漏擊穿電壓 的英文怎麼說

中文拼音 [lóujīchuāndiànyā]
漏擊穿電壓 英文
drain breakdown voltage
  • 漏 : Ⅰ動詞1 （從孔或縫中滴下、透出或掉出） leak; drip 2 （泄漏） divulge; disclose; leak 3 （遺漏） le...
  • 穿 : Ⅰ動詞1 （破; 透） pierce through; penetrate 2 （通過孔、隙、空地等） pass through; cross; go thro...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 壓 : 壓構詞成分。
  • 電壓 : voltage; electric tension; electric voltage
  1. Drain breakdown voltage

    漏擊穿電壓
  2. Incondition of surface anti - corrision and insulation coat of metal and tiny hole of steel where resistance and crack is very small, when supplying a high voltage, gas crack will be punctured and electric spark discharging will occur, now send a pulse signal to the alarming circuit the alarmer can send out sound and light to alarm. we can do leak hunting on the coating according to this principle

    金屬表面絕緣防腐層過薄、漏鐵及漏電微孔處的電阻值和氣隙密度都很小，當有高壓經過時就形成氣隙擊穿而產生火花放電，給報警電路產生一個脈沖信號，報警器發出聲光報警，根據這一原理達到防腐層檢漏目的。
  3. A model of the interface state density distribution near by valence band is presented, and the dependence of the threshold voltage on temperature, the c - v characteristics and the subthreshold characteristics are predicted exactly with this model ; the effects of s / d series resistance on the output characteristics, transfer characteristics and effective mobility of sic pmosfets are analyzed. thirdly, the output characteristics and the drain breakdown characteristics are modeled with the procedure medici. the output characteristics in the room temperature and 300 ? are simulated, and the effects of gate voltage. contact resistance, interface state and other factors on sic pmos drain breakdown characteristics are analyzed

    提出了一個價帶附近的界面態分佈模型，用該模型較好地描述了sicpmos器件閾值電壓隨溫度的變化關系、 c - v特性曲線以及亞閾特性曲線；分析了源漏寄生電阻對sicpmos器件輸出特性、轉移特性以及有效遷移率的影響；論文中用模擬軟體medici模擬了sicpmos器件的輸出特性和漏擊穿特性，分別模擬了室溫下和300時sicpmos器件的輸出特性，分析了柵電壓、接觸電阻、界面態以及其他因素對sicpmos擊穿特性的影響。
  4. Test results indicated : with the hoist of altitude, the increase of ice amount and the rise of pollutant, the average flashover voltage reduced. the character exponent generally depends on the insulator profile, ice amount, ice state and pollution severity etc. by means of a high - speed camera, a data acquisition system and high voltage test facilities, a series of the flashover processes on ice surfaces were record. the experimental results form this study and the subsequent theoretical analyses suggested : the thermal ionization of the air in front of an arc root resulted in arc movement ; the electrostatic force had an auxiliary effect of impelling arc propagation ; the electrical

    通過對攝像機、數據採集系統及高壓試驗裝置記錄覆冰絕緣子表面閃絡電弧的發展過程的試驗結果進行理論分析得出：弧根周圍空氣的熱電離導致了電弧的發展，靜電場力對電弧的發展起到了加速作用，電擊穿僅發生在閃絡最終的跳躍階段；通過測量閃絡過程中的放電電壓、泄漏電流、閃絡時間、覆冰水電導率、電弧長度及電弧半徑等參數，得到了不同階段電弧（電弧起弧階段、電弧發展階段及完全閃絡）的發展速度、臨界電弧長度均隨覆冰水電導率的增加而減小。
  5. In this paper, the theory of negatively charged surface states is used to investigate dynamic breakdown characteristics and the increase of gate - drain breakdown voltage as well as the reduction of saturated drain - source current after sulfur passivation. the measure which can improve the stability of sulfur passivation is proposed

    本論文通過對gaasmesfet擊穿機理和硫鈍化機理的研究，用負電荷表面態理論，解釋了gaasmesfet動態擊穿特性及硫鈍化后柵漏擊穿電壓增大、源漏飽和電流減小的機理，提出了改善硫鈍化穩定性的措施。
  6. High leakage currents and soft reverse current - voltage characteristics are some of the detrimental effects produced by the metal atoms dissolved in the silicon matrix. gettering procedures can reduce metal contamination

    由於金屬雜質原子擴散並沉積在器件的有源區，會造成諸如：反向漏電流較大，反向擊穿電壓是軟擊穿等有害的影響。
  7. The result of the test for dynamic breakdown characteristics reveal that breakdown voltage increases as the lengths of the pulses applied to the gate and drain electrodes increase. this could be mainly due to the influence of surface states

    Gaasmesfet動態擊穿特性測試結果表明， gaasmesfet的擊穿電壓隨柵極與漏極上所加脈沖電壓寬度的增大而增大，這主要是因為表面態的原因。
  8. Namely, the electric field at the drain - side edge of the gate decreases with the increasing of negative charge density in the surface, so the breakdown voltage of gaas mesfet ' s will increase

    表面受主態的增多使表面負電荷密度增大，表面聚集的負電荷可以分散漏側柵邊緣處的電力線密度，減弱了柵靠漏一側的電場強度，擊穿電壓提高。
分享友人
分享到 Line

分享到臉書