漸屈的 的英文怎麼說

中文拼音 [jiānde]
漸屈的 英文
evolute
  • : 漸副詞(逐步; 漸漸) gradually; by degrees
  • : 4次方是 The fourth power of 2 is direction
  1. With the retreat of this boundary the cohesive bonds gradually yield.

    隨著這種邊界後退,凝聚性結合逐服。
  2. He then treated the evolute of a plane curve.

    然後他討論了平面曲線線。
  3. Gradually his feeling of ignominy and of rage sank.

    怒火和委煙消雲散。
  4. The rest of the world is gradually moving beyond “ idolatry to monarchs ” and “ servility to aristocratic pride ”

    世界其它地區正逐超越「對君主崇拜」和「對貴族」 。
  5. The calculation results indicate that the outboard of drum walls fall in plastic yielding at the same time the rising cooling water reaches the height of that point and the yield region becomes narrower and narrower when it comes closer to the circumferential strake weldments, which explains the reason coke drums experience bulging and cracks occur in the weld seams portions of shell to shell after long in service

    計算結果表明:塔壁外側在冷卻水面到達瞬間進入塑性服,筒節中部塑性服區較大,當靠近焊縫時塔壁塑性變形區逐縮小直至消失,塔壁塑性服區分佈特點解釋了塔體長期使用后發生鼓凸變形及簡體與焊縫連接處產生裂紋原因。
  6. After pretorsion the successor tensile yield limit and strength limit both improved very highly, but the trend of the increase of the strength limit was suspended till the pretorsional capacity reached 17, when the pretorsional capacity was greater than17 ( prestrain value was 81. 19 % of total strain ), the successor strength limit rapid failed and approached the yield limit. this illustrate the a3 steel specimen translate from plasticity into friability after pretorsion strengthen. when the specimen was operated by tension - torsion action, the yield limit had very large improved, but the strength limit changed very little. furthermore, the trend of the increase of the strength limit was suspended till the pretension capacity reached 0. 25 ( prestrain value was 66. 93 % of total strain )

    A3鋼試件在預扭轉后,后繼拉伸服極限和強度極限均有很大提高,但強度極限增大趨勢到預扭轉量為17為止,預扭轉量大於17 (預應變值為總應變81 . 19 )后強度極限迅速下降,與其服極限接近,這說明a3鋼試件經預扭轉強化后逐由塑性轉化為脆性。該預應變值為a3鋼試件韌脆轉變點。 a3鋼試件在拉伸-扭轉作用下,服極限有很大提高,但強度極限沒有多大改變,而且,服極限增大趨勢到預拉伸量為0 . 25應變(預應變量為總應變量66 . 93 )后就不再增加。
  7. The parameters are measured respectively during the experimental process, such as bearing capacity, deformation, strain and so on. it concludes that when the other conditions is equal, the limit bearing capacity of the concrete filled steel tube long column subjected to axial compress is reduced along with the long diameter ratio increased

    從試驗結果可以看出:鋼管混凝土軸心受壓長柱穩定承載力,在其他條件相同時隨長細比增大而逐降低;試件在最大承載力狀態下,鋼管表面平均縱向應變已超過鋼管服應變值,破壞呈現為非彈性失穩破壞。
  8. It is shown that : at the position of maximum bearing clearance, the non - yield region is attached to bushing, while at the position of

    隨著服應力提高,未服區逐擴大,當達到一定值時,流場對服應力達到飽和狀態。
  9. Real recovered from a poor start to last season to put together a fine run in the league under his and luxemburgo ' s guidance and eventually finished just four points behind eventual champions barcelona. but the team made a disappointing exit in the first knockout stage of the champions league and failed to progress beyond the last 16 of the king ' s cup

    雖然皇馬上賽季開局很糟糕,但在薩基以及薩基大力推薦而來主教練盧森伯格帶領下, 「銀河艦隊」逐在聯賽中步入正軌,並最終僅以4分之差排在巴塞羅那隊之後居聯賽亞軍。
  10. Non - linear fem analysis for dynamic progressive buckling of thin - walled circular tubes under axial impact load

    受沖薄壁圓管動態非線性有限元分析
  11. The concept of the longitudinal strength of ship hulls has changed and advanced greatly as the study on the failure mechanism of the hull is getting deep. by taking account the failure modes of yielding, buckling and their combination, as well as the non - linear interactions between structural members, the ultimate longitudinal bending moment is defined by the moment corresponding to the point with zero slope on the moment - curvature curve of the ship hull

    但隨著對船舶破壞機理認識和研究發現,在研究船體總縱極限強度時,必須考慮構件曲、服等各種可能破壞模式,要考慮受壓構件曲后及崩潰后非線性性能影響,要考慮組成船體各個構件發生破壞進性質和相互作用等。
分享友人