、圖文混合圖像處理效果很差。
  5. Another aspect of this paper is to expand the working band of hartmann - shack wavefront sensor through frequency transfer of nonlinear optics

    另一方面，我們又對利用非線性光學頻率變換方法拓寬探測器件的響應波段，做了探索性的工作。
  6. A x - band six - cavity tro is studied. with the voltage 760kv 6ka and the magnetic field 2. 6t in the simulation, output power is about 1. 5gw is obtained, and interaction efficiency is 31 %. a noveland high accurate numerical synthetic technique is presented for determining the high frequency characteristics of six - cavity with open boundary

    對粒子模擬的輸出微波功率的作出診斷，找到讀取微波功率快速有效的方法：在電場和磁場同相的前提條件下，對時域波形進行傅立葉變換，微波功率頻域的二倍頻所對應的幅度即為微波x波段渡越輻射振蕩器的理論和實驗研究平均功率的大小。
  7. It shows that when walk - off and diffraction effects could be ignored approximately estimation of the phase distribution of second - harmonic wave could be done. the far field divergent angle and second moment radius of harmonic wave will vary with the aberration of fundamental wave, but the far field divergent angle will be obviously smaller than that of fundamental wave. the phase distribution of both fundamental and harmonic wave is measured using hartmann - shack wave front sensor in the experiment with 1064nm and 790nm lasers, respectively

    這說明利用非線性光學頻率變換方法拓寬波前傳感器件的響應波段是很難實現的，但是，通常三波相互作用過程的研究均是建立在平面波和理想高斯光束之上，因此我們對于位相畸變倍頻過程的研究是非線性光學領域一個重要而有意義的新課題，它有助於人們更加深入理解非線性光學效應，為進一步合理利用之奠定了理論和實驗的基礎。
  8. In order to research sinusoidal - and trapezoidal - current compound driven technology, the controller uses variable structure control ( vss ), by designing switch function s ( x ), which switches motor between sinusoidal - and trapezoidal - current driven technology, and thus realizes motor ' s excellent control in different range of speed. also we do software simulation using matlab

    為了研究方波驅動和正弦波驅動的復合控制，控制器採用變結構控制，通過設計切換函數，使電機在正弦波驅動和方波驅動兩種控制模式下切換，實現不同速度段的優良控制特性，並用matlab軟體對整個復合驅動系統進行了模擬實驗。
  9. Although dm can also solve the modulation time error, but the output waveforms can ’ t reach the industrial standard ( total harmonic distortion thd ). considering this, a new control strategy called current optimal control ( coc ) is presented in paper. coc is that system samples the output value real time, comparing with expected value, considering all switching actions available then draw a concluding to decide which way would be fastest and best way to render system smooth

    針對這一缺點，本文提出了一種更好的控制策略，電流最優delta調制，它是在電流滯環控制的基礎上，根據電路的輸出信號來分析，考慮所有可能的逆變器動作來決定選用哪一種開關轉換方式能最快最平穩地達到預期值，採用的是一種電流預測控制手段，從而使輸出波形的紋波最小。
  10. At the same time, the optimum detector of ffd and tsd in wavelet domain have been investigated according to properties of cwt. they are wavelet - domain - segmented - replica - correlator ( wdsrc ) and wavelet - domain - replica - correlation - integration ( wdrci ). and we have proved that their performances are consistent with those in time domain

    同時又依據連續小波變換的性質推導出ffd和tsd通道小波變換域的最佳檢測器：小波域的分段副本相關器（ wdsrc ）和小波域的副本相關積分器（ wdrci ） ，並從理論和模擬證明了它們與相應的時域檢測器性能的一致性，優于小波域的副本相關器（ wdrc ） 。
  11. The accurately controlled signal source generates sinusoidal elastic wave accurately controlled in frequency and stable in phase to " illustrate " underground media. time signal stacker receive signal by stacking and doing fft to measure the transfer function of media. " sompi " cepstrum method retrieve group velocity travel times and decayed factors of wave element from observational data of transfer function in a limited frequency window

    精密可控震源用於產生頻率精確相位穩定的正弦彈性波以照射地層內部，信號疊加器通過對接收信號進行疊加和進行傅立葉變換的方式實現對介質傳遞函數的精密測量， 「存否」倒譜方法能夠根據一段窄帶頻域傳遞函數數據獲得時域上各個波成分的群速度傳播時間和介質衰減因子。
  12. The welding path recognition system was developed with delphi 7. 0 in the environment of windows2000, which functions include filtering, sharpening, binarization and edge detecting. the straight line and curve can be identified through hough transform and line approximation method and the results are saved for nc auto programming

    能夠對從ccd傳感器攝取的焊接軌跡圖像進行濾波、銳化、二值處理、邊緣檢測等圖像處理工作，並通過分別通過hough變換、直線段逼近演算法完成對直線和曲線的識別，最後保存結果為后續nc自動編程提供數據。
  13. This paper has proposed one new way of thought of differentiating the fault type. after observing the physical course of the single - phase grounding of transmission line, analyzing by the wavelet transformation the transient signals sampled during the fault period from the moment that single - phased grounding occurs to the moment that line breakers work, we can distinguish temporary fault from permanent one through the wave form

    本文提出了一種不同於現有故障類型判別的思路，通過考察線路單相接地故障的物理過程，利用小波變換理論分析處理線路單相瞬時性故障和永久性故障在故障發生后斷路器開斷前時間段的暫態信號，通過波形識別區分兩種故障。
分享友人
分享到 Line

分享到臉書