溫度完善性 的英文怎麼說

中文拼音 [wēndùwánshànxìng]
溫度完善性 英文
thermal integrity
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 善 : Ⅰ形容詞1 （善良; 慈善） good 2 （良好） satisfactory; good 3 （友好; 和好） kind ; friendly 4 （...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 溫度 : [物理學] temperature
  1. Meanwhile in the condition of high temperature, water vapors can participate in combustion. water gas reaction will happen, which will reduce carbon particle in flame, and reform combustion performance, so improve combustion efficiency. the article developed a kind of technology of water injection into intake ports for 4135g diesel engine, meanwhile designed a suit of water injection system

    同時在高溫條件下，水蒸汽參與燃燒，部分水分子與未完全燃燒的熾熱的炭粒發生水煤氣反應，形成可燃性氣體，從而減少了火焰中的炭粒，提高了油的燃燒程度，改善了燃燒狀況，提高了油的燃燒效率。
  2. The ideology and experience regarding design of large capacity w flame units in foreign countries should be further acknowledged, this can be an example for us to draw a more reasonable rules and methods of calculation. in this thesis, the systematic numerical simulations were conducted for w flame boiler furnace

    針對邯峰電廠的660mw機組w型火焰鍋爐的特點，編制和完善了爐內熱態流動及燃燒模擬程序，並進行了全面的爐內過程數值計算，得到了鍋爐爐膛內的溫度分佈和速度分佈，對鍋爐性能進行了預報。
  3. According to the analyses of the research results about the feasibility of 4 - d seismic and the successful 4 - d seismic cases of foreign companies, the author put forward the suggestions for 4 - d seismic pilot area selection ; briefly analyzed the influential function of producing way on the seismic response ; utilized theory calculation, coring data analyses, and reservoir numerical simulation to define the fluid substitution effects on the p - wave velocity. through long time water driven to the reservoir, some of the properties and the log curves have changed, the author tried to find the variation rule of the reservoir and its effects on seismic velocity. the " blind point " in 4 - d seismic feasibility study both in china and overseas was found, that is the lack of consideration of the influence of physical property variation by long time water driven on the seismic response

    在深入分析國外四維地震可行性研究成果和成功實例的基礎上，提出了有利於水驅四維地震成功的工區優選條件；簡要剖析了各種開采方式及其對地震特性的影響；利用理論計算、巖心分析、油藏數值模擬三種方法確定了流體替代對縱波速度的影響；通過對長期水驅造成的物性參數、測井曲線以及油藏溫度和壓力變化規律的總結，分析了這些變化對地震速度的影響，指出了目前國內外水驅四維地震可行性研究中存在的盲區?沒有充分考慮長期注水造成的物性、溫度和壓力變化對地震響應的影響，完善了水驅四維地震可行性研究的內容；在考慮了這些變化因素后，高29斷塊水驅四維地震可行性研究結果表明：四維地震監測注水前沿可能要比監測油藏變化容易的多；以四維地震巖石物理可行性研究結果為基礎，提出了五個有助於突出四維地震造成的微小差異的途徑，為今後水驅四維地震研究指明了方向。
  4. We put forward a scheme that multisensor data fusion - surface fitting and curve - fitting was applied in this system according to the temperature drift and nonlinear of sensor. communication between personal computer and measurement system of sensor was realized by means of transceiver with the type of max232, which could finish the data conversion, data processing and printing task, with the result that the measurement system was further improved

    針對傳感器測量的溫度漂移和非線性等問題，提出了利用多傳感器信息融合技術?曲面擬合法和曲線擬合法來加以解決，並通過max232收發器實現pc機與傳感器測量系統之間的通信，完成數據轉換、數據處理和列印等功能，使測量系統更加完善。
  5. For adapting to the need of industrialization and improving the properties of materials, the method of mechanical activation has introduced on the basis of traditional calcinations at high temperature. the stardard spinel limn204 is prepared by the mechanical activation - high temperature solid synthesis method. the thermodynamic property, the physical - chemistry performance and the producing techniques of. battery have been studied by means of thermogravimetry ( tg ), differential scanning calorimetry ( dsc ), x - ray diffraction ( xrd ), scanning electric microscopy ( sem ) as well as various electrochemical analysis methods. studies show that synthesis temperature, calcinations time, recipe of raw materials, heat treatment and particle size of products are main factors affecting the performances of limn204 cathode materials. with the increment of synthesis temperature and time, the structure and crystal of products are getting to perfect

    隨著合成溫度和時間的增加，產物的結構和晶型越趨于完善，但在1100得到的產物有燒結和晶粒增大的現象，恆溫時間超過24h后對材料的性能影響不是很大； li mn比在0 . 95 1 . 05 2的條件下都可得到標準的尖晶石limn _ 2o _ 4 ，尤其當li mn比為1 . 05 2時，所合成的材料具有較好的電化學性能；通過兩段合成法制備的產物性能要比一段合成法法制備的產物性能好，而兩段間隔合成法比兩段連續合成法處理的材料性能更佳；顆粒的粒度隨著球磨時間的延長而減小，比表面昆明理工大學碩士學位論文摘要卻增大，粒度小且分佈范圍窄的材料有利於鏗離子的擴散。
  6. By controlling the stress value of under - lying layer less than tits structure yield stress value, a new design method to decrease composite ground settlement is suggested. and the composite foundation settlements of 12 buildings with the deep mixing cement piles is calculated, which is in good accord well with the measurement in field. second, considering the influence of well resistance, smear effect and structure breakage of thick soft clay, the equivalent calculation method is proposed

    首先，結合溫州地區深厚軟土，通過對室內常規試驗結果的分析，發現軟土具有較強的結構性，並給出室內固結壓縮曲線校正的新方法；提出了通過控制未打穿水泥攪拌樁復合地基下臥層的應力水平，使其小於土體結構屈服應力，以大幅度減小沉降的復合地基設計方法，並通過與12幢住宅樓未打穿水泥攪拌樁復合地基的實測沉降對比，得到了良好的驗證，進一步完善了結構性軟土壓縮變形的計算方法。
  7. On structure design aspect, a closed magnetic route around the gmm is formed, so magnetic symmetry and intension of gmm are improving ; on analysis of electricmagetic characteristics aspect, ansys software is applied to analyze the gma to optimize its structure ; on ampliflcatory power system aspect, based on the characteristic of driving power of gma and the principle of constant current source, a power amplifier using power mosfet is designed ; on testing equipments aspect, measure bracket is designed including transom, stand beam, screw, pedestal ; on cooling system aspect, a constant temperature cooling system is designed theorily

    本文根據稀土超磁致伸縮材料的特點及其在工業元件、系統中的應用要求，在以往微位移致動器的基礎上，克服他們的不足，經過各方面的完善，設計出一種精確的、適合於主動控制的稀土超磁致伸縮位移致動器，主要在稀土超磁致伸縮致動器結構設計、電磁特性分析、功放系統以及最後的實驗測試系統方面進行了設計，同時對溫度冷卻系統也做了一些理論設計。
  8. The architecture is simple, with high respond speed, high stability and adopts very advanced charging termination methods such as - v, max voltage, max temptature and temptature change rate so its reliability and safety are very high

    該電路結構簡單，響應速度快，有很高的穩定性，採用了非常完善的充電中止方法，如- v終止，最高電壓，最高溫度和溫度變化率等，使得該電路具有相當高的可靠性和安全性。
  9. Aiming at drawbacks that environment simulate test laboratory ( estl ) ' s control precision is being dropped, the system digital simulation, the system characteristic analysis is proceeded ; basing on it, intelligence pid control processor, integral desaturation pid control processor, leading adjust control processor ( leading adjust of point of inflection of curve ) is planned, double loop control processors of low temperature system is consummated, so, the new control scheme and control program is formulated ; moreover through control program " simulate debugging and environment simulate test, 18 experimental curves and 19 experimental items is fulfilled totally. it proved that estl ' s control system and control program are successful. experimental result makes it known that the new control plan solves the problem of low control precision

    本論文針對環模室原控制系統存在的控制精度下降等問題，進行了系統模擬及環境模擬系統特性分析，在此基礎上，設計了智能pid控制器、抗積分飽和的控制器、預估補償控制器、完善了低溫系統的雙迴路控制，制定了新的控制方案和控製程序組態，並對其控製程序進行模擬調試及結合實際試驗對其控制系統進行驗證；共計完成了18條曲線， 19個項目的試驗，對其控制系統及控製程序進行了充分的考驗。
  10. Circuit board through optimization design and continual perfection of production technology, has reduced temperature drift, has improved anti - interference property, ensure products stability and reliability during long - term operation

    線路板經過優化設計及生產工藝不斷完善，降低了溫度漂移提高了抗干擾性能，確保產品在長期工作中的穩定性和可靠性。
分享友人
分享到 Line

分享到臉書