漏流 的英文怎麼說

中文拼音 [lóuliú]
漏流 英文
leak current
  • 漏 : Ⅰ動詞1 （從孔或縫中滴下、透出或掉出） leak; drip 2 （泄漏） divulge; disclose; leak 3 （遺漏） le...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  1. Drainage is certainly indicated because of the probability of bile leakage.

    由於有膽漏的可能性，引流肯定是需要的。
  2. A stream of would - be immigrants from africa keep taking to leaky boats in the hope of reaching the canary islands or malta

    打算移民的非洲人依然川流不息地湧上漏水的小船，希望抵達迦納利群島或是馬耳他。
  3. We found each cask leak more or less

    我們發現每桶都有或多或少的流漏現象。
  4. The liver function of 48 donors got recovery in a week, but the liver function of 4 donors recovered beyond a week. 2 donors had the fat liquefaction of incision. 1 donor had the hematocele under diaphragm. 1 donor had portal vein thrombus. 1 donor had chyle leakage. 1 donor needed pleural punctured for hydrops outflow

    2例供體術后切口脂肪液化， 1例供體術后出現服下積血， 1例供體術后發生門靜脈血栓， 1例供體術后發生小量乳糜漏， 1例行胸腔積液穿刺引流。
  5. According to the record of ancient documents, this paper gives the possible structure of li lan ' s steelyard clepsydra, and demonstrates the principle for the stabilization of average flow velocity

    根據古文獻記述，李蘭秤漏很可能是使用彈簧聯結權器和秤鉤，以達到平均流速穩定的目的。
  6. Study on method of calibrating vacuum leak with constant conductance method

    固定流導法校準真空漏孔方法研究
  7. Based on the ostwald - de waele equation, the leakage characteristics of power - law transmitted by helical gear pump are researched, and the leakage model of power - law in the clearence is founded, and - the velocity distributing and the leakage capacity are worked out by the boundary condition. the power loss of leakage is got through the clearence leakage capacity, and the friction power loss is attained by the velocity distributing. the mathematic calculation model

    利用冪律流體本構方程，首次對聚合物流體在斜齒齒輪泵中的漏流特性進行了研究，建立冪律流體在間隙中的泄漏模型，利用邊界條件求出速度分佈及泄漏量；由間隙泄漏量得到漏流損失功率，由速度分佈得到流體摩擦功率損失，並得到間隙最優解的數值計算數學模型，同時給出實例及數值計算結果。
  8. The vortex simulated in this article include the shedding vortex induced by the vane trailing edge boundary layer, the endwall vortex generated by the endwall boundary layer interaction, the passage vortex generated by the rotor rotation, and the leakage vortex generated by the tip clearance flow

    渦輪級內的渦運動包括：導向器葉片尾緣附而層引起的脫落渦；轉子通道內轉子的旋轉運動產生的通道渦；根腳區兩個端壁附面層干涉，形成的根腳渦；存在葉尖漏流時，出現的漏流渦。
  9. Based on an engineering background, through numerical simulation of the flow field in the hp turbine of the energy efficient engine ( e3 ), the article research the unsteady flow in a transonic turbine stage, the unsteady phenomena in the stage include the shockwave, wake, shedding vortex, endwall vortex, passage vortex and leakage vortex, etc. there are two shockwaves generated on the vane the tailing edge, one on suction side is named moving shockwave, and name another on pressure side steady shockwave

    本文首先對于研究的意義和國內外研究的現狀做了簡要的介紹，再從某工程背景出發，通過對e3發動機高壓渦輪內流場的數值模擬，研究了干涉的周期性的問題，以及渦輪級內常見的非定常現象：激波、尾跡、脫落渦、根腳渦、通道渦、漏流渦。導向器尾緣會出現兩道激波，在吸力面的激波可稱為「運動」激波，壓力面的激波可稱為「定常」激波。
  10. 4. based on the viscous hydrodynamics, the leakage characteristics of newton liquid that is transmitted by helical gear pump are researched for the aim of the least power loss, and the leakage model is founded, the mathematic models of the radial and the axial leakage are gained. at the same time the optimal radial leakage and axial leakage are got, and the numerical calculation is achieved

    基於粘性流體力學，以功率損失最小為目標，首次對牛頓流體在斜齒齒輪泵中的漏流特性進行了研究，建立了泄漏模型，分別得到了斜齒齒輪泵的徑向和軸向泄漏的數學計算模型；同時得到了斜齒齒輪泵最佳徑向間隙和最佳軸向間隙，並在此基礎上進行了數值計算。
  11. The effect of leakage flow due to the upstream hub axial gap on the rotor performance and the mechanism of interaction between the hub leakage flow and the rotor blade passage flow were studied based on the numerical simulations of the flow fields of a transonic compressor rotor with upstream hub leakage

    摘要為研究壓氣機轉子上游葉根軸向間隙泄漏流對轉子性能的影響程度以及泄漏流與轉子流場之間的相互作用機制，對帶有葉根泄漏流的跨聲壓氣機轉子流場進行了數值模擬。
  12. Test of power grounding : receive the command, then begin to open, read the 24th route data from the power screen moulding board after 8 second of open stabilization. the result can send automatically, the data enter into the respond cache ( differentiate rate is 1k second )

    電源對地漏流的測試：收到命令，進行開出，在開出穩定后（ 4秒） ，讀入電源屏模入板第24路數據，結果自主發送，數據進入應答緩存（解析度1毫安） 。
  13. According to the control rod hydraulic drive mechanism ( crhdm ) and the characteristics of its hydraulic cylinder seal structure, the leaking ways of the hydraulic cylinder piston ring seal were analysed, its theoretical calculation model was built and its flow resistance formula based on the calculation model of differential pressure at the hydraulic cylinder piston ring seal was deduced

    摘要根據控制棒水壓驅動機構水壓缸活塞環密封結構的特點，分析了水壓缸活塞環的泄漏途徑，建立了活塞環密封泄漏流阻的理論計算模型，並結合水壓缸活塞環密封處的壓差計算模型，推導出水壓缸密封結構的流阻計算公式。
  14. It is found that the hub leakage flow leads to an increased flow blockage near the hub, resulting in drop of rotor performance

    結果表明：葉根泄漏流可使葉根附近流動堵塞增大，造成轉子氣動性能的惡化。
  15. Additionally, the larger the circumferential velocity component of hub leakage flow, the greater the deleterious effect of hub leakage upon the rotor flow

    另外，葉根泄漏流的周向速度分量越大，泄漏流對轉子流場的不利影響也越大。
  16. Non - destructive testing ; magnetic leakage flux testing by scanning with probes ; principles

    無損檢驗.第1部分:用探測器掃描法檢驗磁性泄漏流量的
  17. The derivation of the leakage flow rate formula of the special annular clearance between the piston and cylinder under condition of variable viscosity in the axial piston pumps was carried out. at same time, considering the questions of the eccentricity and the variable sealing length of piston friction pair, the modified coefficient of the calculation formula of the flow - rate of the leakage was given

    在變粘度、柱塞偏心以及變密封長度條件下，對軸向柱塞泵中柱塞與缸孔之間的特殊圓環縫隙的泄漏流量公式進行推導，得到了該計算公式的修正系數； 6
  18. The complex vortex system structure and shock wave system structure inside this rotor is obtained. wall flow patterns on the blade surface and hub surface are found out. the complex vortex system structure, such as horseshoe vortex, passage vortex, corner vortex and trailing vortex, and the interaction with shock wave system are researched. especially, the character of the tip clearance flow inside the rotor passage is revealed, and the interaction between shock wave and tip clearance flow near blade tip and the evolution of tip clearance flow are considered

    給出了葉片表面及輪轂面上的壁面流型，分析並揭示了轉子葉道內的馬蹄渦、通道渦、角渦、尾渦等復雜渦系及其與激波的相互干涉；特別是，分析並揭示了轉子葉道內頂隙射流的特點，得到了頂隙附近激波與泄漏流動的干涉形態及泄漏流動的發展，並著重給出了其與激波的干涉形態。
  19. The numerical simulation and experimental research made on the characteristics of the clearance cavitations in kaplan turbine are described herein ; in which the analysis mainly is concentrated on the characteristics of leakage - vortex caused by the flow of the clearance between blade tip and blade chamber, that occurs at the front - pressure side of the blade, and the intensity of the secondary - flow - vortex ; furthermore, the relationship in between the leakage - vortex, secondary flow vortex, cavitations and erosion are analyzed as well

    摘要對軸流轉槳式水輪機輪緣間隙流動及空化特性進行數值模擬和試驗研究，重點分析輪緣間隙流動在正面頭部泄漏流動所引起的泄漏渦帶、二次流動的漩渦強度和空化特性，以及泄漏渦帶旋轉、二次流動的漩渦與空蝕和磨損之間的關系。
  20. Based on the comparison made among the characteristics of different kinds of the blade materials, the relationship between the material characters and the flow attack angle is explained, and then the breakage mechanism of the combined effects from both the clearance - cavitations and the erosion of leakage flow are expounded comprehensively

    通過對不同材料的特性比較，解釋了材料特性與沖角之間的關系，綜合闡述了泄漏流動所引起葉片正面頭部空蝕與磨損聯合作用產生破壞的機理。
分享友人
分享到 Line

分享到臉書