漏電試驗 的英文怎麼說

中文拼音 [lóudiànshìyàn]
漏電試驗 英文
leak test
  • 漏 : Ⅰ動詞1 （從孔或縫中滴下、透出或掉出） leak; drip 2 （泄漏） divulge; disclose; leak 3 （遺漏） le...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 漏電 : leakage of electricity; leakage漏電保護 earth leakage protection; 漏電保護開關 earth leakage circ...
  • 試驗 : trial; experiment; test
  1. It's a bulb pressure tester for detecting battery leaks.

    這是檢測電瓶漏氣用的膠球壓力試驗器。
  2. Investigating the relationship between the resistive component of the fundamental frequency current and that of the 3rd harmonic current by experimentation with real movs

    通過試驗研究了moa泄漏電流中基波阻性電流和三次諧波阻性電流之間的關系。
  3. Standard test method for measuring transistor and diode leakage currents

    晶體管及二極體泄漏電流測量的標準試驗方法
  4. Air leakage test procedure for electrical connectors

    電連接器.空氣泄漏試驗
  5. Electric connectors - air leakage test

    電氣連接器.空氣滲漏試驗
  6. Test method for combined fine and gross leaks for large hybrid microcircuit packages

    大型混合微電路插件的綜合微泄漏和總泄漏的試驗方法
  7. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、電氣強度、絕緣電阻、接地連續性、泄漏電流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性（壽命）試驗、電機負載試驗、電源線彎折、電源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  8. Development on reliability test device of residual current device

    漏電保護器可靠性試驗設備的研製
  9. Abstract : in this paper, characteristics of polluted insulator ' s operation state were analysised, studied the differences between each characteristics, the factors influencing lc significantly were found, including circumstance factors, and characteristics of leakage current ( lc ) were studied basing on artificial contamination test, obtained the relationship between leakage current and the influenced factors

    摘要:文章分析了表徵污穢絕緣子運行狀態的特徵量，比較了各特徵量的特點及其適用場所，總結了影響泄漏電流的特徵量，包括環境因素，並且在人工污穢試驗的基礎上，分析了泄漏電流在閃絡過程中的特徵，得出了泄漏電流與其基本特徵量之間的關系。
  10. With regard to its field drilling applications in the geologically loose sandy pebble layers, kl vegetable - gum drilling fluid showed itself with excellent rheological behaviours in its abilities of lubrication, lost circulation, suspension and removal of debris, anti - shear shinning, and high coring rates, which satisfactorily meet the demands of geological boring in the dam foundation of huangjin ping hydroelectrical power plant

    通過在黃金坪水電站壩基深厚砂卵石覆蓋層鉆探取芯的現場試驗，證明了kl植物膠沖洗液具有優良的流變特性，潤滑、堵漏、懸浮排除巖屑和抗剪切稀釋能力顯著，可實現高取芯率，能很好的滿足地質鉆探對取芯質量的要求。
  11. Test results indicated : with the hoist of altitude, the increase of ice amount and the rise of pollutant, the average flashover voltage reduced. the character exponent generally depends on the insulator profile, ice amount, ice state and pollution severity etc. by means of a high - speed camera, a data acquisition system and high voltage test facilities, a series of the flashover processes on ice surfaces were record. the experimental results form this study and the subsequent theoretical analyses suggested : the thermal ionization of the air in front of an arc root resulted in arc movement ; the electrostatic force had an auxiliary effect of impelling arc propagation ; the electrical

    通過對攝像機、數據採集系統及高壓試驗裝置記錄覆冰絕緣子表面閃絡電弧的發展過程的試驗結果進行理論分析得出：弧根周圍空氣的熱電離導致了電弧的發展，靜電場力對電弧的發展起到了加速作用，電擊穿僅發生在閃絡最終的跳躍階段；通過測量閃絡過程中的放電電壓、泄漏電流、閃絡時間、覆冰水電導率、電弧長度及電弧半徑等參數，得到了不同階段電弧（電弧起弧階段、電弧發展階段及完全閃絡）的發展速度、臨界電弧長度均隨覆冰水電導率的增加而減小。
  12. We have advanced equipments in the world, whole set apparatus made in german, special tools used in jatta and audi vehicles, advanced testers, wrong readers, launch tester, inner peeper, advanced repairing machines, automatic lift shaft, wheel balancer and italy automatic lacquer baker, computer print reached ministry standard

    義大利全自動烤漆房，全自動電腦調漆設備，義大利全自動輪胎平衡機，全自動輪胎安拆機義大利吊裝起重設備加拿大車身校正系統汽車電能試驗器廢氣分析儀電腦故障閱讀器空調系統冷媒測漏儀abs測試儀噴射測試儀機油壓力測試儀等。
  13. Test methods for determining hermeticity of electron devices with a helium mass spectrometer leak detector

    用氦質譜儀檢漏器測定電子元件密封性的試驗方法
  14. Electrical insulating materials. method to evaluate the resistance to tracking and erosion. rotating wheel dip test

    電氣絕緣材料.抗漏電和侵蝕性的評價方法.旋轉輪浸漬試驗
  15. This dissertation majorly researchs and designs full digital dc driving system with fuzzy control. it makes a scheme argumentation firstly, analyzing the pid algorithm and fuzzy control algorithm the ordinary digital pulse trigger algorithm and the double remainder method of pulse trigger in detail, and fuzzy control and the double remainder method are put forward to settle the under - mentioned problems, namely, the new viewpoint and the task having finished in this dissertation as follows : ( 1 ) in rder to overcome the influence of dc motor ' s parameter changing with time and nonlinear on the control system performance, this dissertation adopts fuzzy control as outside regulator and pi control as inside regulator in double regulators of the full digital dc motor driving system design ;. ( 2 ) aiming at the pulse trigger reliability of the ordinary d igital pulse trigger being low and leaking the pulse or the order of pulse confusion, this paper adopts the double remainder algorithm with short response time high pulse trigger reliability good adaptability and anti - jamming ; ( 3 ) this dissertation adopts tms320lf2407 which has good performance as major control chip this chip has power function with fast calculation capability, and accomplishes the software and hardware design in the dc motor driving system with fuzzy control ; ( 4 ) this dissertation also puts emphases on anti - jamming in hardware and software ; ( 5 ) after having designed the sample of full digital dc motor driving system with fuzzy control, a lot of experiments are performed to verify the performance and settles problems during experiment. the result of experiment proves the feasibility of design

    首先進行了方案論證，對模糊控制演算法和數字pid調節演算法、觸發脈沖的一般演算法和雙余演算法進行了詳細地研究分析，提出應用模糊控制和雙余法解決下述問題，即該論文主要的新見解和所完成的工作： （ 1 ）為了克服直流電機參數時變性和非線性因素對控制性能的影響，本設計中，雙閉環調速系統的外環採用模糊控制，內環採用pi控制，使系統在一定范圍內對直流電機參數變化和非線性因素影響有自適應能力； （ 2 ）針對常規數字觸發器演算法中觸發脈沖的可靠性不高，經常出現漏脈沖或是脈沖混亂的情況，本文採用雙余法，該演算法具有響應快，可靠性高，具有良好的適應性及抗干擾能力； （ 3 ）本設計中採用了速度快、功能強的tms320lf2407作為系統的主控晶元，應用該晶元完成系統的軟硬體設計： （ 4 ）本文對系統抗干擾的軟硬體措施進行了重點研究； （ 5 ）設計了具有模糊控制的全數字直流傳動系統原理樣機，並進行了試驗驗證，對試驗過程中出現的問題及時解決，最終實驗結果證明設計是可行的。
  16. Based on many references form civil and abroad, the author mainly studies the measurment theory and method for flux, raising height, axial power and rotational velocity. avoiding many complicated and intermediate courses for power wastage analysis, introduces the electric measurement and using efficiency curve of motor in measureing axial power, and satisfies the automatization of the device. the paper also provides a new method, inductive winding, in measuring rotational velocity of electromotor, supplys limitations of other method in measuring rotational velocity of electromotor in water, and meet practical needs in developing diving electric pump for corporation

    作者在參閱大量國內外有關文獻，著重探討了水泵流量、揚程、軸功率、轉速的測試原理和測試方法，提出了採用電測法並結合電機效率特性曲線測量水泵軸功率，從而避免了損耗分析法中大量復雜的中間過程，滿足了試驗裝置的自動化測量要求；採用漏磁感應線圈法測量電機轉速，彌補了其它轉速測量方法對水下電機測試的局限性，適應了萊恩公司開發潛水電泵的實際需要。
  17. Test method for evaluating resistance to tracking and erosion of electrical insulating materials used under severe ambient conditions

    在嚴酷的大氣環境下使用的電絕緣材料耐漏電起痕蝕損的評價的試驗方法
  18. Overhead electrical conductors - creep test procedures for stranded conductors iec 61395 : 1998 ; german version en 61395 : 1998

    架空電力導線.絞合導線的漏電試驗
  19. Remote leakage test comparing with on - the - spot leakage test underground in coalmines

    煤礦井下遠方與就地漏電試驗的比較
  20. Dielectric air leakage test method for trunk, feeder and distribution coaxial cable

    干線饋電和配電同軸電纜用絕緣材料漏汽試驗方法
分享友人
分享到 Line

分享到臉書