液壓閘門 的英文怎麼說

中文拼音 [yèyāzhámén]
液壓閘門 英文
hydraulically operated gate
  • 液 : 名詞（液體） liquid; fluid; juice
  • 壓 : 壓構詞成分。
  • 閘 : anchor gate
  • 門 : Ⅰ名詞1 （房屋、車船等的出入口 ） entrance; exit; door; gate 2 （形狀或作用像門的東西） switch; va...
  • 液壓 : hydraulic pressure液壓泵 hydraulic pump; 液壓表 hydraulic pressure gauge; hydraulic pressure indi...
  • 閘門 : 1 （水閘） sluice gate; gate; water gate2 （船閘） lock gate3 [機械工程] throttle valve; strobe; ...
  1. Small and middle size hydraulic headstock gears. basic parameters

    中小型液壓閘門啟閉機.基本參數
  2. Traditional method for overhaul of the top of miter gate is through manual operation by hydraulic hoisting jack, which has the shortcomings of low efficiency and great risk

    摘要船閘人字門頂門檢修的傳統方法是採用液壓千斤頂手動作業，工作效率低，時間長，技術風險大。
  3. After introducing the general situation of the hatch, the trait and research status of hydraulic control, complying with the technical request of the enterprises, this dissertation first have designed a double - hatched hydraulic control system with an accumulator as a storable energy

    在介紹閘門的概況，分析液壓傳動控制的特點以及液壓系統動態特性研究現狀后，本文首先根據企業提出的技術要求，設計了一個採用蓄能器作為儲備能源的雙閘門液壓控制系統，實現正常與停電工況下的功能要求。
  4. Design of hydraulic hoists for eccentric trunnion sector gates of xiaolangdi project

    小浪底水利樞紐偏心鉸弧形閘門液壓啟閉機設計
  5. Modeling and simulation of hydraulic system of water gate using the distributed physical net modeling approach

    閘門液壓系統分散式物理圖網建模及模擬研究
  6. According to the actuality of the studied water power station, the thesis combine the advanced fieldbus technique, ethernet and the traditional hydraulic technique together, and use them to design the supervise controlling system of the water power station. base on the gate - controlling request of the water power station, designed the gate ' s hydraulic hoist system

    文章從結合所研究的水電站的實際需要出發，將先進的現場總線技術、以太網技術與傳統的液壓技術相結合，並應用到水電站閘門監控系統的實際設計過程中。論文根據所研究水電站閘門控制的具體技術要求，設計了適合該水電站的液壓啟閉機系統。
  7. According to the demands of the enterprises, combining with the actuality, this dissertation has designed a hydraulic control system for inlet hatch, in order to meet the waterworks " requirements - cutting off the inlet in time when an electrical failure should occur. this system benefits the safety and well - running of waterworks. besides, with the simulink in matlab, it has simulated the dynamic characters of the system to optimize the parameters, components and system

    根據企業需求，結合現狀，本文設計了速閉閘液壓控制系統以滿足水處理廠遠程控制閘門及在斷電時快速切斷進廠水源的迫切需要，有利於保證水處理廠的安全、正常運行：利用matlab提供的simulink軟體包對速閉閘控制系統的動態特性進行模擬，來達到優化參數、元件、系統的目的。
  8. They are used for connecting the sluice of the three - gorge dam and the gantry or disconnecting them

    該液壓系統為三峽大壩泄洪閘實現與門機聯接或脫開的系統。
  9. Secondly, based on the account of hydraulic dynamic factor ( hydro - capacitance and hydro - inductance ) and the analysis of each component ' s math model, the system ' s math models of three situations are established

    其次，在充分考慮液壓系統的動態因素（液容和液感） ，並對各液壓元器件建模分析的基礎上，分別建立了速閉閘液壓控制系統在泵或蓄能器作用下開啟、關閉閘門過程的數學模型。
  10. Basic parameters of qppy hydraulic hoist for hydraulic plane gate

    Qppy型水工平面閘門液壓啟閉機基本參數
  11. Basic parameters of qpky hydraulic hoist for quick - closing hydraulic plane gate

    Qpky型水工平面快速閘門液壓啟閉機基本參數
  12. Research on hydraulic transients and operating system for energy - reserve rapid - drop gate of large scale pumping stations

    大型泵站水力過渡過程計算及蓄能式液壓啟閉閘門的研究
  13. The thesis analyzed the development of the gate ' s hoist and its controlsystem, and the localization of the gate ' s operating machine ' s traditional hydraulic system, according to today ' s control technique, especially the characteristics of the profibus fieldbus, the thesis put forward the project that " the gate supervise controlling system base on the profibus control and ethernet technique ", according to that project, completed plc control procedure and the procedure of the supervise and control ( supervise and control software and man - machine interface ), at last the thesis set up a ethernet network for the monitor and the plc correspondence of a place of honor machine and plc and a fieldbus network for the far i / o mold and the plc, made the gate supervise and control by network

    文章對閘門啟閉機及其控制系統的發展狀況和傳統液壓啟閉機控制系統的局限性進行了詳細分析，並結合當前控制技術，特別是profibus現場總線控制技術的特點，針對所研究的水電站的實際情況提出了「基於profibus現場總線控制和以太網技術的閘門監控系統」的技術方案。並根據該方案完成了下位機（ plc控製程序）的編制和上位機（監控軟體和人機界面的組態）的組態。最後通過組建上位機與plc的通信以太網路和遠程i o模塊與plc之間的總線網路，實現了整個閘門監控系統的網路化。
分享友人
分享到 Line

分享到臉書