溫度雙曲線 的英文怎麼說

中文拼音 [wēndùshuāngqūxiàn]
溫度雙曲線 英文
temperature hyperbola
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 雙 : Ⅰ形容詞1 （兩個） two; twin; both; dual 2 （偶數的） even 3 （加倍的） double; twofold Ⅱ量詞（用...
  • 曲 : 曲名詞1 （一種韻文形式） qu a type of verse for singing which emerged in the southern song and ji...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 溫度 : [物理學] temperature
  • 曲線 : [數學] curve; bight; bought; profile; net曲線板 french curve; irregular curve; curve board; splin...
  1. On the basis of it, - a isotherms were analyzed at different ph 、 temperature 、 molar fraction of mpda and the optimal condition were obtained the preparation of polydiacetylene monolayers and the studies of its spectroscopic properties : the mpda / pda monolayers were irritated by 254nm uv - lamp for 20 seconds and the sensitive monolayers were produced. the uv - vis spectra showed that the recognition between mannose and e. colik12 is specific. the results of the rrs confirmed that the bands of double < wp = 7 > and triple bonds simultaneously shifted toward high wavenumber and its electrical structure of the backbone changed from acetylene to butatriene

    - a曲線的結果表明：雙炔（ pda ）及其甘露糖衍生物（ mpda ）是混溶的。在此基礎之上，我們又對亞相處于不同溫度、不同ph值時和雙炔（ pda ）及其甘露糖衍生物（ mpda ）二者以不同比例混合時的- a曲線進行了詳細的分析，從而確定了雙炔（ pda ）及其甘露糖衍生物（ mpda ）成膜的最佳條件。
  2. This paper studies the application of inductively coupled plasma ( icp ) technology to the etching compound semiconductor insb - in film. by means of single probe and double probe, the ion density and electron temperature of chamber ( 30mm and 50mm in height respectively ) under varied process condition were diagnosed. the spatial distribution of the axial position of the two parameters and the varied curve that the two parameters varies with the power and air pressure are obtained

    利用單探針和雙探針診斷30mm高反應室和50mm高反應室在各種工藝條件下的離子密度和電子溫度，得到這兩個參數在反應室軸向位置的空間分佈、隨功率和氣壓的變化曲線、頂蓋接地和反應室體積對它們的影響，結果表明離子密度為10 ~ 8 10 ~ （ 10 ） cm ~ （ - 3 ） ，電子溫度在4 10ev之間；當頂蓋接地時，該處的等離子體密度明顯大於不接地；在同樣條件下， 50mm高反應室內的離子密度明顯大於30mm高反應室。
  3. The dynamic parameters of the asphalt concrete can be obtained through dynamic triaxial test, combined with the cunli chen ' s studying results, discovering that the dynamic stress - strain relationship obeys the hyperbolic model well, and t he maximum dynamic modulus edmax and the maximum shear modulus gdmax increasing along with the decreasing of the temperature and the increasing of consolidation ratio kc

    通過振動三軸試驗獲得瀝青混凝土材料的動力參數，並結合西安理工大學陳存禮老師的研究成果。發現動應力與動應變的關系較好地符合雙曲線規律，最大動模量e _ （ dmax ）和最大剪切模量g _ （ dmax ）隨著溫度的降低、圍壓和固結比kc的增大而增大。
  4. The author argues that the model can be used to calculate the longitudinal force caused by the temperature or the load acting on one of the double railway tracks, as well as the braking force and the breakage force

    此模型可計算溫度的影響，探究雙線橋樑上的單線荷載作用下的撓曲力、制動力和單軌斷裂時的斷軌力。
  5. Secondly, the effect of transverse deforming on the property of the wedge pressing was studied. the results showed that : the wedge pressing stock with the transverse deforming amount of 10 % acquired the best performance. the highest density got the biggest rate of slope while with the amount of 30 % the curve was more some special structure and performance as following : the large porosities was crushed into small or linear ones with the high - direction deformation amount of 20 % ; as the increasing of the high - direction deforming, the particles got a further deforming, the porosities got a further crushing, the small porosities were mergered by the large ones and the former then disappeared ; when the amound reached 60 %, the quantity of the porosities would obviously decrease which made the materials compact, the microstructure more uniform and the density and hardness curves more horizontal, the relative desity could reach 99. 7 %, the tensile strength b of the as - compacted samples reached 408mpa with the yield strength s teached 289mpa and the elongation percentage reached 13. 6 %. in addition, the microstructure of the wedge pressing stock under the pressing temperectureof 450 was uniform, the porosities and the boundries of the grains basically disappeared and the conjunction between particles was great

    採用雙向楔形壓制，大尺寸噴射沉積5a06鋁合金楔壓坯的組織和性能變化具有如下特點:當高向變形量為20 %時，大的孔洞變形破碎為小的孔洞，或呈線狀孔;隨著高向變形量的增加，顆粒進一步變形，孔洞進一步破碎，大孔「吞併」小孔，小孔塌陷並逐步消失;當高向變形量達到60 %時，孔洞量大為減少，材料基本緻密，組織趨于均勻，楔壓坯料的密度、硬度變化曲線接近水平線，坯料的相對密度達99 . 7 % ，抗拉強度_ b = 408mpa ，屈服強度_ （ 0 . 2 ） = 289mpa ，延伸率= 13 . 6 % ;對比其它的壓制溫度，在450楔形壓制的坯料組織均勻，孔洞及顆粒邊界基本消失，顆粒之間冶金結合良好。
  6. Aiming at drawbacks that environment simulate test laboratory ( estl ) ' s control precision is being dropped, the system digital simulation, the system characteristic analysis is proceeded ; basing on it, intelligence pid control processor, integral desaturation pid control processor, leading adjust control processor ( leading adjust of point of inflection of curve ) is planned, double loop control processors of low temperature system is consummated, so, the new control scheme and control program is formulated ; moreover through control program " simulate debugging and environment simulate test, 18 experimental curves and 19 experimental items is fulfilled totally. it proved that estl ' s control system and control program are successful. experimental result makes it known that the new control plan solves the problem of low control precision

    本論文針對環模室原控制系統存在的控制精度下降等問題，進行了系統模擬及環境模擬系統特性分析，在此基礎上，設計了智能pid控制器、抗積分飽和的控制器、預估補償控制器、完善了低溫系統的雙迴路控制，制定了新的控制方案和控製程序組態，並對其控製程序進行模擬調試及結合實際試驗對其控制系統進行驗證；共計完成了18條曲線， 19個項目的試驗，對其控制系統及控製程序進行了充分的考驗。
分享友人
分享到 Line

分享到臉書